Stiction Reduction in MEMS Fabrication via Naphthalene Sublimation
Authors:
- 30 October 2022
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 01-04
Abstract
This work describes a simple low-cost method to prevent stiction in low-stiffness suspended microstructures via naphthalene sublimation. Different microstructure types with different lengths and therefore different stiffness were fabricated and released using this technique. The results show great improvement when compared to water release. The method uses naphthalene crystal sediments acting as temporary support underneath and between suspended microstructures during solvent evaporation. Results show a significant reduction of stiction compared to similar structures released and dried without this procedure.Keywords
Funding Information
- National Science Foundation (1923195)
This publication has 14 references indexed in Scilit:
- MEMS stiction supression with sacrificial polystyrene nanoparticles2017
- Controlling Stiction in Nano-Electro-Mechanical Systems Using Liquid CrystalsACS Nano, 2016
- Anti-stiction coating of PDMS moulds for rapid microchannel fabrication by double replica mouldingJournal of Micromechanics and Microengineering, 2011
- Modeling of dry stiction in micro electro-mechanical systems (MEMS)Journal of Micromechanics and Microengineering, 2006
- A new processing technique to prevent stiction using silicon selective etching for SOI-MEMSSensors and Actuators A: Physical, 2002
- Tribological Challenges in Micromechanical SystemsTribology Letters, 2002
- The NIST Chemistry WebBook: A Chemical Data Resource on the InternetJournal of Chemical & Engineering Data, 2001
- Critical point drying and cleaning for MEMS technology1999
- Elimination of post-release adhesion in microstructures using conformal fluorocarbon coatingsJournal of Microelectromechanical Systems, 1997
- A Drying Method Using Naphthalene for Flexible Microgripper FabricationJapanese Journal of Applied Physics, 1996