Hiroshi Ikuta
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Hiroshi Ikuta has a total of 56 co-authors. Here are the top co-authors by number of shared publications:
- Uichiro Mizutani
Department of Crystalline Materials Science, Nagoya University, Nagoya 464-8603, Japan
7 shared publications Masaaki Yoshikawa
IMRA MATERIAL R&D
4 shared publicationsTetsuo Oka
Aisin Seiki Co., Ltd
4 shared publicationsYoshitaka Itoh
IMRA Material R&D Co., Ltd., Hachiken-cho 5-50, Kariya 448-0021, Japan
4 shared publications- Yoshitaka Itoh
IMRA, Japan
3 shared publications Yousuke Yanagi
IMRA Material R&D Co., Ltd., Hachiken-cho 5-50, Kariya 448-0021, Japan
3 shared publications
Latest Publications
- 1 October 2017
- Published by Elsevier in Journal of Electron Spectroscopy and Related Phenomena
- Vol. 220, 54-57
Superconducting gap of heavily underdoped copper oxide superconductor (Bi,Pb) 2 Sr 2 (Ca,Y)Cu 2 O 8+δ
- 1 October 2017
- Published by Elsevier in Journal of Electron Spectroscopy and Related Phenomena
- Vol. 220, 54-57
Superconducting gap of heavily underdoped copper oxide superconductor (Bi,Pb) 2 Sr 2 (Ca,Y)Cu 2 O 8+δ
- 1 May 2011
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 50 (5R) , 053101
Substrate Dependence of Structural and Transport Properties in FeSe0.5Te0.5Thin Films
In order to clarify the best condition for the growth of iron chalcogenide superconductor thin films, we investigated the effect of the substrate on the transport and structural properties of films. Thin films of FeSe0.5Te0.5 grown by pulsed laser deposition were characterized by DC electrical resistivity, Hall effect, X-ray diffraction measurements, and transmission electron microscopy (TEM) observation. The c-axis length of the FeSe0.5Te0.5 thin films revealed a non-systematic change with the cell constants of the substrates. In the films with poor or no superconductivity, we found the occurrence of oxygen penetration to the film and the formation of amorphous layer between the film and the substrate. The origin of the oxygen penetration and the amorphous layer was the chemical properties of substrate. From the chemical viewpoint, LaAlO3 and MgO substrates were confirmed to be appropriate to grow FeSe0.5Te0.5 films.
- 1 May 2011
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 50 (5R) , 053101
Substrate Dependence of Structural and Transport Properties in FeSe0.5Te0.5Thin Films
In order to clarify the best condition for the growth of iron chalcogenide superconductor thin films, we investigated the effect of the substrate on the transport and structural properties of films. Thin films of FeSe0.5Te0.5 grown by pulsed laser deposition were characterized by DC electrical resistivity, Hall effect, X-ray diffraction measurements, and transmission electron microscopy (TEM) observation. The c-axis length of the FeSe0.5Te0.5 thin films revealed a non-systematic change with the cell constants of the substrates. In the films with poor or no superconductivity, we found the occurrence of oxygen penetration to the film and the formation of amorphous layer between the film and the substrate. The origin of the oxygen penetration and the amorphous layer was the chemical properties of substrate. From the chemical viewpoint, LaAlO3 and MgO substrates were confirmed to be appropriate to grow FeSe0.5Te0.5 films.
- 17 February 2010
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 20 (2) , 66-70
Enhanced Growth Rate of a YBCO Bulk in the Melt-Textured Process Under 1 atm Oxygen Pressure
By the employment of 1 atm oxygen pressure as the growth atmosphere, we report a success in the enhanced growth rate of the melt-textured (MT) YBCO bulk. A well-oriented c -axis single-domain bulk with a size of 42 mm in diameter was fully grown at a high average growth rate of about 0.32 mm/h, which is 1.5 times larger than that in air. It was found that the increased oxygen partial pressure has a profound influence on the MT growth (MTG) for YBCO. The enhanced growth rate can be interpreted by both increased solubility and diffusion coefficient of yttrium in the Ba-Cu-O liquid under high oxygen partial pressure. After oxygenation, single-domain samples were determined to have a sharp superconducting transition temperature at 91.7 K, indicating that the superconductivity of crystals grown under high oxygen pressure does not degrade. Additionally, due to the rapid growth, the trapping effect of Y211 particles becomes predominant. As a result, a relatively more homogeneous distribution of Y211 particles was observed in the Y123 matrix. Finally, the most important advantage of this technique is that the enhanced growth rate of Y123 gives less opportunity from self-nucleation in the liquid, which takes place beyond the growth window and the embryonic period. Thus, this oxygen-increased MTG process is very promising for producing large-sized YBCO bulks with good superconducting properties.
