Joseph D. Rouse
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Joseph D. Rouse has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Hiroyuki Sugino
Department of Applied Life Science, Faculty of Engineering, Sojo University. Ikeda, Kumamoto, Japan
2 shared publications Kenji Furukawa
2 shared publicationsMeta Levstek
2 shared publications- Takao Fujii
Department of Applied Life Science, Sojo University, 4-22-1 Ikeda, Nishiku, Kumamoto 860-0082, Japan
2 shared publications - Igor Plazl
University of Ljubljana
1 shared publication - Kenji Furukawa
Graduate School of Science and Technology, Kumamoto University, 2-39-1 Kurokami, Kumamoto 860-8555, Japan
1 shared publication
Latest Publications
- 1 March 2010
- Vol. 57 (1) , 45-51
Estimation of the specific surface area for a porous carrier.
In biofilm systems, treatment performance is primarily dependent upon the available biofilm growth surface area in the reactor. Specific surface area is thus a parameter that allows for making comparisons between different carrier technologies used for wastewater treatment. In this study, we estimated the effective surface area for a spherical, porous polyvinyl alcohol (PVA) gel carrier (Kuraray) that has previously demonstrated effectiveness for retention of autotrophic and heterotrophic biomass. This was accomplished by applying the GPS-X modeling tool (Hydromantis) to a comparative analysis of two moving-bed biofilm reactor (MBBR) systems. One system consisted of a lab-scale reactor that was fed synthetic wastewater under autotrophic conditions where only the nitrification process was studied. The other was a pre-denitrification pilot-scale plant that was fed real, primary-settled wastewater. Calibration of an MBBR process model for both systems indicated an effective specific surface area for PVA gel of 2500 m2/m3, versus a specific surface area of 1000 m2/m3 when only the outer surface of the gel beads is considered. In addition, the maximum specific growth rates for autotrophs and heterotrophs were estimated to be 1.2/day and 6.0/day, respectively.
- 1 March 2010
- Vol. 57 (1) , 45-51
Estimation of the specific surface area for a porous carrier.
In biofilm systems, treatment performance is primarily dependent upon the available biofilm growth surface area in the reactor. Specific surface area is thus a parameter that allows for making comparisons between different carrier technologies used for wastewater treatment. In this study, we estimated the effective surface area for a spherical, porous polyvinyl alcohol (PVA) gel carrier (Kuraray) that has previously demonstrated effectiveness for retention of autotrophic and heterotrophic biomass. This was accomplished by applying the GPS-X modeling tool (Hydromantis) to a comparative analysis of two moving-bed biofilm reactor (MBBR) systems. One system consisted of a lab-scale reactor that was fed synthetic wastewater under autotrophic conditions where only the nitrification process was studied. The other was a pre-denitrification pilot-scale plant that was fed real, primary-settled wastewater. Calibration of an MBBR process model for both systems indicated an effective specific surface area for PVA gel of 2500 m2/m3, versus a specific surface area of 1000 m2/m3 when only the outer surface of the gel beads is considered. In addition, the maximum specific growth rates for autotrophs and heterotrophs were estimated to be 1.2/day and 6.0/day, respectively.
- 1 October 2007
- Published by IWA Publishing in Water Science & Technology
- Vol. 56 (7) , 65-71
Bench-scale study using PVA gel as a biocarrier in a UASB reactor treating corn steep liquor wastewater
PVA-gel beads were used as a biocarrier for treatment of corn steep liquor wastewater containing high levels of volatile fatty acids (VFA), where retention of biomass could be either solely in the porous microstructure of the gel or by granule formation using a gel bead as a nucleus. With stable COD removal efficiencies of 90% or greater, continuous treatment was demonstrated over a four month period, with organic loading rates being increased stepwise from 2.5 to 22.5 kg COD/m3 d. In addition, VFA in the effluent were, with few exceptions maintained close to zero. Gas production increased over the course of the study and reached a level of 0.38 m3/kg COD consisting of 65% methane with the remainder being mostly carbon dioxide. Biomass granules containing methane producing bacteria progressively formed around the PVA-gel beads during the study. In contrast, very few small natural granules developed apart from PVA-gel nuclei indicating that PVA gel may serve well as a seeding material to enhance granulation when natural occurrence is lacking.
