Wanjin Zhang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Wanjin Zhang has a total of 51 co-authors. Here are the top co-authors by number of shared publications:
Xiaofeng Lu
Department of Chemistry, Alan G. MacDiarmid Institute, Jilin University, Changchun 130012, People's Republic of China
19 shared publicationsDanming Chao
Department of Chemistry, Alan G. MacDiarmid Institute, Jilin University, Changchun 130012, People's Republic of China
18 shared publicationsYen Wei
Department of Chemistry, Drexel University, Philadelphia, PA 19104, USA
14 shared publicationsHui Mao
Alan G. MacDiarmid Institute, Jilin University, Changchun 130012, P. R. China
9 shared publicationsLili Cui
Alan G. MacDiarmid Institute, Jilin University, Changchun, 130012 People's Republic of China
8 shared publicationsChunhai Chen
Alan G. MacDiarmid Institute, Jilin University, Changchun 130012, People's Republic of China
5 shared publications
Latest Publications
- 14 July 2010
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 118 (6) , 3318-3323
Crosslinked sulfonated poly(arylene ether ketone) with pendant carboxylic acid group via poly(ethylene glycol) for proton exchange membrane
Novel proton exchange membranes are solvent‐cast from N,N‐dimethylacetamide (DMAc) solutions of the crosslinked poly(arylene ether ketone) copolymer with pendant carboxylic acid group (C‐SPAEK) via poly(ethylene glycol) (PEG) with different amounts. These membranes are formed as a result of physical and chemical crosslinking. In this study, 1H‐NMR and FTIR have been used to confirm the chemical structures of the copolymers. Mechanical and thermal properties, swelling and proton conductivity are affected by the crosslinker (PEG) content in the copolymers. Compared to the noncrosslinked C‐SPAEK membrane, the crosslinked membranes become more flexible and greatly reduced water uptake and swelling ratio with only slight sacrifice in proton conductivities. And the crosslinked membranes keep higher proton conductivities without a sharply decrease at higher temperature. These results show that the crosslinked membranes have potential applications as proton exchange membranes for fuel cell. © 2010 Wiley Periodicals, Inc. J Appl Polym Sci, 2010
- 14 July 2010
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 118 (6) , 3318-3323
Crosslinked sulfonated poly(arylene ether ketone) with pendant carboxylic acid group via poly(ethylene glycol) for proton exchange membrane
Novel proton exchange membranes are solvent‐cast from N,N‐dimethylacetamide (DMAc) solutions of the crosslinked poly(arylene ether ketone) copolymer with pendant carboxylic acid group (C‐SPAEK) via poly(ethylene glycol) (PEG) with different amounts. These membranes are formed as a result of physical and chemical crosslinking. In this study, 1H‐NMR and FTIR have been used to confirm the chemical structures of the copolymers. Mechanical and thermal properties, swelling and proton conductivity are affected by the crosslinker (PEG) content in the copolymers. Compared to the noncrosslinked C‐SPAEK membrane, the crosslinked membranes become more flexible and greatly reduced water uptake and swelling ratio with only slight sacrifice in proton conductivities. And the crosslinked membranes keep higher proton conductivities without a sharply decrease at higher temperature. These results show that the crosslinked membranes have potential applications as proton exchange membranes for fuel cell. © 2010 Wiley Periodicals, Inc. J Appl Polym Sci, 2010
- 30 April 2010
- Published by Elsevier in Reactive and Functional Polymers
- Vol. 70 (4) , 251-256
Synthesis, characterization and properties of an electroactive polymer having oligoaniline and binaphthyl units
- 30 April 2010
- Published by Elsevier in Reactive and Functional Polymers
- Vol. 70 (4) , 251-256
Synthesis, characterization and properties of an electroactive polymer having oligoaniline and binaphthyl units
- 1 March 2010
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry
- Vol. 20 (15) , 3079-3083
Unique tetragonal starlike polyaniline microstructure and its application in electrochemical biosensing
Tetragonal starlike microstructures of polyaniline (PANI) doped with aspartic acid (AA) have been synthesized under hydrothermal conditions for the first time. It was found that the morphologies of the obtained samples were much sensitive to the concentration of the doping amino acid. Hydrothermal synthesis by monitoring the reaction time provided a platform for understanding the process of the polymerization. The products were characterized by scanning electron microscopy (SEM), transmission electron microscopy (TEM), UV-visible spectroscopy (UV-vis), Fourier transmission infrared spectroscopy (FT-IR), and X-ray diffraction (XRD). Furthermore, the tetragonal starlike PANI modified glassy carbon electrode (GCE) exhibited high electrocatalytic activity for sensing dopamine.