- 17 February 2010
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 20 (2) , 66-70
Enhanced Growth Rate of a YBCO Bulk in the Melt-Textured Process Under 1 atm Oxygen Pressure
By the employment of 1 atm oxygen pressure as the growth atmosphere, we report a success in the enhanced growth rate of the melt-textured (MT) YBCO bulk. A well-oriented c -axis single-domain bulk with a size of 42 mm in diameter was fully grown at a high average growth rate of about 0.32 mm/h, which is 1.5 times larger than that in air. It was found that the increased oxygen partial pressure has a profound influence on the MT growth (MTG) for YBCO. The enhanced growth rate can be interpreted by both increased solubility and diffusion coefficient of yttrium in the Ba-Cu-O liquid under high oxygen partial pressure. After oxygenation, single-domain samples were determined to have a sharp superconducting transition temperature at 91.7 K, indicating that the superconductivity of crystals grown under high oxygen pressure does not degrade. Additionally, due to the rapid growth, the trapping effect of Y211 particles becomes predominant. As a result, a relatively more homogeneous distribution of Y211 particles was observed in the Y123 matrix. Finally, the most important advantage of this technique is that the enhanced growth rate of Y123 gives less opportunity from self-nucleation in the liquid, which takes place beyond the growth window and the embryonic period. Thus, this oxygen-increased MTG process is very promising for producing large-sized YBCO bulks with good superconducting properties.
- 15 July 2009
- Published by Physical Society of Japan in Journal of the Physical Society of Japan
- Vol. 78 (7) , 73701
Effect of L n -Site Disorder on T c of Oxypnictide Superconductor L n FeAsO 1- x F x ( L n =Nd, Ce–Gd, and La–Dy)
- 15 July 2009
- Published by Physical Society of Japan in Journal of the Physical Society of Japan
- Vol. 78 (7) , 73701
Effect of L n -Site Disorder on T c of Oxypnictide Superconductor L n FeAsO 1- x F x ( L n =Nd, Ce–Gd, and La–Dy)
- 15 July 2008
- Published by Physical Society of Japan in Journal of the Physical Society of Japan
- Vol. 77 (7)
Origin of the Anomalously Strong Influence of Out-of-Plane Disorder on High-TcSuperconductivity
The electronic structure of Bi2Sr2-xRxCuOy(R=La, Eu) near the (pi,0) point of the first Brillouin zone was studied by means of angle-resolved photoemission spectroscopy (ARPES). The temperature T* above which the pseudogap structure in the ARPES spectrum disappears was found to have an R dependence that is opposite to that ofthe superconducting transition temperature Tc. This indicates that the pseudogap state is competing with high-Tc superconductivity, and the large Tc suppression observed with increasing the out-of-plane disorder is due to the stabilization of the pseudogap state.
- 15 July 2008
- Published by Physical Society of Japan in Journal of the Physical Society of Japan
- Vol. 77 (7)
Origin of the Anomalously Strong Influence of Out-of-Plane Disorder on High-TcSuperconductivity
The electronic structure of Bi2Sr2-xRxCuOy(R=La, Eu) near the (pi,0) point of the first Brillouin zone was studied by means of angle-resolved photoemission spectroscopy (ARPES). The temperature T* above which the pseudogap structure in the ARPES spectrum disappears was found to have an R dependence that is opposite to that ofthe superconducting transition temperature Tc. This indicates that the pseudogap state is competing with high-Tc superconductivity, and the large Tc suppression observed with increasing the out-of-plane disorder is due to the stabilization of the pseudogap state.
