Unbiased roughness measurements: subtracting out SEM effects, part 3
Authors:
- 26 March 2019
- conference paper
- Published by SPIE-Intl Soc Optical Eng
- Vol. 10959, 109590P
Abstract
Background: The measurement of line-edge and linewidth roughness of small features for semiconductor manufacturing is commonly accomplished using a scanning electron microscope (SEM). But these measurements are biased by the noise inherent in SEM imaging. Aim: Unbiasing of roughness measurements is best accomplished by taking advantage of the frequency characteristics of the noise to measure and subtract it out. This requires the ability to detect edges in a noisy SEM image without the use of standard image filtering techniques . Approach: A physics-based inverse linescan model is used to robustly detect edges in high-noise SEM images without the use of filtering or image averaging. To validate the efficacy of SEM noise measurement and subtraction, rough features were measured under a wide variety of SEM settings, including number of frames of averaging and voltage. Results: In all cases, the vast majority of the measurement bias was properly subtracted out. Over a wide range of SEM settings the biased roughness varied by more than a factor of two, but the unbiased linewidth roughness varied by only a few percent. Conclusions: The approach of inverse-linescan edge detection followed by noise measurement and subtraction leads to reliable estimates of the true (unbiased) line-edge and linewidth roughness of features on the wafer. These unbiased estimates are quite insensitive to metrology tool settings over a reasonable range of values.Keywords
This publication has 11 references indexed in Scilit:
- Unbiased roughness measurements: Subtracting out SEM effects, part 2Journal of Vacuum Science & Technology B, 2018
- Stochastic printing failures in extreme ultraviolet lithographyJournal of Micro/Nanolithography, MEMS, and MOEMS, 2018
- Edge placement error fundamentals and impact of EUV: will traditional design-rule calculations work in the era of EUV?Journal of Micro/Nanolithography, MEMS, and MOEMS, 2018
- Assessment of pattern variability and defectivity by large-scale SEM metrology with >100 million measurementsJournal of Micro/Nanolithography, MEMS, and MOEMS, 2018
- Reducing roughness in extreme ultraviolet lithographyJournal of Micro/Nanolithography, MEMS, and MOEMS, 2018
- Unbiased roughness measurements: Subtracting out SEM effectsMicroelectronic Engineering, 2018
- Lithographic stochastics: beyond 3σJournal of Micro/Nanolithography, MEMS, and MOEMS, 2017
- Systematic errors in the measurement of power spectral densityJournal of Micro/Nanolithography, MEMS, and MOEMS, 2013
- Electron-beam induced photoresist shrinkage influence on 2D profiles2010
- Determination of optimal parameters for CD-SEM measurement of line-edge roughness2004