- 1 October 2007
- Published by IWA Publishing in Water Science & Technology
- Vol. 56 (7) , 65-71
Bench-scale study using PVA gel as a biocarrier in a UASB reactor treating corn steep liquor wastewater
PVA-gel beads were used as a biocarrier for treatment of corn steep liquor wastewater containing high levels of volatile fatty acids (VFA), where retention of biomass could be either solely in the porous microstructure of the gel or by granule formation using a gel bead as a nucleus. With stable COD removal efficiencies of 90% or greater, continuous treatment was demonstrated over a four month period, with organic loading rates being increased stepwise from 2.5 to 22.5 kg COD/m3 d. In addition, VFA in the effluent were, with few exceptions maintained close to zero. Gas production increased over the course of the study and reached a level of 0.38 m3/kg COD consisting of 65% methane with the remainder being mostly carbon dioxide. Biomass granules containing methane producing bacteria progressively formed around the PVA-gel beads during the study. In contrast, very few small natural granules developed apart from PVA-gel nuclei indicating that PVA gel may serve well as a seeding material to enhance granulation when natural occurrence is lacking.
- 15 September 2007
- Published by Water Environment Federation in Water Practice
- Vol. 1 (4) , 1-6
Oxidation of Excess Organic Sludge from a Moving-bed Biofilm Process
- 15 September 2007
- Published by Water Environment Federation in Water Practice
- Vol. 1 (4) , 1-6
Oxidation of Excess Organic Sludge from a Moving-bed Biofilm Process
- 1 April 2007
- Published by IWA Publishing in Water Science & Technology
- Vol. 55 (8-9) , 135-141
A pilot-plant study of a moving-bed biofilm reactor system using PVA gel as a biocarrier for removals of organic carbon and nitrogen
A pilot-plant study was conducted to evaluate the performance of a moving-bed biofilm reactor process using PVA-gel beads as a biocarrier. Real primary-settled wastewater was fed to the pre-denitrification system and removals of nitrogenous and organic contaminants were evaluated over a 1-year period. The results demonstrated that at a total nitrogen (TN) loading of 18 mg/L.h, a TN removal efficiency in keeping with and even exceeding the theoretical maximum efficiency based on the level of internal recycle, was possible and a nitrification rate of 15 mg/L.h was sustained with a HRT of only 2.5 h at 15 °C. Furthermore, soluble COD and BOD5 in the effluent of the pilot plant were reduced to levels well below most regulatory discharge limits. In addition, the possibility of using this biocarrier in a system, including the elimination of waste organic sludge, was discussed.
- 1 April 2007
- Published by IWA Publishing in Water Science & Technology
- Vol. 55 (8-9) , 135-141
A pilot-plant study of a moving-bed biofilm reactor system using PVA gel as a biocarrier for removals of organic carbon and nitrogen
A pilot-plant study was conducted to evaluate the performance of a moving-bed biofilm reactor process using PVA-gel beads as a biocarrier. Real primary-settled wastewater was fed to the pre-denitrification system and removals of nitrogenous and organic contaminants were evaluated over a 1-year period. The results demonstrated that at a total nitrogen (TN) loading of 18 mg/L.h, a TN removal efficiency in keeping with and even exceeding the theoretical maximum efficiency based on the level of internal recycle, was possible and a nitrification rate of 15 mg/L.h was sustained with a HRT of only 2.5 h at 15 °C. Furthermore, soluble COD and BOD5 in the effluent of the pilot plant were reduced to levels well below most regulatory discharge limits. In addition, the possibility of using this biocarrier in a system, including the elimination of waste organic sludge, was discussed.
- 1 January 2002
- Published by Elsevier in Journal of Bioscience and Bioengineering
- Vol. 94 (5) , 412-418
Characterization of the Microbial Community in an Anaerobic Ammonium-Oxidizing Biofilm Cultured on a Nonwoven Biomass Carrier.
- 1 January 2002
- Published by Elsevier in Journal of Bioscience and Bioengineering
- Vol. 94 (5) , 412-418
Characterization of the Microbial Community in an Anaerobic Ammonium-Oxidizing Biofilm Cultured on a Nonwoven Biomass Carrier.
- 1 January 2001
- Published by Water Environment Federation in Proceedings of the Water Environment Federation
- Vol. 2001 (16) , 84-95
ESTABLISHMENT OF AN ANAEROBIC AMMONIUM-OXIDIZING CULTURE IN CONTINUOUS FLOW TREATMENT WITH NON-WOVEN BIOMASS CARRIER
Acclimation of biofilm cultures treating groundwater in Kumamoto, Japan, capable of anaerobic ammonium oxidation (Anammox) has been ongoing in our...
- 1 January 2001
- Published by Water Environment Federation in Proceedings of the Water Environment Federation
- Vol. 2001 (16) , 84-95
ESTABLISHMENT OF AN ANAEROBIC AMMONIUM-OXIDIZING CULTURE IN CONTINUOUS FLOW TREATMENT WITH NON-WOVEN BIOMASS CARRIER
Acclimation of biofilm cultures treating groundwater in Kumamoto, Japan, capable of anaerobic ammonium oxidation (Anammox) has been ongoing in our...