- 1 March 2010
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry
- Vol. 20 (15) , 3079-3083
Unique tetragonal starlike polyaniline microstructure and its application in electrochemical biosensing
Tetragonal starlike microstructures of polyaniline (PANI) doped with aspartic acid (AA) have been synthesized under hydrothermal conditions for the first time. It was found that the morphologies of the obtained samples were much sensitive to the concentration of the doping amino acid. Hydrothermal synthesis by monitoring the reaction time provided a platform for understanding the process of the polymerization. The products were characterized by scanning electron microscopy (SEM), transmission electron microscopy (TEM), UV-visible spectroscopy (UV-vis), Fourier transmission infrared spectroscopy (FT-IR), and X-ray diffraction (XRD). Furthermore, the tetragonal starlike PANI modified glassy carbon electrode (GCE) exhibited high electrocatalytic activity for sensing dopamine.
- 5 September 2009
- Published by Elsevier in Journal of Power Sources
- Vol. 193 (2) , 477-482
Controllable sulfonation of aromatic poly(arylene ether ketone)s containing different pendant phenyl rings
- 5 September 2009
- Published by Elsevier in Journal of Power Sources
- Vol. 193 (2) , 477-482
Controllable sulfonation of aromatic poly(arylene ether ketone)s containing different pendant phenyl rings
- 12 May 2009
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 113 (22) , 9465-9472
One-Step Synthesis of Au/PEDOT/β-Fe3+O(OH, Cl) Nanospindles in Aqueous Solution
- 12 May 2009
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 113 (22) , 9465-9472
One-Step Synthesis of Au/PEDOT/β-Fe3+O(OH, Cl) Nanospindles in Aqueous Solution
- 6 April 2009
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 113 (2) , 1330-1334
Rapid bending of a nonliquid crystal azobenzene polymer film and characteristics of surface relief grating
A nonliquid crystal polymer was prepared by introducing the azobenzene group into the main chain of the poly(amic acid). The polymer film can be easily prepared by a general method. The obtained film exhibits a high bending intensity and shows fast bending response and a very large bending angle (reach of 90°) at room temperature without temperature heating, which can improve the efficiency of the transformation of energy from light to mechanical energy. The surface structure of the relief grating also was investigated by atomic force microscopy. The depth of typical surface relief was approximately 65 nm. © 2009 Wiley Periodicals, Inc. J Appl Polym Sci, 2009
- 6 April 2009
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 113 (2) , 1330-1334
Rapid bending of a nonliquid crystal azobenzene polymer film and characteristics of surface relief grating
A nonliquid crystal polymer was prepared by introducing the azobenzene group into the main chain of the poly(amic acid). The polymer film can be easily prepared by a general method. The obtained film exhibits a high bending intensity and shows fast bending response and a very large bending angle (reach of 90°) at room temperature without temperature heating, which can improve the efficiency of the transformation of energy from light to mechanical energy. The surface structure of the relief grating also was investigated by atomic force microscopy. The depth of typical surface relief was approximately 65 nm. © 2009 Wiley Periodicals, Inc. J Appl Polym Sci, 2009
- 25 February 2009
- Published by Wiley in Macromolecular Chemistry and Physics
- Vol. 210 (5) , 394-400
Novel Copolymer with Oligoaniline and Anthracene Units in the Main Chain: Synthesis, Characterization, and Optical Properties
