Gilles Flamant
Research Subjects
Research Interests
Gilles Flamant has a total of 37 co-authors. Here are the top co-authors by number of shared publications:
- Daniel Laplaze
Laboratoire des Colloïdes , Verres et Nanomatériaux (LCVN), Université de Montpellier II , Montpellier cedex, France
3 shared publications - Stéphane Abanades
CNRS Processes, Materials and Solar Energy Laboratory, PROMES—CNRS, 7 Rue du Four Solaire, 66120 Font-Romeu Odeillo, France
3 shared publications D Gauthier
Institut de Science et de Génie des Matériaux et Procédés, CNRS-IMP, 66125 Odeillo-Font Romeu Cédex, France
2 shared publications- D. Gauthier
Laboratoire Procédés et Matériaux et Energie Solaire (CNRS-PROMES), 7 Rue du Four Solaire, Odeillo, 66120 Font-Romeu Cedex, France
2 shared publications E. Anglaret
Groupe de Dynamique des Phases Condensées, Université de Montpellier II, 34095 Montpellier Cedex 5, France
2 shared publicationsJ. L. Sauvajol
Groupe de Dynamique des Phases Condensées, Université de Montpellier II, 34095 Montpellier Cedex 5, France
2 shared publications
Latest Publications
- 11 July 2007
- Published by Taylor & Francis in Fullerenes, Nanotubes and Carbon Nanostructures
- Vol. 15 (4) , 257-266
Nitrogen‐Doped Carbon Nanotubes Produced by Solar Energy
Both single‐walled and multi‐walled carbon nanotubes (SWNTs and MWNTs) are produced using a solar reactor working under nitrogen atmosphere. Samples were studied by transmission electron microscopy (TEM), Raman spectroscopy and electron energy loss spectroscopy (EELS). The produced MWNTs exhibit the typical morphologies observed for nitrogen‐doped MWNTs synthesized with other methods and EELS measurements point out the presence of substituted nitrogen within the tubes. The doping level is not uniform and the maximum value reaches 11 at.%.
- 11 July 2007
- Published by Taylor & Francis in Fullerenes, Nanotubes and Carbon Nanostructures
- Vol. 15 (4) , 257-266
Nitrogen‐Doped Carbon Nanotubes Produced by Solar Energy
Both single‐walled and multi‐walled carbon nanotubes (SWNTs and MWNTs) are produced using a solar reactor working under nitrogen atmosphere. Samples were studied by transmission electron microscopy (TEM), Raman spectroscopy and electron energy loss spectroscopy (EELS). The produced MWNTs exhibit the typical morphologies observed for nitrogen‐doped MWNTs synthesized with other methods and EELS measurements point out the presence of substituted nitrogen within the tubes. The doping level is not uniform and the maximum value reaches 11 at.%.
- 30 August 2004
- Published by Elsevier in Powder Technology
- Vol. 146 (1-2) , 20-31
Predicting heavy metal vaporization dynamics in a circulating fluidized bed riser by a Lagrangian approach
- 30 August 2004
- Published by Elsevier in Powder Technology
- Vol. 146 (1-2) , 20-31
Predicting heavy metal vaporization dynamics in a circulating fluidized bed riser by a Lagrangian approach
- 1 January 2004
- Vol. 16 (4) , 635-9
Volatilization of heavy metals during incineration of municipal solid wastes.
Incineration experiments with MSW, which had been impregnated with heavy metals, were presented to obtain information on the volatilization behavior of the elements cadmium(Cd), lead (Pb), and zinc (Zn) under different conditions. Experiments were carried out in a bubbling fluid bed system connected to a customized inductively coupled plasma optical emission spectroscopy (ICP-OES) for analyzing metals in the flue gas. The results indicated that the combustion temperature, the gas atmosphere, and the chlorine content in the flue gas could affect the volatilization behavior of heavy metals. In the fluidized bed combustion, a large surface area was provided by the bed sand particles, and they may act as absorbents for the gaseous ash-forming compound. Comparer with the metals Cd and Pb, the vaporization of Zn was low. The formation of stable compounds such as ZnO x Al2O3 could greatly decrease the metals volatilization. The presence of chlorine would enhance the volatilization of heavy metals by increasing the formation of metal chlorides. However, when the oxygen content was high, the chlorinating reaction was kinetically hindered, which heavy metals release would be delayed.
- 1 January 2004
- Vol. 16 (4) , 635-9
Volatilization of heavy metals during incineration of municipal solid wastes.
Incineration experiments with MSW, which had been impregnated with heavy metals, were presented to obtain information on the volatilization behavior of the elements cadmium(Cd), lead (Pb), and zinc (Zn) under different conditions. Experiments were carried out in a bubbling fluid bed system connected to a customized inductively coupled plasma optical emission spectroscopy (ICP-OES) for analyzing metals in the flue gas. The results indicated that the combustion temperature, the gas atmosphere, and the chlorine content in the flue gas could affect the volatilization behavior of heavy metals. In the fluidized bed combustion, a large surface area was provided by the bed sand particles, and they may act as absorbents for the gaseous ash-forming compound. Comparer with the metals Cd and Pb, the vaporization of Zn was low. The formation of stable compounds such as ZnO x Al2O3 could greatly decrease the metals volatilization. The presence of chlorine would enhance the volatilization of heavy metals by increasing the formation of metal chlorides. However, when the oxygen content was high, the chlorinating reaction was kinetically hindered, which heavy metals release would be delayed.
