SWShui-Jinn Wang

Shui-Jinn Wang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Shui-Jinn Wang has a total of 86 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Surface engineered Schottky contact for boosting performance parameters of Al-doped ZnON thin-film transistors

    by Chien-Hung Wu, Srikant Kumar Mohanty, Rong-Ming Ko, Jhong-Han Wu, Shui-Jinn Wang

    In this study, AlZnON thin-film transistors (TFTs) were fabricated by incorporating aluminum into the ZnON semiconductor and further Schottky contact on the surface of the channel is implemented to enhance the electrical and optical performance of the device. The presence of Al in the thin film improves the reliability of the TFT by stabilizing the nitrogen bond. Further, the optical transmittance improved to 90% from 80% and the bandgap increased to 2.48 eV from 1.89 eV with the doping of Al. The effects of the work function and the widths of the Schottky metal contact on the device characteristics are also investigated. The optimum structure is realized with high work function (5.65 eV) platinum (Pt) metal contact which was positioned at the center of the channel and the width of the Schottky contact was 0.25 times the length of the channel. With the encapsulation of this optimum surface-engineered Schottky contact (SESC) in the device, the field effect mobility increased from 27.3 to 43.9 cm2 V−1·s−1, the subthreshold swing reduced from 196 to 113 mV dec−1, threshold voltage changed from −0.13 to 0.12 V and the on–off current ratio improved from 4.13 × 106 to 1.03 × 108. The substantial enhancement of transistor performance is achieved through the utilization of a high-work function metal layer, which generates a larger depletion region in the channel, and by precisely controlling the width of the Schottky contact at the channel’s center, the depletion region is optimized to suppress off-current while maintaining improved field effect mobility. From the above result, it is evident that the proposed SESC in Al-doped ZnON TFT is a promising candidate for next-generation display application.


  • Open Access

    Enhancing photodetection performance of UV photodetectors with stacked Pt/NiO dual capping layers on IGZO thin-film transistors

    by Rong-Ming Ko, Shui-Jinn Wang, Sin-Jhih Huang, Chien-Hung Wu, Wei-Han Chen, Hao-Che Cheng

    This paper proposes a solution to mitigate the trade-off between dark and photocurrents in the indium gallium zinc oxide (IGZO) thin-film transistor (TFT) applications, such as ultraviolet photodetectors, by using a stacked Pt/NiO dual capping layer (CL). The Pt CL forms a Schottky contact with the IGZO channel, which maximizes the depletion width on the channel layer and allows the use of a thicker channel to suppress both dark current and channel resistance. On the other hand, the NiO CL forms a pn heterojunction with the IGZO channel, which provides additional space for generating electron–hole pairs and is forward biased by the photovoltaic voltage under UV irradiation, resulting in a further negative shift in the threshold voltage and a significant increase in photocurrent. Experimental results show that the proposed CL scheme exhibits excellent photoresponsivity, photosensitivity, and specific detectivity in a 40 nm-thick IGZO TFT, with the values of 1888 A/W, 3.37 × 108 A/A, and 3.99 × 1016 Jones, respectively, which are about 55%, 83%, and 68% higher than a traditional 30 nm-thick IGZO TFT using only NiO CL under 275 nm UV irradiation.


  • The use of a multiple roughening scheme to enhance sensing performance of pH sensors with NiO nanosheets/multi-walled carbon nanotubes on KOH-etched Si substrates

    by Yi-Shiang Chang, Shui-Jinn Wang, Rong-Ming Ko, Wen-Rui Hsu

    Sensing electrodes (SEs) fabricated by a multiple surface roughening scheme based on KOH-etched Si substrates with spraying deposited multi-walled carbon nanotubes (MWCNTs) and hydrothermally grown (HTG) NiO nanosheets (NSs) to improve pH sensing performance are demonstrated. A surface area (SA) gain of around 2.31 is obtained from the etched Si substrate, which results in an enhancement in the pH sensitivity of MWCNTs SEs from 52.15 to 54.95 mV pH −1 based on Si substrates without and with KOH etching. Effects of the thermal annealing temperatures and spraying times of the MWCNTs and HTG times of NiO NSs of the proposed NiO NSs/MWCNTs/pyramid-Si SEs on pH sensitivity, hysteresis, and reliability are studied. A near-Nernstian response of 57.56 mV pH −1 is obtained, which could be attributed to the proposed method maximize SA and the number of ion adsorption sites for advancing pH sensing performance.

