Jerry W. Shan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Jerry W. Shan has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
Anna S. Cherkasova
Department of Mechanical and Aerospace Engineering, Rutgers University, Piscataway, NJ 08854-8054
2 shared publicationsDaniel B. Lang
Graduate Aeronautical Laboratories, California Institute of Technology, Pasadena, USA
2 shared publicationsPaul E. Dimotakis
Graduate Aeronautical Laboratories, California Institute of Technology, Pasadena, USA
2 shared publications- An-Ping Li
Oak Ridge National Laboratory
1 shared publication Cevat Akin
Department of Mechanical and Aerospace Engineering, Rutgers University, Piscataway, NJ 08854, USA.
1 shared publicationCorentin Durand
Center for Nanophase Materials Sciences, Oak Ridge National Laboratory, Oak Ridge, TN 37831, USA
1 shared publication
Latest Publications
- 28 January 2017
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 121 (4)
Tunable acoustic attenuation in dilute suspensions of subwavelength, non-spherical magnetic particles
The microstructure (e.g., particle orientation and chaining) of suspensions of non-spherical ferromagnetic particles can be controlled by an external field, potentially making it possible to tune the acoustic properties of the suspension. Here, we experimentally demonstrate that dilute suspensions of subwavelength-sized oblate-spheroidal nickel particles exhibit up to a 35% change in attenuation coefficient at MHz frequencies upon changing the direction of an external magnetic field, for particle volume fractions of only 0.5%. Comparison is made to suspensions of spherical particles, in which the attenuation is smaller and nearly isotropic. Optical transmission measurements and analysis of the characteristic timescales of particle alignment and chaining are also performed to investigate the reasons for this acoustic anisotropy. The alignment of the oblate-spheroidal particles is found to be the dominant mechanism for the anisotropic and tunable acoustic attenuation of these suspensions.
- 28 January 2017
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 121 (4)
Tunable acoustic attenuation in dilute suspensions of subwavelength, non-spherical magnetic particles
The microstructure (e.g., particle orientation and chaining) of suspensions of non-spherical ferromagnetic particles can be controlled by an external field, potentially making it possible to tune the acoustic properties of the suspension. Here, we experimentally demonstrate that dilute suspensions of subwavelength-sized oblate-spheroidal nickel particles exhibit up to a 35% change in attenuation coefficient at MHz frequencies upon changing the direction of an external magnetic field, for particle volume fractions of only 0.5%. Comparison is made to suspensions of spherical particles, in which the attenuation is smaller and nearly isotropic. Optical transmission measurements and analysis of the characteristic timescales of particle alignment and chaining are also performed to investigate the reasons for this acoustic anisotropy. The alignment of the oblate-spheroidal particles is found to be the dominant mechanism for the anisotropic and tunable acoustic attenuation of these suspensions.
- 12 May 2016
- Published by Royal Society of Chemistry (RSC) in Lab on a Chip
- Vol. 16 (11) , 2126-2134
High-throughput electrical measurement and microfluidic sorting of semiconductor nanowires
Existing nanowire electrical characterization tools not only are expensive and require sophisticated facilities, but are far too slow to enable statistical characterization of highly variable samples. They are also generally not compatible with further sorting and processing of nanowires. Here, we demonstrate a high-throughput, solution-based electro-orientation-spectroscopy (EOS) method, which is capable of automated electrical characterization of individual nanowires by direct optical visualization of their alignment behavior under spatially uniform electric fields of different frequencies. We demonstrate that EOS can quantitatively characterize the electrical conductivities of nanowires over a 6-order-of-magnitude range (10−5 to 10 S m−1, corresponding to typical carrier densities of 1010–1016 cm−3), with different fluids used to suspend the nanowires. By implementing EOS in a simple microfluidic device, continuous electrical characterization is achieved, and the sorting of nanowires is demonstrated as a proof-of-concept. With measurement speeds two orders of magnitude faster than direct-contact methods, the automated EOS instrument enables for the first time the statistical characterization of highly variable 1D nanomaterials.
