The Influence of DC discharge afterglow treatment on poly(ethylene terephthalate) surface properties
Open Access
- 1 October 2019
- conference paper
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 1328 (1) , 012010
Abstract
In this work, we investigated the effects of gas flow rate, processing time and distance from plasma region on the modification of poly(ethylene terephthalate) (PET) films under conditions of afterglows of atmospheric pressure discharges in air and argon. Both original and plasma-modified surfaces were studied by FTIR, AFM, XPS and contact angle measurements. It was found that the remote treatment 1) results in increasing PET surface hydrophilicity, but in decreasing contact angles (by ∼ 3 times compared with the original sample); 2) leads to the destruction of ester groups as well as to the formation of new C-O groups; and 3) causes an increase in average surface roughness (from 1.4 nm for untreated PET to 2.2 and 4.4 nm for PET modified by air and argon afterglows, respectively). The set of experimental techniques together with plasma modeling provided the information on plasma emission properties, gas temperature, reduced electric field strength, discharge geometry and densities of plasma active species. Based on these data, the modification mechanism involving UV photons and O atoms was proposed.Keywords
This publication has 9 references indexed in Scilit:
- Modification of polypropylene in the afterglow of the atmospheric pressure discharges in air and argonJournal of Physics: Conference Series, 2017
- Influence the loading effect on modification of PET film and fiber by Argon PlasmaJournal of Physics: Conference Series, 2017
- Modeling Chemical Composition for an Atmospheric Pressure DC Discharge in Air with Water Cathode by 0-D modelPlasma Chemistry and Plasma Processing, 2014
- Surface modification of polypropylene with an atmospheric pressure plasma jet sustained in argon and an argon/water vapour mixtureApplied Surface Science, 2011
- Spectroscopy of Low Temperature Plasma2009
- Characteristics of atmospheric pressure N2 cold plasma torch using 60-Hz AC power and its application to polymer surface modificationSurface and Coatings Technology, 2005
- Biaxially Oriented Polypropylene (BOPP) Surface Modification by Nitrogen Atmospheric Pressure Glow Discharge (APGD) and by Air CoronaPlasmas and Polymers, 2002
- Kinetic Features of Initiation of Poly(ethylene terephthalate) Oxidative Degradation Processes in Oxygen PlasmaHigh Energy Chemistry, 2001
- A comparison of polypropylene-surface treatment by filamentary, homogeneous and glow discharges in helium at atmospheric pressureJournal of Physics D: Applied Physics, 1998