Mark A. E. Auty
Research Subjects
Research Interests
Mark A. E. Auty has a total of 52 co-authors. Here are the top co-authors by number of shared publications:
- Alan L. Kelly
School of Food and Nutritional Sciences, University College Cork, College Road, Cork, T12 K8AF, Ireland
2 shared publications - Amy Logan
CSIRO Agriculture and Food, Werribee, Victoria 3030, Australia
2 shared publications - Charlotte E. Conn
School of Science, RMIT University City Campus, Melbourne, VIC 3000, Australia
2 shared publications - Lisa M. Zychowski
Food Chemistry and Technology Department, Teagasc Food Research Centre, Moorepark, Fermoy, Co. Cork, Ireland
2 shared publications Mary Ann Augustin
CSIRO Agriculture and Food, Werribee, Victoria 3030, Australia
2 shared publications- Adnan Y Tamime
24 Queens Terrace, Ayr KA7 1DX, UK
1 shared publication
Latest Publications
- Open Access
- 3 April 2020
- Published by MDPI AG in International Journal of Molecular Sciences
- Vol. 21 (7) , 2486
Development and Assessment of Duplex and Triplex Laminated Edible Films Using Whey Protein Isolate, Gelatin and Sodium Alginate
The objective of this study was to assess the ability of producing laminated edible films manufactured using the following proteins; gelatin (G), whey protein isolate (WPI) and polysaccharide sodium alginate (SA), and to evaluate their physical properties. Additionally, films’ preparation employing these ingredients was optimized through the addition of corn oil (O). Overall, 8-types of laminated films (G-SA, G-WPI, SA-WPI, SA-G-WPI, GO-SAO, GO-WPIO, SAO-WPIO and SAO-GO-WPIO) were developed in this study. The properties of the prepared films were characterized through the measurement of tensile strength (TS), elongation at break point (EB), puncture resistance (PR), tear strength (TT), water vapour permeability (WVP) and oxygen permeability (OP). The microstructure of cross-sections of laminated films was investigated by scanning electron microscopy (SEM). Mechanical properties of films were dramatically enhanced through the addition of film layers. GO-SAO laminate showed the best barrier properties to water vapour (22.6 ± 4.04 g mm/kPa d m2) and oxygen (18.2 ± 8.70 cm3 mm/kPa d m2). SAO-GO-WPIO laminate film was the strongest of all laminated films tested, having the highest TS of 55.77 MPa, PR of 41.36 N and TT of 27.32 N. SA-G-WPI film possessed the highest elasticity with an EB value of 17.4%.
- 3 April 2020
- Published by MDPI AG in International Journal of Molecular Sciences
- Vol. 21 (7) , 2486
Open AccessDevelopment and Assessment of Duplex and Triplex Laminated Edible Films Using Whey Protein Isolate, Gelatin and Sodium Alginate
The objective of this study was to assess the ability of producing laminated edible films manufactured using the following proteins; gelatin (G), whey protein isolate (WPI) and polysaccharide sodium alginate (SA), and to evaluate their physical properties. Additionally, films’ preparation employing these ingredients was optimized through the addition of corn oil (O). Overall, 8-types of laminated films (G-SA, G-WPI, SA-WPI, SA-G-WPI, GO-SAO, GO-WPIO, SAO-WPIO and SAO-GO-WPIO) were developed in this study. The properties of the prepared films were characterized through the measurement of tensile strength (TS), elongation at break point (EB), puncture resistance (PR), tear strength (TT), water vapour permeability (WVP) and oxygen permeability (OP). The microstructure of cross-sections of laminated films was investigated by scanning electron microscopy (SEM). Mechanical properties of films were dramatically enhanced through the addition of film layers. GO-SAO laminate showed the best barrier properties to water vapour (22.6 ± 4.04 g mm/kPa d m2) and oxygen (18.2 ± 8.70 cm3 mm/kPa d m2). SAO-GO-WPIO laminate film was the strongest of all laminated films tested, having the highest TS of 55.77 MPa, PR of 41.36 N and TT of 27.32 N. SA-G-WPI film possessed the highest elasticity with an EB value of 17.4%.