- 9 December 2004
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 43 (12) , 8208-8212
Thermoelectric Properties ofAn+2Con+1O3n+3(A=Ca, Sr, Ba,n=1–5)
- 9 December 2004
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 43 (12) , 8208-8212
Thermoelectric Properties ofAn+2Con+1O3n+3(A=Ca, Sr, Ba,n=1–5)
- 1 January 2004
- Published by Japan Society of Mechanical Engineers in The Proceedings of Conference of Tokai Branch
- Vol. 2004.53, 57-58
Development of superconducting strong magnetic field generators
総合学術電子ジャーナルサイト「J-STAGE」-国内で発行された学術論文全文を読むことのできる、日本最大級の総合電子ジャーナルプラットフォームです。
- 1 January 2004
- Published by Japan Society of Mechanical Engineers in The Proceedings of Conference of Tokai Branch
- Vol. 2004.53, 57-58
Development of superconducting strong magnetic field generators
総合学術電子ジャーナルサイト「J-STAGE」-国内で発行された学術論文全文を読むことのできる、日本最大級の総合電子ジャーナルプラットフォームです。
- 28 April 2003
- Published by AIP Publishing in Applied Physics Letters
- Vol. 82 (17) , 2850-2852
Magnetic confinement of weakly ionized plasma with superconducting bulk magnets
This letter describes the application of single-domain superconducting bulk magnets as a plasma confinement. A through-hole was drilled at the center of a Sm123 bulk superconductor of 39 mm diameter and 17 mm thickness. When the sample was field cooled to 77 K, the resulting bulk magnet trapped a magnetic field of ∼0.65 T called a magnetic mirror, in the bore of the hole. The magnet was applied to a weakly ionized neon plasma column. Both the magnet and discharge glass tube were immersed in liquid nitrogen. The spatial distribution in the tube of red fluorescence of the plasma showed that the magnet certainly confined the plasma. These results would provide a clue to applications of the compact magnet of strong magnetic field.
- 28 April 2003
- Published by AIP Publishing in Applied Physics Letters
- Vol. 82 (17) , 2850-2852
Magnetic confinement of weakly ionized plasma with superconducting bulk magnets
This letter describes the application of single-domain superconducting bulk magnets as a plasma confinement. A through-hole was drilled at the center of a Sm123 bulk superconductor of 39 mm diameter and 17 mm thickness. When the sample was field cooled to 77 K, the resulting bulk magnet trapped a magnetic field of ∼0.65 T called a magnetic mirror, in the bore of the hole. The magnet was applied to a weakly ionized neon plasma column. Both the magnet and discharge glass tube were immersed in liquid nitrogen. The spatial distribution in the tube of red fluorescence of the plasma showed that the magnet certainly confined the plasma. These results would provide a clue to applications of the compact magnet of strong magnetic field.
- 1 January 2003
- Published by Japan Society of Mechanical Engineers in The proceedings of the JSME annual meeting
- Vol. 2003.1, 465-466
Development of a Sputtering Cathode Using a Superconducting Bulk Magnet
We fabricated large single-domain Sm-Ba-Cu-O bulk superconductors 60mm in diameter, which can trap magnetic fields exceeding 2 T at 77 K. We have proposed the construction of a superconducting bulk magnet (SBM) system by using the extremely powerful bulk superconductor cooled by a refrigerator. As one of promising applications, we have constructed a magnetron sputtering device by replacing a conventional Nd-Fe-B permanent magnet with an SBM. In our system, the magnetic field parallel to the target surface reached 0.6 T, which is more than ten times stronger than that of a conventional magnetron cathode. This strong magnet field enabled us to deposit films from various targets including a 3mm thick Fe at pressures lower than 1×(10)^<-2> Pa. To the best of our knowledge, the present magnetron sputtering is the only one which can be operated under such a low pressure range. For example, plasma damage-free films can be prepared by extending the target to substrate distance to 30-50cm, since the mean free path of sputtered particles becomes so long that they can reach the substrate without involving repeated collisions during their flight.
- 1 January 2003
- Published by Japan Society of Mechanical Engineers in The proceedings of the JSME annual meeting
- Vol. 2003.1, 465-466
Development of a Sputtering Cathode Using a Superconducting Bulk Magnet
We fabricated large single-domain Sm-Ba-Cu-O bulk superconductors 60mm in diameter, which can trap magnetic fields exceeding 2 T at 77 K. We have proposed the construction of a superconducting bulk magnet (SBM) system by using the extremely powerful bulk superconductor cooled by a refrigerator. As one of promising applications, we have constructed a magnetron sputtering device by replacing a conventional Nd-Fe-B permanent magnet with an SBM. In our system, the magnetic field parallel to the target surface reached 0.6 T, which is more than ten times stronger than that of a conventional magnetron cathode. This strong magnet field enabled us to deposit films from various targets including a 3mm thick Fe at pressures lower than 1×(10)^<-2> Pa. To the best of our knowledge, the present magnetron sputtering is the only one which can be operated under such a low pressure range. For example, plasma damage-free films can be prepared by extending the target to substrate distance to 30-50cm, since the mean free path of sputtered particles becomes so long that they can reach the substrate without involving repeated collisions during their flight.