- 12 May 2016
- Published by Royal Society of Chemistry (RSC) in Lab on a Chip
- Vol. 16 (11) , 2126-2134
High-throughput electrical measurement and microfluidic sorting of semiconductor nanowires
Existing nanowire electrical characterization tools not only are expensive and require sophisticated facilities, but are far too slow to enable statistical characterization of highly variable samples. They are also generally not compatible with further sorting and processing of nanowires. Here, we demonstrate a high-throughput, solution-based electro-orientation-spectroscopy (EOS) method, which is capable of automated electrical characterization of individual nanowires by direct optical visualization of their alignment behavior under spatially uniform electric fields of different frequencies. We demonstrate that EOS can quantitatively characterize the electrical conductivities of nanowires over a 6-order-of-magnitude range (10−5 to 10 S m−1, corresponding to typical carrier densities of 1010–1016 cm−3), with different fluids used to suspend the nanowires. By implementing EOS in a simple microfluidic device, continuous electrical characterization is achieved, and the sorting of nanowires is demonstrated as a proof-of-concept. With measurement speeds two orders of magnitude faster than direct-contact methods, the automated EOS instrument enables for the first time the statistical characterization of highly variable 1D nanomaterials.
- 1 August 2015
- Published by Elsevier in Biochimica et Biophysica Acta (BBA) - Biomembranes
- Vol. 1848 (8) , 1706-1714
Transport, resealing, and re-poration dynamics of two-pulse electroporation-mediated molecular delivery
- 1 August 2015
- Published by Elsevier in Biochimica et Biophysica Acta (BBA) - Biomembranes
- Vol. 1848 (8) , 1706-1714
Transport, resealing, and re-poration dynamics of two-pulse electroporation-mediated molecular delivery
- 9 June 2010
- Published by Wiley in Journal of Heat Transfer
- Vol. 132 (8) , 082402
Particle Aspect-Ratio and Agglomeration-State Effects on the Effective Thermal Conductivity of Aqueous Suspensions of Multiwalled Carbon Nanotubes
The effective thermal conductivities of aqueous nanofluids containing surfactant-stabilized multiwalled carbon nanotubes were measured and compared with the predictions of effective medium theory (Nan, C.-W., et al., 1997, “Effective Thermal Conductivity of Particulate Composites With Interfacial Thermal Resistance,” J. Appl. Phys., 81(10), pp. 6692–6699). Detailed characterization of nanotube morphology was carried out through electron microscopy, while the nanotube agglomeration state was monitored through optical microscopy and absorption measurements. An optimum surfactant-to-nanotube mass ratio was found for the particular surfactant, sodium dodecylbenzene sulfonate, which resulted in the greatest increase in thermal conductivity. Taking into consideration the volume-weighted aspect ratio of the nanotubes, the measured thermal conductivities of the suspensions were shown to be in good agreement with calculations for a reasonable choice of interfacial resistance on the particle/liquid interface. The effect of particle aspect ratio on the suspension’s thermal conductivity was further demonstrated and compared with theory by reducing the nanotube length through intense ultrasonication. The effect of particle aggregation on the thermal conductivity was also investigated by destabilizing previously stable suspensions with ethanol addition, which causes surfactant desorption and bundling of nanotubes. The measured thermal conductivities were correlated with absorption measurements and microscopic visualizations to show that particle aggregation decreases the thermal conductivity of the nanofluid by reducing the effective particle aspect ratio.