  • Performance enhancement of a hydrothermally grown ZnO-based ultraviolet photodetector using substrate transfer and pyramid-like surface texture

    by Ying-Chi Hung, Shui-Jinn Wang, Rong-Ming Ko, Sheng-Yi Wang, Bing-Cheng You, Hsiang-Yi Chen, Chun-Kai Liao, Sheng-Tsang Hsiao

    A comparative study of the performance of lateral- and vertical-structured UV photodetectors (PDs) based on a hydrothermally grown (HTG) n-ZnO/sputtered p-CuO heterojunction (HJ) is presented. After substrate transfer (ST) conducted using a sonicating bath process, the vertical-structured UV PD showed a fast response and a 310-fold improvement in light responsivity compared with that of the lateral-structured UV PD under UV illumination (365 nm at 3 mW cm −2 ) at a reverse bias of −1 V. This improvement is attributed to the much shorter conduction path and lake of a seed layer for the vertical structure. With further surface chemical etching of the HTG n-ZnO layer after ST, a pyramid-like surface texture formed and a significantly enhanced UV light response (as high as 943-fold higher) was obtained. The increase in photo-responsivity is due to the removal of the high defect density initial ZnO growth layer and reduced light reflection.


  • Super-Nernstian pH sensors based on WO 3 nanosheets

    by Chao-Yin Kuo, Shui-Jinn Wang, Rong-Ming Ko, Hung-Hao Tseng

    The effects of the surface morphology of hydrothermally grown WO 3 nanosheets (NSs) and sputtering WO 3 film on the performance of pH sensing electrodes are presented and compared in the pH range of 2–12. Using a separated electrode of an extended-gate field-effect transistor (EGFET) configuration, the WO 3 nanosheet (NS) pH sensor shows a sensitivity of 63.37 mV/pH, a good linearity of 0.9973, a low voltage hysteresis of 4.79 mV, and a low drift rate of 3.18 mV/h. In contrast, the film-type one shows a typical sensitivity of only 50.08 mV/pH and a linearity of 0.9932. The super-Nernstian response could be attributed to the significant increase in the number of surface ion adsorption sites of the NS structure and the occurrence of local electric field enhancement over the sharp edges and corners of WO 3 NSs.


  • Hydrothermal growth of n-ZnO films on a patterned p-GaN epilayer and its application in heterojunction light-emitting diodes

    by Rong-Ming Ko, Shui-Jinn Wang, Ching-Yi Chen, Cheng-Han Wu, Yan-Ru Lin, Hsin-Ming Lo

    The hydrothermal growth (HTG) of crystalline n-ZnO films on both the nonpatterned and patterned p-GaN epilayers with a honeycomb array of etched holes is demonstrated, and its application in n-ZnO/p-GaN heterojunction light-emitting diodes (HJ-LEDs) is reported. The results reveal that an HTG n-ZnO film on a patterned p-GaN layer exhibits a high-quality single crystal with FWHMs of 0.463 and 0.983° obtained from a ω-rocking curve and a ϕ-scan pattern, respectively, which are much better than those obtained on a nonpatterned p-GaN layer. In addition, the n-ZnO/patterned p-GaN HJ-LED exhibited a much better rectifying diode behavior owing to having a higher n-ZnO film crystallinity quality and an improved interface with the p-GaN layer. Strong violet and violet-blue lights emitted from the n-ZnO/patterned p-GaN HJ-LED at around 405, 412, and 430 nm were analyzed.


