Chuen-Jinn Tsai
Research Subjects
Research Interests
Chuen-Jinn Tsai has a total of 3 co-authors. Here are the top co-authors by number of shared publications:
- Hsin-Chung Lu
Dept. of Envir. Engrg. and Health, Hungkuang Inst. of Technol., 34, Chung Chie Rd., 435 Shalu, Taichung, Taiwan.. edu.tw
1 shared publication Shie-Bong Perng
Institute of Environmental Engineering, National Chiao Tung University , Hsinchu , Taiwan
1 shared publicationShin-Fu Chiou
Institute of Environmental Engineering, National Chiao Tung University , Hsinchu , Taiwan
1 shared publication
Latest Publications
- 27 December 2000
- Published by Taylor & Francis in Journal of the Air & Waste Management Association
- Vol. 50 (12) , 2120-2128
Use of Two Different Acidic Aerosol Samplers To Measure Acidic Aerosols in Hsinchu, Taiwan
Acidic aerosol concentrations measured by an annular denuder system (ADS) and a honeycomb denuder system (HDS) in Hsinchu, Taiwan, were compared. Aerosols were also sampled by a MOUDI (micro-orifice uniform deposit impactor) and analyzed by an ion chromatograph to determine the size distributions of different species. Using the measured aerosol size distribution, theoretical analysis showed that positive HNO3 artifact due to volatiliza-tion of NH4NO3 is generally negligible for both samplers.4 3Comparing two different denuder samplers, the average concentration of HNO3 measured by the ADS was found3to be lower than that measured by the HDS, while the difference between the two samplers for the average concentration of other species was found to be within ±15%. A possible cause of the difference in HNO3 con-3centrations is due to a greater loss of HNO3 in the cyclone3 used by the ADS than in the impactor used by the HDS. The study also showed incomplete absorption of the evaporated HCl and HNO3 from the particles on the Teflon3filter by the first nylon filter in the filter pack of the ADS. Collection efficiency and capacity of HCl and HNO3 by3the nylon filters need further investigation.
- 27 December 2000
- Published by Taylor & Francis in Journal of the Air & Waste Management Association
- Vol. 50 (12) , 2120-2128
Use of Two Different Acidic Aerosol Samplers To Measure Acidic Aerosols in Hsinchu, Taiwan
Acidic aerosol concentrations measured by an annular denuder system (ADS) and a honeycomb denuder system (HDS) in Hsinchu, Taiwan, were compared. Aerosols were also sampled by a MOUDI (micro-orifice uniform deposit impactor) and analyzed by an ion chromatograph to determine the size distributions of different species. Using the measured aerosol size distribution, theoretical analysis showed that positive HNO3 artifact due to volatiliza-tion of NH4NO3 is generally negligible for both samplers.4 3Comparing two different denuder samplers, the average concentration of HNO3 measured by the ADS was found3to be lower than that measured by the HDS, while the difference between the two samplers for the average concentration of other species was found to be within ±15%. A possible cause of the difference in HNO3 con-3centrations is due to a greater loss of HNO3 in the cyclone3 used by the ADS than in the impactor used by the HDS. The study also showed incomplete absorption of the evaporated HCl and HNO3 from the particles on the Teflon3filter by the first nylon filter in the filter pack of the ADS. Collection efficiency and capacity of HCl and HNO3 by3the nylon filters need further investigation.
- 1 June 1999
- Published by American Society of Civil Engineers (ASCE) in Journal of Environmental Engineering
- Vol. 125 (6) , 583-591
Influence of Design and Operation Parameters on Bag-Cleaning Performance of Pulse-Jet Baghouse
In this study, a filter test system with clean new fabric bags was used to measure the pulse pressure and acceleration of the filter bag. Fabric acceleration and pulse pressure were used as an index of bag-cleaning intensity. The jet pump curves, which relate the flow rate through the venturi to the average developed pressure by the venturi, were determined by the similar system. The intersection of the jet pump curve and the bag operating line, which relates the pressure drop to flow rate across the bag during pulse-jet cleaning, is the system operating point that was used to predict the average pulse pressure in the bag during pulse-jet cleaning. Experimental results of this study show that a higher pulse pressure can be achieved without the venturi at the top of the bag for bag materials with low resistance coefficient. For bags with higher resistance coefficients, higher pulse pressure is obtained with a venturi installed at the top of the bag. The predicted pressure values are in good agreement with ...
- 1 June 1999
- Published by American Society of Civil Engineers (ASCE) in Journal of Environmental Engineering
- Vol. 125 (6) , 583-591
Influence of Design and Operation Parameters on Bag-Cleaning Performance of Pulse-Jet Baghouse
In this study, a filter test system with clean new fabric bags was used to measure the pulse pressure and acceleration of the filter bag. Fabric acceleration and pulse pressure were used as an index of bag-cleaning intensity. The jet pump curves, which relate the flow rate through the venturi to the average developed pressure by the venturi, were determined by the similar system. The intersection of the jet pump curve and the bag operating line, which relates the pressure drop to flow rate across the bag during pulse-jet cleaning, is the system operating point that was used to predict the average pulse pressure in the bag during pulse-jet cleaning. Experimental results of this study show that a higher pulse pressure can be achieved without the venturi at the top of the bag for bag materials with low resistance coefficient. For bags with higher resistance coefficients, higher pulse pressure is obtained with a venturi installed at the top of the bag. The predicted pressure values are in good agreement with ...