A. S. Ovcharova
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
A. S. Ovcharova has a total of 2 co-authors. Here are the top co-authors by number of shared publications:
- Olga N. Goncharova
Altai State University, Barnaul, Russia
1 shared publication - Victoria B. Bekezhanova
Department of Differential Equations of Mechanics, Institute of Computational Modeling SB RAS, Krasnoyarsk, Russia
1 shared publication
Latest Publications
- 1 August 2023
- Published by Pleiades Publishing Ltd in Journal of Applied Mechanics and Technical Physics
- Vol. 64 (4) , 564-574
SIMULATION OF CONVECTION IN A TWO-PHASE SYSTEM UNDER CONDITIONS OF DIFFUSIVE EVAPORATION IN A CLOSED REGION
This paper describes the study of a problem of thermocapillary convection in a flat bounded region filled with liquid and gas in contact along the interfacial interface under weak evaporation. It is proposed to investigate the heat and mass transfer processes and the parameters of phase transitions during local heating using a two-sided mathematical model based on the Oberbeck–Boussinesq equations. The characteristics of mass transfer through a thermocapillary interface due to evaporation and vapor content in the gas layer are analyzed with account for the influence of the Soret and Dufour effects. The results of a numerical study of the evolution of the interface and unsteady flows in a cell are presented. The calculation of the main characteristics of the liquid — gas system and the position of the interface at each time is carried out using a specially developed numerical algorithm. The model presented in this study makes it possible to describe the formation of characteristic thermal and concentration structures and the transition modes of cellular convection with a complex configuration of flows in layers.
- 1 August 2023
- Published by Pleiades Publishing Ltd in Journal of Applied Mechanics and Technical Physics
- Vol. 64 (4) , 564-574
SIMULATION OF CONVECTION IN A TWO-PHASE SYSTEM UNDER CONDITIONS OF DIFFUSIVE EVAPORATION IN A CLOSED REGION
This paper describes the study of a problem of thermocapillary convection in a flat bounded region filled with liquid and gas in contact along the interfacial interface under weak evaporation. It is proposed to investigate the heat and mass transfer processes and the parameters of phase transitions during local heating using a two-sided mathematical model based on the Oberbeck–Boussinesq equations. The characteristics of mass transfer through a thermocapillary interface due to evaporation and vapor content in the gas layer are analyzed with account for the influence of the Soret and Dufour effects. The results of a numerical study of the evolution of the interface and unsteady flows in a cell are presented. The calculation of the main characteristics of the liquid — gas system and the position of the interface at each time is carried out using a specially developed numerical algorithm. The model presented in this study makes it possible to describe the formation of characteristic thermal and concentration structures and the transition modes of cellular convection with a complex configuration of flows in layers.
- 1 January 2016
- Published by Pleiades Publishing Ltd in Fluid Dynamics
- Vol. 51 (1) , 99-108
Formation of a secondary droplet over the crown upon the liquid film rupture under the action of a laser beam
The free surface of a liquid film exposed to a laser beam is deformed and suffers a rupture. Depending on the thermal load intensity and the thermal properties of the liquid the rupture can be accompanied by the formation of secondary droplets over the film crown. This process is investigated using a mathematical model describing the motion of the thin layer of a viscous nonisothermal liquid. The model is based on the two-dimensional Navier–Stokes equations. The boundary conditions at the film-gas and film-liquid interfaces necessary for the solution of these equations are derived in the explicit form. The results of the solution of model problems are presented.
- 1 January 2016
- Published by Pleiades Publishing Ltd in Fluid Dynamics
- Vol. 51 (1) , 99-108
Formation of a secondary droplet over the crown upon the liquid film rupture under the action of a laser beam
The free surface of a liquid film exposed to a laser beam is deformed and suffers a rupture. Depending on the thermal load intensity and the thermal properties of the liquid the rupture can be accompanied by the formation of secondary droplets over the film crown. This process is investigated using a mathematical model describing the motion of the thin layer of a viscous nonisothermal liquid. The model is based on the two-dimensional Navier–Stokes equations. The boundary conditions at the film-gas and film-liquid interfaces necessary for the solution of these equations are derived in the explicit form. The results of the solution of model problems are presented.
- 27 December 2013
- Published by Pleiades Publishing Ltd in Computational Mathematics and Mathematical Physics
- Vol. 53 (12) , 1900-1907
Features of the behavior of a liquid film heated from above and placed over deep liquid
The features of rupture occurring in a liquid film lying on deep liquid are studied. A thermal load applied to the film free surface leads to its deformation and rupture. The process is studied using a mathematical model describing the motion of a thin viscous nonisothermal liquid layer. The model is based on the two-dimensional Navier-Stokes equations. To solve them, the boundary conditions on the film-gas and film-liquid interfaces are written in explicit form. The effect of the thermal load on the film rupture is analyzed numerically depending on the Marangoni number and the stresses on the film-liquid interface. The results of solving model problems are presented.