  • Improving source/drain contact resistance of amorphous indium–gallium–zinc-oxide thin-film transistors using an n+-ZnO buffer layer

    by Chien-Hsiung Hung, Shui-Jinn Wang, Chieh Lin, Chien-Hung Wu, Yen-Han Chen, Pang-Yi Liu, Yung-Chun Tu, Tseng-Hsing Lin

    To avoid high temperature annealing in improving the source/drain (S/D) resistance (R DS) of amorphous indium–gallium–zinc-oxide (α-IGZO) thin-film transistors (TFTs) for flexible electronics, a simple and efficient technique using a sputtering-deposited n+-ZnO buffer layer (BL) sandwiched between the S/D electrode and the α-IGZO channel is proposed and demonstrated. It shows that the R DS of α-IGZO TFTs with the proposed n+-ZnO BL is reduced to 8.1 × 103 Ω as compared with 6.1 × 104 Ω of the conventional one. The facilitation of carrier tunneling between the S/D electrode and the α-IGZO channel through the use of the n+-ZnO BL to lower the effective barrier height therein is responsible for the R DS reduction. Effects of the chamber pressure on the carrier concentration of the sputtering-deposited n+-ZnO BL and the thickness of the BL on the degree of improvement in the performance of α-IGZO TFTs are analyzed and discussed.


  • Epitaxial Growth of ZnO Films on Patternedc-Plane GaN Layer Using Hydrothermal Method

    by Rong-Ming Ko, Yan-Ru Lin, Shui-Jinn Wang, Si-Ming Su, Yen-Chieh Huang, Tsung-Hsien Yu

    The growth of epitaxial ZnO film with a c-axis orientation on a patterned GaN/sapphire substrate using a two-step hydrothermal (HT) process is demonstrated. Honeycomb arrays of etched holes were formed on the GaN epilayer to unveil m-plane for the synthesis of ZnO crystallites with a lattice mismatch of 0.4% along c-axis (as compared with that of 1.88% on the c-plane). Effects of the etched pattern and HT processing parameters on the coalescence of hexagonal ZnO prisms are investigated. Experimental results reveal that etched holes with a 5-μm diameter, 3-μm spacing, and an off angle of 30° between the close-packing direction of the honeycomb array and the a-axis (i.e., the direction) of GaN yield ZnO films might be most efficient for the ZnO epitaxy. The successful growth of ZnO single-crystalline films can be attributed to the m-plane of GaN providing nucleation sites with a lower lattice mismatch for the hetero-epitaxy of ZnO crystallites and the propagation of homo-epitaxial lateral growth over c- and m-plane. Material analysis results confirm that the continuous ZnO films grown on the GaN epilayer have high quality and a single-crystalline wurtzite structure, suggesting a high potential for use in the fabrication of ZnO substrates and devices.


  • Open Access

    Improving Crystalline Silicon Solar Cell Efficiency Using Graded-Refractive-Index SiON/ZnO Nanostructures

    by Yung-Chun Tu, Shui-Jinn Wang, Chien-Hung Wu, Kow-Ming Chang, Tseng-Hsing Lin, Chien-Hsiung Hung, Jhen-Siang Wu

    The fabrication of silicon oxynitride (SiON)/ZnO nanotube (NT) arrays and their application in improving the energy conversion efficiency (η) of crystalline Si-based solar cells (SCs) are reported. The SiON/ZnO NT arrays have a graded-refractive-index that varies from 3.5 (Si) to1.9~2.0(Si3N4and ZnO) to1.72~1.75(SiON) to 1 (air). Experimental results show that the use of 0.4 μm long ZnO NT arrays coated with a 150 nm thick SiON film increasesΔη/ηby 39.2% under AM 1.5 G (100 mW/cm2) illumination as compared to that of regular SCs with a Si3N4/micropyramid surface. This enhancement can be attributed to SiON/ZnO NT arrays effectively releasing surface reflection and minimizing Fresnel loss.