- Open Access
- 1 October 2018
- Published by Elsevier in Food Chemistry
- Vol. 264, 24-33
Phytosterol crystallisation within bulk and dispersed triacylglycerol matrices as influenced by oil droplet size and low molecular weight surfactant addition
- 1 October 2018
- Published by Elsevier in Food Chemistry
- Vol. 264, 24-33
Open AccessPhytosterol crystallisation within bulk and dispersed triacylglycerol matrices as influenced by oil droplet size and low molecular weight surfactant addition
- 1 October 2016
- Published by Elsevier in Food Research International
- Vol. 88, 42-51
Improving thermal stability of hydrolysed whey protein-based infant formula emulsions by protein–carbohydrate conjugation
- 1 October 2016
- Published by Elsevier in Food Research International
- Vol. 88, 42-51
Improving thermal stability of hydrolysed whey protein-based infant formula emulsions by protein–carbohydrate conjugation
- 23 August 2016
- Published by American Chemical Society (ACS) in Journal of Agricultural and Food Chemistry
- Vol. 64 (34) , 6546-6554
Effect of Phytosterols on the Crystallization Behavior of Oil-in-Water Milk Fat Emulsions
Milk has been used commercially as a carrier for phytosterols, but there is limited knowledge on the effect of added plant sterols on the properties of the system. In this study, phytosterols dispersed in milk fat at a level of 0.3 or 0.6% were homogenized with an aqueous dispersion of whey protein isolate (WPI). The particle size, morphology, ζ-potential, and stability of the emulsions were investigated. Emulsion crystallization properties were examined through the use of differential scanning calorimetry (DSC) and Synchrotron X-ray scattering at both small and wide angles. Phytosterol enrichment influenced the particle size and physical appearance of the emulsion droplets, but did not affect the stability or charge of the dispersed particles. DSC data demonstrated that, at the higher level of phytosterol addition, crystallization of milk fat was delayed, whereas, at the lower level, phytosterol enrichment induced nucleation and emulsion crystallization. These differences were attributed to the formation of separate phytosterol crystals within the emulsions at the high phytosterol concentration, as characterized by Synchrotron X-ray measurements. X-ray scattering patterns demonstrated the ability of the phytosterol to integrate within the milk fat triacylglycerol matrix, with a concomitant increase in longitudinal packing and system disorder. Understanding the consequences of adding phytosterols, on the physical and crystalline behavior of emulsions may enable the functional food industry to design more physically and chemically stable products.
- 23 August 2016
- Published by American Chemical Society (ACS) in Journal of Agricultural and Food Chemistry
- Vol. 64 (34) , 6546-6554
Effect of Phytosterols on the Crystallization Behavior of Oil-in-Water Milk Fat Emulsions
Milk has been used commercially as a carrier for phytosterols, but there is limited knowledge on the effect of added plant sterols on the properties of the system. In this study, phytosterols dispersed in milk fat at a level of 0.3 or 0.6% were homogenized with an aqueous dispersion of whey protein isolate (WPI). The particle size, morphology, ζ-potential, and stability of the emulsions were investigated. Emulsion crystallization properties were examined through the use of differential scanning calorimetry (DSC) and Synchrotron X-ray scattering at both small and wide angles. Phytosterol enrichment influenced the particle size and physical appearance of the emulsion droplets, but did not affect the stability or charge of the dispersed particles. DSC data demonstrated that, at the higher level of phytosterol addition, crystallization of milk fat was delayed, whereas, at the lower level, phytosterol enrichment induced nucleation and emulsion crystallization. These differences were attributed to the formation of separate phytosterol crystals within the emulsions at the high phytosterol concentration, as characterized by Synchrotron X-ray measurements. X-ray scattering patterns demonstrated the ability of the phytosterol to integrate within the milk fat triacylglycerol matrix, with a concomitant increase in longitudinal packing and system disorder. Understanding the consequences of adding phytosterols, on the physical and crystalline behavior of emulsions may enable the functional food industry to design more physically and chemically stable products.