- 14 June 2002
- Published by Elsevier in Chemical Engineering Science
- Vol. 57 (14) , 2603-2614
Simulation of heavy metal vaporization dynamics in a fluidized bed
- 14 June 2002
- Published by Elsevier in Chemical Engineering Science
- Vol. 57 (14) , 2603-2614
Simulation of heavy metal vaporization dynamics in a fluidized bed
- 8 October 2001
- Published by Elsevier in Powder Technology
- Vol. 120 (1-2) , 134-140
Plasma-enhanced chemical vapor deposition of nitrides on fluidized particles
- 8 October 2001
- Published by Elsevier in Powder Technology
- Vol. 120 (1-2) , 134-140
Plasma-enhanced chemical vapor deposition of nitrides on fluidized particles
- Open Access
- 21 April 2001
- Published by ASME International
- p. 465
Heat, Mass and Fluid Flow in a Solar Reactor for Fullerene Synthesis
A 2 kW solar furnace was used to vaporize a graphite target for fullerene synthesis. Tests were performed in a wide range of vaporization rates (0.1–4 g/h), under variable pressure and argon flow rate. Experimental results are interpreted with numerical simulation to define key parameters for large-scale synthesis of fullerenes with solar energy. We demonstrate that the vaporization process is controlled by diffusion in the temperature and pressure ranges 3000–3700 K and 70–250 hPa respectively. Experimental data and numerical simulation suggest that in the solar reactor, fullerene yield is governed by the dilution of carbon vapor in argon and by the temperature gradient in the cooling zone. Criteria for both parameters are suggested. Consequently, these data, combined with the numerical model accounting for heat, mass and fluid flow inside the reactor, may be used for the design of large-scale solar process.
- 21 April 2001
- Published by ASME International
- p. 465
Open AccessHeat, Mass and Fluid Flow in a Solar Reactor for Fullerene Synthesis
A 2 kW solar furnace was used to vaporize a graphite target for fullerene synthesis. Tests were performed in a wide range of vaporization rates (0.1–4 g/h), under variable pressure and argon flow rate. Experimental results are interpreted with numerical simulation to define key parameters for large-scale synthesis of fullerenes with solar energy. We demonstrate that the vaporization process is controlled by diffusion in the temperature and pressure ranges 3000–3700 K and 70–250 hPa respectively. Experimental data and numerical simulation suggest that in the solar reactor, fullerene yield is governed by the dilution of carbon vapor in argon and by the temperature gradient in the cooling zone. Criteria for both parameters are suggested. Consequently, these data, combined with the numerical model accounting for heat, mass and fluid flow inside the reactor, may be used for the design of large-scale solar process.
- 15 March 1999
- Published by EDP Sciences in The European Physical Journal Applied Physics
- Vol. 5 (3) , 251-256
Production of carbon nanotubes by the solar route
- 15 March 1999
- Published by EDP Sciences in The European Physical Journal Applied Physics
- Vol. 5 (3) , 251-256
Production of carbon nanotubes by the solar route
- 1 January 1999
- Published by AIP Publishing
Solar synthesis of single wall carbon nanotubes
We discuss here the influence of some synthesis parameters in the production of single wall carbon nanotubes (SWNT) with a 2 kW solar furnace at the Odeillo Institute. We first study the specific role of catalysts like nickel or cobalt on the SWNT formation process. SEM and TEM pictures show significant differences in the yield of production and suggest different growth mechanisms. Furthermore, we report Raman spectra for samples produced using lanthanium or sulfur as catalysts. These samples provide very striking results in the low frequency range (in term of distribution in diameter) with a good correlation with the graphite-like modes region.
- 1 January 1999
- Published by AIP Publishing
Solar synthesis of single wall carbon nanotubes
We discuss here the influence of some synthesis parameters in the production of single wall carbon nanotubes (SWNT) with a 2 kW solar furnace at the Odeillo Institute. We first study the specific role of catalysts like nickel or cobalt on the SWNT formation process. SEM and TEM pictures show significant differences in the yield of production and suggest different growth mechanisms. Furthermore, we report Raman spectra for samples produced using lanthanium or sulfur as catalysts. These samples provide very striking results in the low frequency range (in term of distribution in diameter) with a good correlation with the graphite-like modes region.
- 1 January 1991
- Published by Taylor & Francis in Chemical Engineering Communications
- Vol. 100 (1) , 77-94
RESIDENCE TIME DISTRIBUTION IN A SERIES OF THREE TANKS WITH BYPASS AND BACK-MIXING. APPLICATION TO MULTISTAGE FLUIDIZED-BED
- 1 January 1991
- Published by Taylor & Francis in Chemical Engineering Communications
- Vol. 100 (1) , 77-94
RESIDENCE TIME DISTRIBUTION IN A SERIES OF THREE TANKS WITH BYPASS AND BACK-MIXING. APPLICATION TO MULTISTAGE FLUIDIZED-BED