- 9 June 2010
- Published by Wiley in Journal of Heat Transfer
- Vol. 132 (8) , 082402
Particle Aspect-Ratio and Agglomeration-State Effects on the Effective Thermal Conductivity of Aqueous Suspensions of Multiwalled Carbon Nanotubes
The effective thermal conductivities of aqueous nanofluids containing surfactant-stabilized multiwalled carbon nanotubes were measured and compared with the predictions of effective medium theory (Nan, C.-W., et al., 1997, “Effective Thermal Conductivity of Particulate Composites With Interfacial Thermal Resistance,” J. Appl. Phys., 81(10), pp. 6692–6699). Detailed characterization of nanotube morphology was carried out through electron microscopy, while the nanotube agglomeration state was monitored through optical microscopy and absorption measurements. An optimum surfactant-to-nanotube mass ratio was found for the particular surfactant, sodium dodecylbenzene sulfonate, which resulted in the greatest increase in thermal conductivity. Taking into consideration the volume-weighted aspect ratio of the nanotubes, the measured thermal conductivities of the suspensions were shown to be in good agreement with calculations for a reasonable choice of interfacial resistance on the particle/liquid interface. The effect of particle aspect ratio on the suspension’s thermal conductivity was further demonstrated and compared with theory by reducing the nanotube length through intense ultrasonication. The effect of particle aggregation on the thermal conductivity was also investigated by destabilizing previously stable suspensions with ethanol addition, which causes surfactant desorption and bundling of nanotubes. The measured thermal conductivities were correlated with absorption measurements and microscopic visualizations to show that particle aggregation decreases the thermal conductivity of the nanofluid by reducing the effective particle aspect ratio.
- 4 June 2008
- Published by Wiley in Journal of Heat Transfer
- Vol. 130 (8) , 082406
Particle Aspect-Ratio Effects on the Thermal Conductivity of Micro- and Nanoparticle Suspensions
The influence of particle anisotropy on the effective thermal conductivity of a suspension is experimentally investigated. Suspensions of micron-sized, silicon-carbide particles with varying aspect-ratio distributions were prepared and measured. It is shown that the conductivity of the silicon-carbide suspensions can be quantitatively predicted by the effective medium theory of Nan et al. (1997, “Effective Thermal Conductivity of Particulate Composites With Interfacial Thermal Resistance,” J. Appl. Phys. 81(10), pp. 6692–6699), provided the volume-weighted aspect ratio of the particles is used. Recent experimental data on multiwalled-nanotube-in-oil suspensions by Yang et al. (2006, “Thermal and Rheological Properties of Carbon Nanotube-in-Oil Dispersions,” J. Appl. Phys., 99(11), 114307) are also analyzed and shown to be in at least qualitative agreement with the effective-medium-theory prediction that the thermal conductivity of suspensions is enhanced by large aspect-ratio particles.
- 4 June 2008
- Published by Wiley in Journal of Heat Transfer
- Vol. 130 (8) , 082406
Particle Aspect-Ratio Effects on the Thermal Conductivity of Micro- and Nanoparticle Suspensions
The influence of particle anisotropy on the effective thermal conductivity of a suspension is experimentally investigated. Suspensions of micron-sized, silicon-carbide particles with varying aspect-ratio distributions were prepared and measured. It is shown that the conductivity of the silicon-carbide suspensions can be quantitatively predicted by the effective medium theory of Nan et al. (1997, “Effective Thermal Conductivity of Particulate Composites With Interfacial Thermal Resistance,” J. Appl. Phys. 81(10), pp. 6692–6699), provided the volume-weighted aspect ratio of the particles is used. Recent experimental data on multiwalled-nanotube-in-oil suspensions by Yang et al. (2006, “Thermal and Rheological Properties of Carbon Nanotube-in-Oil Dispersions,” J. Appl. Phys., 99(11), 114307) are also analyzed and shown to be in at least qualitative agreement with the effective-medium-theory prediction that the thermal conductivity of suspensions is enhanced by large aspect-ratio particles.
- 24 June 2004
- Published by Springer Nature in Experiments in Fluids
- Vol. 37 (2) , 310
Scalar concentration measurements in liquid-phase flows with pulsed lasers
- 24 June 2004
- Published by Springer Nature in Experiments in Fluids
- Vol. 37 (2) , 310
Scalar concentration measurements in liquid-phase flows with pulsed lasers
- 1 February 2004
- Published by Springer Nature in Experiments in Fluids
- Vol. 36 (2) , 268-273
Scalar concentration measurements in liquid-phase flows with pulsed lasers
- 1 February 2004
- Published by Springer Nature in Experiments in Fluids
- Vol. 36 (2) , 268-273
Scalar concentration measurements in liquid-phase flows with pulsed lasers