Wolfgang Ensinger
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Wolfgang Ensinger has a total of 26 co-authors. Here are the top co-authors by number of shared publications:
K. Baba
Nagasaki University, Graduate School of Engineering, 1-14 Bunkyo, Nagasaki 852-8521, Japan
5 shared publicationsR. Hatada
Materials Science, Technische Universität Darmstadt, Darmstadt 64287, Germany
5 shared publicationsS. Flege
4 shared publications- F. Sittner
Technische Universität Darmstadt, Department of Materials Science, Petersenstr. 23, 64287 Darmstadt, Germany
2 shared publications K. Volz
University of Marburg, Materials Science Center, Marburg, Germany
2 shared publications- M. Yekehtaz
Technische Universität Darmstadt, Department of Materials Science, Petersenstr. 23, 64287 Darmstadt, Germany
2 shared publications
Latest Publications
- 1 April 2016
- Published by Elsevier in Materials Letters
- Vol. 168, 196-199
Preparation of anatase surface layers via carbon implantation into titanium
- 1 April 2016
- Published by Elsevier in Materials Letters
- Vol. 168, 196-199
Preparation of anatase surface layers via carbon implantation into titanium
- 6 August 2013
- Published by Springer Nature in Grundwasser
- Vol. 18 (3) , 197-202
Untersuchungen zur Sorptionsreversibilität von organischen Schadstoffen in Aktivkohle, Holzkohle und Zeolith Y-200
- 6 August 2013
- Published by Springer Nature in Grundwasser
- Vol. 18 (3) , 197-202
Untersuchungen zur Sorptionsreversibilität von organischen Schadstoffen in Aktivkohle, Holzkohle und Zeolith Y-200
- 27 July 2013
- Published by Springer Nature in Journal of Sol-Gel Science and Technology
- Vol. 67 (3) , 654-659
Comparison of the influence of titanium and chromium adhesion layers on the properties of sol–gel derived NKN thin films
- 27 July 2013
- Published by Springer Nature in Journal of Sol-Gel Science and Technology
- Vol. 67 (3) , 654-659
Comparison of the influence of titanium and chromium adhesion layers on the properties of sol–gel derived NKN thin films
- 26 October 2011
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Plasma Science
- Vol. 39 (11) , 3140-3143
Deposition of Diamond-Like Carbon Films on Inner Wall Surfaces of Millimeter-Size-Diameter Steel Tubes by Plasma Source Ion Implantation
Diamond-like carbon (DLC) film deposition on the interior surfaces of steel tubes was carried out by plasma source ion implantation. SUS304 austenitic-type stainless steel tubes with inner diameters of 9, 5, and 4 mm were used as substrate tubes. Acetylene was the working gas for the plasma that was generated by applying a negative pulse voltage of -18 kV to the substrates. The surface morphology of the films and the film thickness were observed by atomic force microscopy and scanning electron microscopy. The composition within the film and at the interface was examined by depth profiling with Auger electron spectroscopy and secondary ion mass spectrometry. The film structure was characterized by Raman spectroscopy. The friction coefficient of the untreated substrate and the DLC films was evaluated by a reciprocating sliding test. The DLC film surfaces were smooth, and no special structure was observed on the surface. The DLC film thicknesses, structure, and composition on the interior surface of the steel tube depend, on the one hand, on the gas and pulse conditions and, on the other hand, on the distance from the end of the tube, as well as on the diameter of the tube. A low friction coefficient of 0.2 was derived for the deposited DLC films.
- 26 October 2011
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Plasma Science
- Vol. 39 (11) , 3140-3143
Deposition of Diamond-Like Carbon Films on Inner Wall Surfaces of Millimeter-Size-Diameter Steel Tubes by Plasma Source Ion Implantation
Diamond-like carbon (DLC) film deposition on the interior surfaces of steel tubes was carried out by plasma source ion implantation. SUS304 austenitic-type stainless steel tubes with inner diameters of 9, 5, and 4 mm were used as substrate tubes. Acetylene was the working gas for the plasma that was generated by applying a negative pulse voltage of -18 kV to the substrates. The surface morphology of the films and the film thickness were observed by atomic force microscopy and scanning electron microscopy. The composition within the film and at the interface was examined by depth profiling with Auger electron spectroscopy and secondary ion mass spectrometry. The film structure was characterized by Raman spectroscopy. The friction coefficient of the untreated substrate and the DLC films was evaluated by a reciprocating sliding test. The DLC film surfaces were smooth, and no special structure was observed on the surface. The DLC film thicknesses, structure, and composition on the interior surface of the steel tube depend, on the one hand, on the gas and pulse conditions and, on the other hand, on the distance from the end of the tube, as well as on the diameter of the tube. A low friction coefficient of 0.2 was derived for the deposited DLC films.
- Open Access
- 10 October 2011
- Published by IntechOpen
Compilation on Synthesis, Characterization and Properties of Silicon and Boron Carbonitride Films
- 10 October 2011
- Published by IntechOpen
Open AccessCompilation on Synthesis, Characterization and Properties of Silicon and Boron Carbonitride Films
- 1 July 2010
- Published by Elsevier in Thin Solid Films
- Vol. 518 (18) , 5223-5226
Characterization of protective sol–gel coatings on magnesium based on phenyl-triethoxysilane precursor
- 1 July 2010
- Published by Elsevier in Thin Solid Films
- Vol. 518 (18) , 5223-5226
Characterization of protective sol–gel coatings on magnesium based on phenyl-triethoxysilane precursor
- 1 May 2009
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms
- Vol. 267 (8) , 1666-1669
Corrosion resistance of magnesium treated by hydrocarbon plasma immersion ion implantation
- 1 May 2009
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms
- Vol. 267 (8) , 1666-1669
Corrosion resistance of magnesium treated by hydrocarbon plasma immersion ion implantation