- 25 February 2009
- Published by Wiley in Macromolecular Chemistry and Physics
- Vol. 210 (5) , 394-400
Novel Copolymer with Oligoaniline and Anthracene Units in the Main Chain: Synthesis, Characterization, and Optical Properties
- 24 November 2008
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 112 (51) , 20469-20480
Preparation and Characterization of PEDOT/β-Fe3+O(OH,Cl) Nanospindles with Controllable Sizes in Aqueous Solution
- 24 November 2008
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 112 (51) , 20469-20480
Preparation and Characterization of PEDOT/β-Fe3+O(OH,Cl) Nanospindles with Controllable Sizes in Aqueous Solution
- 8 October 2008
- Published by Springer Nature in Polymer Journal
- Vol. 40 (12) , 1195-1198
Morphology and Structure of Ring-banded Spherulites Obtained by Solvent Evaporation in PLLA/PAAC Blend Films
- 8 October 2008
- Published by Springer Nature in Polymer Journal
- Vol. 40 (12) , 1195-1198
Morphology and Structure of Ring-banded Spherulites Obtained by Solvent Evaporation in PLLA/PAAC Blend Films
- 18 August 2008
- Published by Wiley in Polymer Composites
- Vol. 30 (6) , 847-854
Fabrication of core‐shell Fe3O4/polypyrrole and hollow polypyrrole microspheres
A facile synthesis of highly‐regulated core‐shell Fe3O4/polypyrrole (PPy) microspheres is achieved using a surfactant directed chemical oxidation polymerization in aqueous solution. The thickness of the PPy layer can be tuned by the quantity of the pyrrole monomer. The formation of core‐shell Fe3O4/PPy microspheres lies on the static interactions between the SO3− group in sodium dodecyl sulphate molecules and Fe3O4 microspheres. Other surfactants such as cetyltrimethylammonium bromide and polyoxyethylene (10) isooctylcyclohexyl ether (Triton X‐100) directed polymerization cannot produce such highly‐regulated core‐shell Fe3O4/PPy microspheres. XPS spectra proved the core‐shell structure of the composite microspheres. XRD, FTIR, and UV–vis spectra are used to characterize the chemical structure of the composite microspheres. The electrical and magnetic properties are also investigated. Moreover, the obtained core‐shell Fe3O4/PPy microspheres can be converted to highly‐regulated hollow PPy microspheres by dissolving the Fe3O4 core with acid solution. POLYM. COMPOS., 2009. © 2008 Society of Plastics Engineers
- 18 August 2008
- Published by Wiley in Polymer Composites
- Vol. 30 (6) , 847-854
Fabrication of core‐shell Fe3O4/polypyrrole and hollow polypyrrole microspheres
A facile synthesis of highly‐regulated core‐shell Fe3O4/polypyrrole (PPy) microspheres is achieved using a surfactant directed chemical oxidation polymerization in aqueous solution. The thickness of the PPy layer can be tuned by the quantity of the pyrrole monomer. The formation of core‐shell Fe3O4/PPy microspheres lies on the static interactions between the SO3− group in sodium dodecyl sulphate molecules and Fe3O4 microspheres. Other surfactants such as cetyltrimethylammonium bromide and polyoxyethylene (10) isooctylcyclohexyl ether (Triton X‐100) directed polymerization cannot produce such highly‐regulated core‐shell Fe3O4/PPy microspheres. XPS spectra proved the core‐shell structure of the composite microspheres. XRD, FTIR, and UV–vis spectra are used to characterize the chemical structure of the composite microspheres. The electrical and magnetic properties are also investigated. Moreover, the obtained core‐shell Fe3O4/PPy microspheres can be converted to highly‐regulated hollow PPy microspheres by dissolving the Fe3O4 core with acid solution. POLYM. COMPOS., 2009. © 2008 Society of Plastics Engineers