- 27 December 2013
- Published by Pleiades Publishing Ltd in Computational Mathematics and Mathematical Physics
- Vol. 53 (12) , 1900-1907
Features of the behavior of a liquid film heated from above and placed over deep liquid
The features of rupture occurring in a liquid film lying on deep liquid are studied. A thermal load applied to the film free surface leads to its deformation and rupture. The process is studied using a mathematical model describing the motion of a thin viscous nonisothermal liquid layer. The model is based on the two-dimensional Navier-Stokes equations. To solve them, the boundary conditions on the film-gas and film-liquid interfaces are written in explicit form. The effect of the thermal load on the film rupture is analyzed numerically depending on the Marangoni number and the stresses on the film-liquid interface. The results of solving model problems are presented.
- 1 March 2012
- Published by Pleiades Publishing Ltd in Journal of Applied Mechanics and Technical Physics
- Vol. 53 (2) , 182-189
Effect of the thermophysical properties of the liquid on the rupture of a film under a thermal load. Role of the Prandtl number
The rupture of freely hanging liquid films depending on the Prandtl number is considered. The process is studied using a mathematical model based on two-dimensional Navier-Stokes equations which describes the motion of a thin layer of a nonisothermal viscous liquid in microgravity. It is shown that if the temperature on the entire free surface is given in advance, the lifetime of the film, the character of the rupture, and the position of the free surface, with the set of forces taken into account in the model, do not depend on the Prandtl number. If temperature is specified only in some region of the free surface, and on the rest of the surface, it is to be determined in the process of solving the problem, the Prandtl number plays an important role. Results of solution of model problems are presented.
- 1 March 2012
- Published by Pleiades Publishing Ltd in Journal of Applied Mechanics and Technical Physics
- Vol. 53 (2) , 182-189
Effect of the thermophysical properties of the liquid on the rupture of a film under a thermal load. Role of the Prandtl number
The rupture of freely hanging liquid films depending on the Prandtl number is considered. The process is studied using a mathematical model based on two-dimensional Navier-Stokes equations which describes the motion of a thin layer of a nonisothermal viscous liquid in microgravity. It is shown that if the temperature on the entire free surface is given in advance, the lifetime of the film, the character of the rupture, and the position of the free surface, with the set of forces taken into account in the model, do not depend on the Prandtl number. If temperature is specified only in some region of the free surface, and on the rest of the surface, it is to be determined in the process of solving the problem, the Prandtl number plays an important role. Results of solution of model problems are presented.
- 1 February 2006
- Published by Pleiades Publishing Ltd in Computational Mathematics and Mathematical Physics
- Vol. 46 (2) , 305-314
Leveling a capillary ridge generated by substrate geometry
The formation of capillary ridges is typical of thin viscous films flowing over a topographical feature. This process is studied by using a two-dimensional model describing the slow motion of a thin viscous nonisothermal liquid film flowing over complex topography. The model is based on the Navier-Stokes equations in the Oberbeck-Boussinesq approximation. The density, surface tension, and viscosity of the liquid are linear functions of temperature. For a nonisothermal flow over a planar substrate with a local heater, the influence of the heater on the free surface is analyzed numerically depending on the buoyancy effect, Marangoni stresses, and variable viscosity. The analysis shows that the film can create its own ridges or valleys depending on the heater and the dominating liquid properties. It is shown that the capillary ridges generated by the substrate features can be optimally leveled by using various types of heaters consistent with the dominating liquid properties. Numerical results for model problems are presented.
- 1 February 2006
- Published by Pleiades Publishing Ltd in Computational Mathematics and Mathematical Physics
- Vol. 46 (2) , 305-314
Leveling a capillary ridge generated by substrate geometry
The formation of capillary ridges is typical of thin viscous films flowing over a topographical feature. This process is studied by using a two-dimensional model describing the slow motion of a thin viscous nonisothermal liquid film flowing over complex topography. The model is based on the Navier-Stokes equations in the Oberbeck-Boussinesq approximation. The density, surface tension, and viscosity of the liquid are linear functions of temperature. For a nonisothermal flow over a planar substrate with a local heater, the influence of the heater on the free surface is analyzed numerically depending on the buoyancy effect, Marangoni stresses, and variable viscosity. The analysis shows that the film can create its own ridges or valleys depending on the heater and the dominating liquid properties. It is shown that the capillary ridges generated by the substrate features can be optimally leveled by using various types of heaters consistent with the dominating liquid properties. Numerical results for model problems are presented.