- Open Access
- 18 February 2015
- Published by Frontiers Media SA in Frontiers in Microbiology
- Vol. 6, 99
Growth and location of bacterial colonies within dairy foods using microscopy techniques: a review
The growth, location and distribution of bacterial colonies in dairy products are important factors for the ripening and flavor development of cheeses, yogurts and soured creams. Starter, non-starter, spoilage and pathogenic bacteria all become entrapped in the developing casein matrix of dairy foods. In order to visualize these bacterial colonies and the environments surrounding them, microscopy techniques are used. The use of various microscopy methods allow for the rapid detection, enumeration and distribution of starter, non-starter and pathogenic bacteria in dairy foods. Confocal laser scanning microscopy is extensively utilised to identify bacteria location via the use of fluorescent dyes. Further study is needed in relation to the development of micro- gradients and localized ripening parameters in dairy products due to the location of bacteria at the protein-fat interface. Development in the area of bacterial discrimination using microscopy techniques and fluorescent dyes/tags is needed as the benefits of rapidly identifying spoilage/pathogenic bacteria early in product manufacture would be of huge benefit in relation to both safety and financial concerns.
- 18 February 2015
- Published by Frontiers Media SA in Frontiers in Microbiology
- Vol. 6, 99
Open AccessGrowth and location of bacterial colonies within dairy foods using microscopy techniques: a review
The growth, location and distribution of bacterial colonies in dairy products are important factors for the ripening and flavor development of cheeses, yogurts and soured creams. Starter, non-starter, spoilage and pathogenic bacteria all become entrapped in the developing casein matrix of dairy foods. In order to visualize these bacterial colonies and the environments surrounding them, microscopy techniques are used. The use of various microscopy methods allow for the rapid detection, enumeration and distribution of starter, non-starter and pathogenic bacteria in dairy foods. Confocal laser scanning microscopy is extensively utilised to identify bacteria location via the use of fluorescent dyes. Further study is needed in relation to the development of micro- gradients and localized ripening parameters in dairy products due to the location of bacteria at the protein-fat interface. Development in the area of bacterial discrimination using microscopy techniques and fluorescent dyes/tags is needed as the benefits of rapidly identifying spoilage/pathogenic bacteria early in product manufacture would be of huge benefit in relation to both safety and financial concerns.
- 1 January 2013
- Published by Elsevier
Contributor contact details
- 1 December 2011
- Published by Elsevier in Food Chemistry
- Vol. 129 (4) , 1362-1368
Techniques for localisation of konjac glucomannan in model milk protein–polysaccharide mixed systems: Physicochemical and microscopic investigations
- 1 December 2011
- Published by Elsevier in Food Chemistry
- Vol. 129 (4) , 1362-1368
Techniques for localisation of konjac glucomannan in model milk protein–polysaccharide mixed systems: Physicochemical and microscopic investigations
A new cryo‐STEM method for imaging food colloids in the scanning electron microscope
A new cryo‐scanning transmission electron microscopy (cryo‐STEM) technique for imaging casein micelles in a field emission scanning electron microscope is presented. Thin films of micellar casein suspensions on lacey carbon grids were prepared using a modified sample holder developed by Gatan UK. Bright and dark field images were obtained at −135°C showing casein micelles in their frozen hydrated state and in the size range 30–500 nm. Results were compared favorably with published images of casein micelles obtained with conventional cryo‐transmission electron microscopy, suggesting that cryo‐STEM is a useful alternative technique for visualizing food colloids close to their native state. SCANNING 32: 150–154, 2010.
A new cryo‐STEM method for imaging food colloids in the scanning electron microscope
A new cryo‐scanning transmission electron microscopy (cryo‐STEM) technique for imaging casein micelles in a field emission scanning electron microscope is presented. Thin films of micellar casein suspensions on lacey carbon grids were prepared using a modified sample holder developed by Gatan UK. Bright and dark field images were obtained at −135°C showing casein micelles in their frozen hydrated state and in the size range 30–500 nm. Results were compared favorably with published images of casein micelles obtained with conventional cryo‐transmission electron microscopy, suggesting that cryo‐STEM is a useful alternative technique for visualizing food colloids close to their native state. SCANNING 32: 150–154, 2010.