Daniel Laplaze
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Daniel Laplaze has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
- Gilles Flamant
Laboratoire PROMES‐CNRS , Font Romeu Cedex, France
3 shared publications - Ana Maria Benito
Instituto de Carboquímica, ICB-CSIC
1 shared publication - Annick Loiseau
Université Paris-Saclay, ONERA-CNRS, Laboratoire d’Étude des Microstructures
1 shared publication D. Luxembourg
Laboratoire PROMES‐CNRS , Font Romeu Cedex, France
1 shared publicationE. Anglaret
Groupe de Dynamique des Phases Condensées, U.M.R.5581, 34095 Montpellier, France
1 shared publicationG. Olalde
Institut de Sciences et de Génie des Matériaux et Procédés, UPR 8521, 66125 Font-Romeu, France
1 shared publication
Latest Publications
- 11 July 2007
- Published by Taylor & Francis in Fullerenes, Nanotubes and Carbon Nanostructures
- Vol. 15 (4) , 257-266
Nitrogen‐Doped Carbon Nanotubes Produced by Solar Energy
Both single‐walled and multi‐walled carbon nanotubes (SWNTs and MWNTs) are produced using a solar reactor working under nitrogen atmosphere. Samples were studied by transmission electron microscopy (TEM), Raman spectroscopy and electron energy loss spectroscopy (EELS). The produced MWNTs exhibit the typical morphologies observed for nitrogen‐doped MWNTs synthesized with other methods and EELS measurements point out the presence of substituted nitrogen within the tubes. The doping level is not uniform and the maximum value reaches 11 at.%.
- 11 July 2007
- Published by Taylor & Francis in Fullerenes, Nanotubes and Carbon Nanostructures
- Vol. 15 (4) , 257-266
Nitrogen‐Doped Carbon Nanotubes Produced by Solar Energy
Both single‐walled and multi‐walled carbon nanotubes (SWNTs and MWNTs) are produced using a solar reactor working under nitrogen atmosphere. Samples were studied by transmission electron microscopy (TEM), Raman spectroscopy and electron energy loss spectroscopy (EELS). The produced MWNTs exhibit the typical morphologies observed for nitrogen‐doped MWNTs synthesized with other methods and EELS measurements point out the presence of substituted nitrogen within the tubes. The doping level is not uniform and the maximum value reaches 11 at.%.
- Open Access
- 21 April 2001
- Published by ASME International
- p. 465
Heat, Mass and Fluid Flow in a Solar Reactor for Fullerene Synthesis
A 2 kW solar furnace was used to vaporize a graphite target for fullerene synthesis. Tests were performed in a wide range of vaporization rates (0.1–4 g/h), under variable pressure and argon flow rate. Experimental results are interpreted with numerical simulation to define key parameters for large-scale synthesis of fullerenes with solar energy. We demonstrate that the vaporization process is controlled by diffusion in the temperature and pressure ranges 3000–3700 K and 70–250 hPa respectively. Experimental data and numerical simulation suggest that in the solar reactor, fullerene yield is governed by the dilution of carbon vapor in argon and by the temperature gradient in the cooling zone. Criteria for both parameters are suggested. Consequently, these data, combined with the numerical model accounting for heat, mass and fluid flow inside the reactor, may be used for the design of large-scale solar process.
- 21 April 2001
- Published by ASME International
- p. 465
Open AccessHeat, Mass and Fluid Flow in a Solar Reactor for Fullerene Synthesis
A 2 kW solar furnace was used to vaporize a graphite target for fullerene synthesis. Tests were performed in a wide range of vaporization rates (0.1–4 g/h), under variable pressure and argon flow rate. Experimental results are interpreted with numerical simulation to define key parameters for large-scale synthesis of fullerenes with solar energy. We demonstrate that the vaporization process is controlled by diffusion in the temperature and pressure ranges 3000–3700 K and 70–250 hPa respectively. Experimental data and numerical simulation suggest that in the solar reactor, fullerene yield is governed by the dilution of carbon vapor in argon and by the temperature gradient in the cooling zone. Criteria for both parameters are suggested. Consequently, these data, combined with the numerical model accounting for heat, mass and fluid flow inside the reactor, may be used for the design of large-scale solar process.
- 1 January 1999
- Published by AIP Publishing
Solar synthesis of single wall carbon nanotubes
We discuss here the influence of some synthesis parameters in the production of single wall carbon nanotubes (SWNT) with a 2 kW solar furnace at the Odeillo Institute. We first study the specific role of catalysts like nickel or cobalt on the SWNT formation process. SEM and TEM pictures show significant differences in the yield of production and suggest different growth mechanisms. Furthermore, we report Raman spectra for samples produced using lanthanium or sulfur as catalysts. These samples provide very striking results in the low frequency range (in term of distribution in diameter) with a good correlation with the graphite-like modes region.
- 1 January 1999
- Published by AIP Publishing
Solar synthesis of single wall carbon nanotubes
We discuss here the influence of some synthesis parameters in the production of single wall carbon nanotubes (SWNT) with a 2 kW solar furnace at the Odeillo Institute. We first study the specific role of catalysts like nickel or cobalt on the SWNT formation process. SEM and TEM pictures show significant differences in the yield of production and suggest different growth mechanisms. Furthermore, we report Raman spectra for samples produced using lanthanium or sulfur as catalysts. These samples provide very striking results in the low frequency range (in term of distribution in diameter) with a good correlation with the graphite-like modes region.