The Effect of Masonry Infill Model Selection on the Seismic Response of Reinforced Concrete Frame Structures
Open Access
- 31 December 2025
- journal article
- Published by University of Banja Luka, Faculty of Architecture, Civil Engineering and Geodesy in AГГ+
- Vol. 13 (2) , 50-70
Abstract
In many countries, reinforced concrete (RC) frames are widely utilized as the primary building structure. The infill is typically composed of traditional masonry (brick elements connected with mortar), commonly without isolation from the frame. It is noted that in engineering practice, seismic force calculations for RC frame buildings are often conducted on models that exclude masonry infill, even when the infill is not isolated from the frame through specific construction elements. In such cases, the walls are considered only as a permanent load. Consequently, the contribution of non-insulated (bonded) masonry infill to changes in bearing capacity, stiffness, and ductility of the RC frame, affecting stresses and horizontal movement during seismic activity, is frequently disregarded. To assess the consequences of prevalent calculation models, four representative types of RC frame models with masonry infill were analysed herein. The study demonstrated that differently conceptualized models of the same building impact dynamic characteristics, including forces and displacements of the main frame structure. The dynamic analysis revealed that inadequate treatment of the frame and non-insulated infill connection in the design phase can lead to dangerous phenomena such as "soft floors," significant torsion, and the effects of short columns going unnoticed. Therefore, this paper underscores the importance of appropriately addressing non-insulated infill in the calculation model in routine design practices. Additionally, it advocates for the issuance of precise instructions for special construction measures that would effectively isolate masonry infill from the frame when such a solution is justified.Keywords
This publication has 47 references indexed in Scilit:
- Nonlinear dynamic tests of a reinforced concrete frame building at different damage levelsEarthquake Engineering & Structural Dynamics, 2020
- Experimental results of reinforced concrete frames with masonry infills under combined quasi-static in-plane and out-of-plane seismic loadingBulletin of Earthquake Engineering, 2019
- Assessment of the combined in‐plane and out‐of‐plane behavior of brick infill walls within reinforced concrete frames under seismic loadingEarthquake Engineering & Structural Dynamics, 2018
- Seismic response of RC buildings during the Mw 6.0 August 24, 2016 Central Italy earthquake: the Amatrice case studyBulletin of Earthquake Engineering, 2017
- Prediction of inter-storey drifts for regular RC structures with masonry infills based on bare frame modellingBulletin of Earthquake Engineering, 2017
- Seismic performance of the infill masonry walls and ambient vibration tests after the Ghorka 2015, Nepal earthquakeBulletin of Earthquake Engineering, 2016
- Effectiveness of plasters and textile reinforced mortars for strengthening clay masonry infill walls subjected to combined in‐plane/out‐of‐plane actions / Wirksamkeit von Putz und textilbewehrtem Mörtel bei der Verstärkung von Ausfachungswänden aus Ziegelmauerwerk, die kombinierter Scheiben‐ und Plattenbeanspruchung ausgesetzt sindMauerwerk, 2015
- Experimental testing of engineered masonry infill walls for post-earthquake structural damage controlBulletin of Earthquake Engineering, 2014
- Performance of buildings with masonry infill walls during the 2011 Lorca earthquakeBulletin of Earthquake Engineering, 2013
- Performance of non-structural elements in RC buildings during the L’Aquila, 2009 earthquakeBulletin of Earthquake Engineering, 2010