Abdeslem Fnidiki
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Abdeslem Fnidiki has a total of 17 co-authors. Here are the top co-authors by number of shared publications:
D. Lemarchand
Groupe de Physique des Matériaux, UMR CNRS 6634, Site Universitaire du Madrillet, BP12, 76801 Saint Etienne du Rouvray Cedex, France
3 shared publicationsF. Danoix
Groupe de Physique des Matériaux, UMR CNRS 6634, Site Universitaire du Madrillet, BP12, 76801 Saint Etienne du Rouvray Cedex, France
2 shared publications- Marco Coïsson
INRIM
2 shared publications S. Cazottes
Groupe de Physique des Matériaux, UMR CNRS 6634, Site Universitaire du Madrillet, BP12, 76801 Saint Etienne du Rouvray Cedex, France
2 shared publicationsDany Lemarchand
Groupe de Physique des Matériaux, Université de Rouen, UMR CNRS 6634, Site Universitaire du Madrillet,BP12, 76801 Saint Etienne du Rouvray cedex, France
1 shared publication- Etienne Talbot
Université Rouen, GPM, 76800 Saint Etienne du Rouvray, France
1 shared publication
Latest Publications
- 2 October 2012
- Published by Oxford University Press (OUP) in Microscopy and Microanalysis
- Vol. 18 (5) , 1129-1134
Nanometer Scale Tomographic Investigation of Fine Scale Precipitates in a CuFeNi Granular System by Three-Dimensional Field Ion Microscopy
The microstructure of Cu80Fe10Ni10 (at. %) granular ribbons was investigated by means of three-dimensional field ion microscopy (3D FIM). This ribbon is composed of magnetic precipitates embedded in a nonmagnetic matrix. The magnetic precipitates have a diameter smaller than 5 nm in the as-spun state and are coherent with the matrix. No accurate characterization of such a microstructure has been performed so far. A tomographic characterization of the microstructure of melt spun and annealed Cu80Fe10Ni10 ribbon was achieved with 3D FIM at the atomic scale. A precise determination of the size distribution, number density, and distance between the precipitates was carried out. The mean diameter for the precipitates is 4 nm in the as-spun state. After 2 h at 350°C, there is an increase of the size of the precipitates, while after 2 h at 400°C the mean diameter of the precipitates decreases. Those data were used as inputs in models that describe the magnetic and magnetoresistive properties of this alloy.
- 2 October 2012
- Published by Oxford University Press (OUP) in Microscopy and Microanalysis
- Vol. 18 (5) , 1129-1134
Nanometer Scale Tomographic Investigation of Fine Scale Precipitates in a CuFeNi Granular System by Three-Dimensional Field Ion Microscopy
The microstructure of Cu80Fe10Ni10 (at. %) granular ribbons was investigated by means of three-dimensional field ion microscopy (3D FIM). This ribbon is composed of magnetic precipitates embedded in a nonmagnetic matrix. The magnetic precipitates have a diameter smaller than 5 nm in the as-spun state and are coherent with the matrix. No accurate characterization of such a microstructure has been performed so far. A tomographic characterization of the microstructure of melt spun and annealed Cu80Fe10Ni10 ribbon was achieved with 3D FIM at the atomic scale. A precise determination of the size distribution, number density, and distance between the precipitates was carried out. The mean diameter for the precipitates is 4 nm in the as-spun state. After 2 h at 350°C, there is an increase of the size of the precipitates, while after 2 h at 400°C the mean diameter of the precipitates decreases. Those data were used as inputs in models that describe the magnetic and magnetoresistive properties of this alloy.
- 19 June 2012
- Published by Springer Nature in Journal of Nanoparticle Research
- Vol. 14 (7) , 1-16
Microstructure, magnetic and transport properties of magnetoresistive Cu80Fe x Ni20−x (x = 5, 10 and 15 at.%) ribbons
- 19 June 2012
- Published by Springer Nature in Journal of Nanoparticle Research
- Vol. 14 (7) , 1-16
Microstructure, magnetic and transport properties of magnetoresistive Cu80Fe x Ni20−x (x = 5, 10 and 15 at.%) ribbons
- Open Access
- 14 December 2005
- Published by EDP Sciences in The European Physical Journal Applied Physics
- Vol. 32 (3) , 177-185
Characterization of carbon and iron nanostructures synthesized by the DC arc discharge method: influence of the location in the reactor and of the pressure
X-ray diffraction, Mössbauer spectroscopy, Scanning Electron Microscopy (SEM) and Transmission Electron Microscopy (TEM) techniques were used to characterize the Fe-C phases in the soots synthesized by the DC arc discharge method. Various equilibrium and non-equilibrium Fe-C compounds were identified, with fractions depending on both the location in the reactor and the helium gas pressure. The soots obtained are composed of the same five phases (C-graphite, α-Fe, γ-Fe, Fe3C and Fe5C2) whatever the helium gas pressure and wherever they are situated in the reactor. However, the location in the reactor has a considerable influence on the size of the particles in the nanostructure. The Fe-C compounds in the Pyrex vessel samples (CL) seem only to be present in the form of nanoparticles embedded in an amorphous gangue, while the water-cooled copper cylinder samples (RS) contain, in addition to these nanoparticles, large composite crystalline particles.
- 14 December 2005
- Published by EDP Sciences in The European Physical Journal Applied Physics
- Vol. 32 (3) , 177-185
Open AccessCharacterization of carbon and iron nanostructures synthesized by the DC arc discharge method: influence of the location in the reactor and of the pressure
X-ray diffraction, Mössbauer spectroscopy, Scanning Electron Microscopy (SEM) and Transmission Electron Microscopy (TEM) techniques were used to characterize the Fe-C phases in the soots synthesized by the DC arc discharge method. Various equilibrium and non-equilibrium Fe-C compounds were identified, with fractions depending on both the location in the reactor and the helium gas pressure. The soots obtained are composed of the same five phases (C-graphite, α-Fe, γ-Fe, Fe3C and Fe5C2) whatever the helium gas pressure and wherever they are situated in the reactor. However, the location in the reactor has a considerable influence on the size of the particles in the nanostructure. The Fe-C compounds in the Pyrex vessel samples (CL) seem only to be present in the form of nanoparticles embedded in an amorphous gangue, while the water-cooled copper cylinder samples (RS) contain, in addition to these nanoparticles, large composite crystalline particles.
- 2 December 1998
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms
- Vol. 146 (1) , 244-249
Evidence for recrystallization of amorphous Fe/Tb multilayers under swift ion irradiation
- 2 December 1998
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms
- Vol. 146 (1) , 244-249
Evidence for recrystallization of amorphous Fe/Tb multilayers under swift ion irradiation