Uichiro Mizutani
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Uichiro Mizutani has a total of 57 co-authors. Here are the top co-authors by number of shared publications:
- Hiroshi Ikuta
Department of Crystalline Materials Science, Nagoya University, Nagoya 464-8603
7 shared publications - Tsunehiro Takeuchi
Nagoya University
7 shared publications Hirokazu Sato
3 shared publicationsMasaaki Yoshikawa
IMRA MATERIAL R&D
3 shared publicationsTetsuo Oka
Aisin Seiki Co., Ltd
3 shared publicationsToshiharu Fukunaga
Ddag Department of Physics, Aichi University of Education, Kariya-shi, Aichi-ken 448-8542, Japan
3 shared publications
Latest Publications
- 6 June 2008
- Published by Elsevier in Physica C: Superconductivity and its Applications
- Vol. 468 (15-20) , 1456-1460
Fabrication of Mo/Si multilayer mirrors for extreme ultraviolet lithography by means of superconducting bulk magnet magnetron sputtering
- 6 June 2008
- Published by Elsevier in Physica C: Superconductivity and its Applications
- Vol. 468 (15-20) , 1456-1460
Fabrication of Mo/Si multilayer mirrors for extreme ultraviolet lithography by means of superconducting bulk magnet magnetron sputtering
- 1 January 2007
- Published by Springer Nature in MRS Proceedings
- Vol. 1048
Stability of the Pd-Co-Ni-Cu-P Metallic Glasses
- 1 January 2007
- Published by Springer Nature in MRS Proceedings
- Vol. 1048
Stability of the Pd-Co-Ni-Cu-P Metallic Glasses
- 21 January 2006
- Published by Taylor & Francis in Philosophical Magazine
- Vol. 86 (3-5) , 645-654
The Hume–Rothery electron concentration rule for a series of gamma-brasses studied by full-potential linearized augmented plane wave (FLAPW)
A theoretical interpretation of the Hume–Rothery electron concentration rule has been attempted by performing full-potential linearized augmented plane wave (FLAPW) band calculations for a series of gamma-brasses: Cu5Zn8, Cu9Al4 and TM2Zn11 (TM = Ni, Pd, Co and Fe). The Fourier spectrum of the FLAPW wavefunction was evaluated for states at point N on the set of {110} zone planes of the reduced bcc Brillouin zone at energy eigenvalues sustaining the pseudogap. It turned out that electrons near the Fermi level resonate with periodic potentials due to {330} and {411} lattice planes to open the pseudogap for all gamma-brasses studied. The effective electron per atom ratio (e/a) was evaluated by averaging the wave vector 2(k i + G) having the largest Fourier component of the FLAPW wavefunction at energy E over selected electronic states k i in the Brillouin zone, with subsequent construction of the dispersion relation E versus in the extended zone scheme. The e/a value proved to be close to e/a = 21/13 = 1.62, the value empirically assigned for the gamma-brass in the Hume–Rothery electron concentration rule, for Cu5Zn8, Cu9Al4, Ni2Zn11 and Pd2Zn11, but to be as small as 1.43 and 1.31 for Co2Zn11 and Fe2Zn11, respectively.
- 21 January 2006
- Published by Taylor & Francis in Philosophical Magazine
- Vol. 86 (3-5) , 645-654
The Hume–Rothery electron concentration rule for a series of gamma-brasses studied by full-potential linearized augmented plane wave (FLAPW)
A theoretical interpretation of the Hume–Rothery electron concentration rule has been attempted by performing full-potential linearized augmented plane wave (FLAPW) band calculations for a series of gamma-brasses: Cu5Zn8, Cu9Al4 and TM2Zn11 (TM = Ni, Pd, Co and Fe). The Fourier spectrum of the FLAPW wavefunction was evaluated for states at point N on the set of {110} zone planes of the reduced bcc Brillouin zone at energy eigenvalues sustaining the pseudogap. It turned out that electrons near the Fermi level resonate with periodic potentials due to {330} and {411} lattice planes to open the pseudogap for all gamma-brasses studied. The effective electron per atom ratio (e/a) was evaluated by averaging the wave vector 2(k i + G) having the largest Fourier component of the FLAPW wavefunction at energy E over selected electronic states k i in the Brillouin zone, with subsequent construction of the dispersion relation E versus in the extended zone scheme. The e/a value proved to be close to e/a = 21/13 = 1.62, the value empirically assigned for the gamma-brass in the Hume–Rothery electron concentration rule, for Cu5Zn8, Cu9Al4, Ni2Zn11 and Pd2Zn11, but to be as small as 1.43 and 1.31 for Co2Zn11 and Fe2Zn11, respectively.
