Fast transition-edge sensors suitable for photonic quantum computing
Authors:
- Ruslan HummatovRHRuslan Hummatov
- Adriana E. LitaALAdriana E. Lita
- Tannaz FarrahiTFTannaz Farrahi
- Negar OtrooshiNONegar Otrooshi
- Matthew J. CollinsMCMatthew J. Collins
- Malcolm DurkinMDMalcolm Durkin
- Douglas BennettDBDouglas Bennett
- Joel UllomJUJoel Ullom
- Richard P. MirinRMRichard P. Mirin
- Sae Woo NamSNSae Woo Nam
Open Access
- 16 June 2023
- journal article
- research article
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 133 (23)
Abstract
Photon-number resolving transition-edge sensors (TESs) with near unity system detection efficiency enable novel approaches to quantum computing, for example, heralding robust Gottesman–Kitaev–Preskill qubit states. Increasing the speed of the detectors increases the rate at which these states can be heralded. In addition, depending on the details of the scheme, faster detectors can reduce the complexities of the hardware implementation. In previous work, we demonstrated that adding a small amount of gold between the tungsten film and silicon substrate can increase thermal conductance and reduce detector recovery time. In that study, the readout electronics imposed limitations on stable biasing conditions of the TES detector, and the TES could only be biased at higher than ideal values. In this report, we demonstrate the operation of the TES illuminated by a heavily attenuated pulsed laser running at 1 MHz repetition rate and examine the limits to adding gold to speed up device recovery times using a higher bandwidth readout system. The best performance was achieved by combining a 15×15μm2 tungsten TES with 5μm3 of gold, which resulted in a recovery time faster than 250 ns, with an energy resolution of 0.25 eV full-width at half maximum at 0.8 eV photon energy.Keywords
Funding Information
- National Institute of Standards and Technology
- Xanadu Quantum Technologies
This publication has 21 references indexed in Scilit:
- Fabrication and Characterization of Fast TESs With Small Area for Single Photon CountingIEEE Transactions on Applied Superconductivity, 2014
- Faster recovery time of a hot-electron transition-edge sensor by use of normal metal heat-sinksApplied Physics Letters, 2011
- Introduction to TES PhysicsJournal of Low Temperature Physics, 2008
- Energy Collection Efficiency of Tungsten Transition-Edge Sensors in the Near-InfraredJournal of Low Temperature Physics, 2008
- Resolution limitation in superconducting transition edge photon detectors due to downconversion phonon noiseApplied Physics Letters, 2006
- Impedance measurements and modeling of a transition-edge-sensor calorimeterReview of Scientific Instruments, 2004
- Superconducting multiplexer for arrays of transition edge sensorsApplied Physics Letters, 1999
- Detection of single infrared, optical, and ultraviolet photons using superconducting transition edge sensorsApplied Physics Letters, 1998
- Thermal-response time of superconducting transition-edge microcalorimetersJournal of Applied Physics, 1998
- An application of electrothermal feedback for high resolution cryogenic particle detectionApplied Physics Letters, 1995