Reentrant cavities as electromechanical transducers
- 1 April 2004
- journal article
- conference paper
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 75 (4) , 1000-1005
Abstract
The present work quantifies the dependence of the tunable frequency range on the gap spacing between the end of the conical post and the cavity top plate in reentrant 1.0 GHz klystron cavities. Fabricated from aluminum, the cavities tested are 80 mm in diameter with a top plate 1 mm thick. Experiments performed on such cavities have shown tuning coefficients (change in resonant frequency due to variation of the capacitive gap) as high as 40.0 MHz/μm, thereby demonstrating the capability of reentrant cavities as electromechanical transducers in resonant mass gravitational wave antennas. For cavity-based transducers ten times as small as the cavities tested here, this result translates into a tuning coefficient 100 times higher.Keywords
This publication has 8 references indexed in Scilit:
- The Brazilian spherical detector: progress and plansClassical and Quantum Gravity, 2004
- Accurate calibration technique for a resonant-mass gravitational wave detectorReview of Scientific Instruments, 2000
- Applications of low-temperature microwave techniques to the measurement of gravity waves and quantum measurement of macroscopic systemsPhysica B: Condensed Matter, 2000
- Advances in modeling and simulation of vacuum electronic devicesProceedings of the IEEE, 1999
- High Sensitivity Gravitational Wave Antenna with Parametric Transducer ReadoutPhysical Review Letters, 1995
- Superconducting re-entrant cavity transducer for a resonant bar gravitational radiation antennaReview of Scientific Instruments, 1992
- Development of a 1.5-tonne niobium gravitational radiational antennaReview of Scientific Instruments, 1987
- General Treatment of Klystron Resonant CavitiesIEEE Transactions on Microwave Theory and Techniques, 1958