- 1 January 2006
- Published by Japan Society of Powder and Powder Metallurgy in Journal of the Japan Society of Powder and Powder Metallurgy
- Vol. 53 (1) , 107-110
Electronic Structure of Zr-TM-Al (TM=Ni, Cu) Bulk Metallic Glasses
- 1 January 2006
- Published by Japan Society of Powder and Powder Metallurgy in Journal of the Japan Society of Powder and Powder Metallurgy
- Vol. 53 (1) , 107-110
Electronic Structure of Zr-TM-Al (TM=Ni, Cu) Bulk Metallic Glasses
- 9 December 2004
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 43 (12) , 8208-8212
Thermoelectric Properties ofAn+2Con+1O3n+3(A=Ca, Sr, Ba,n=1–5)
- 9 December 2004
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 43 (12) , 8208-8212
Thermoelectric Properties ofAn+2Con+1O3n+3(A=Ca, Sr, Ba,n=1–5)
- 30 July 2004
- Published by American Physical Society (APS) in Physical Review B
- Vol. 70 (2) , 024210
Orbital hybridizations versus the Fermi surface–Brillouin zone interaction in strongly hybridizing approximantThe origin of a deep pseudogap existing at the Fermi level in the approximant was studied from two different points of view of orbital hybridizations and the Fermi surface–Brillouin zone interaction. The first-principle band calculations were performed in the framework of the linear muffin-tin orbital-atomic sphere approximation (LMTO-ASA) and the nearly free electron (NFE) model. The orbital hybridization between the nearest neighbor atoms, on one hand, is shown to give rise to splitting into bonding and antibonding states across . The Fermi surface–Brillouin zone interaction, on the other hand, is studied by calculating the local density of states (LDOS) in an element in the space in the periodic zone scheme and subsequently by integrating them over a given zone plane. By examining carefully how the pseudogap develops on the zone plane, we are led to conclude that successive zones are not independent of each other but are strongly coupled to produce the pseudogap. The coupling of zones was studied in the 1061- and 1505-wave approximations in the NFE model, both being accurate enough to reproduce the electronic structure derived from LMTO-ASA. Encouraged by this success, we studied the effect of each zone on the pseudogap by deleting its form factor in the NFE model. We found the pseudogap to disappear almost completely in the following two cases: one, the elimination of , zones, which is consistent with the prediction from the empirical Hume-Rothery matching rule, and the second all zones below , where represents the set of Miller indices of the lattice planes. A localized charge density due to the hybridizations between neighboring atoms is heavily destroyed, when these two sets of form factors are forced to zero.- 30 July 2004
- Published by American Physical Society (APS) in Physical Review B
- Vol. 70 (2) , 024210
Orbital hybridizations versus the Fermi surface–Brillouin zone interaction in strongly hybridizing approximantThe origin of a deep pseudogap existing at the Fermi level in the approximant was studied from two different points of view of orbital hybridizations and the Fermi surface–Brillouin zone interaction. The first-principle band calculations were performed in the framework of the linear muffin-tin orbital-atomic sphere approximation (LMTO-ASA) and the nearly free electron (NFE) model. The orbital hybridization between the nearest neighbor atoms, on one hand, is shown to give rise to splitting into bonding and antibonding states across . The Fermi surface–Brillouin zone interaction, on the other hand, is studied by calculating the local density of states (LDOS) in an element in the space in the periodic zone scheme and subsequently by integrating them over a given zone plane. By examining carefully how the pseudogap develops on the zone plane, we are led to conclude that successive zones are not independent of each other but are strongly coupled to produce the pseudogap. The coupling of zones was studied in the 1061- and 1505-wave approximations in the NFE model, both being accurate enough to reproduce the electronic structure derived from LMTO-ASA. Encouraged by this success, we studied the effect of each zone on the pseudogap by deleting its form factor in the NFE model. We found the pseudogap to disappear almost completely in the following two cases: one, the elimination of , zones, which is consistent with the prediction from the empirical Hume-Rothery matching rule, and the second all zones below , where represents the set of Miller indices of the lattice planes. A localized charge density due to the hybridizations between neighboring atoms is heavily destroyed, when these two sets of form factors are forced to zero.- 1 January 2004
- Published by Japan Society of Mechanical Engineers in The Proceedings of Conference of Tokai Branch
- Vol. 2004.53, 57-58
Development of superconducting strong magnetic field generators
総合学術電子ジャーナルサイト「J-STAGE」-国内で発行された学術論文全文を読むことのできる、日本最大級の総合電子ジャーナルプラットフォームです。
- 1 January 2004
- Published by Japan Society of Mechanical Engineers in The Proceedings of Conference of Tokai Branch
- Vol. 2004.53, 57-58
Development of superconducting strong magnetic field generators
総合学術電子ジャーナルサイト「J-STAGE」-国内で発行された学術論文全文を読むことのできる、日本最大級の総合電子ジャーナルプラットフォームです。
- 28 April 2003
- Published by AIP Publishing in Applied Physics Letters
- Vol. 82 (17) , 2850-2852
Magnetic confinement of weakly ionized plasma with superconducting bulk magnets
This letter describes the application of single-domain superconducting bulk magnets as a plasma confinement. A through-hole was drilled at the center of a Sm123 bulk superconductor of 39 mm diameter and 17 mm thickness. When the sample was field cooled to 77 K, the resulting bulk magnet trapped a magnetic field of ∼0.65 T called a magnetic mirror, in the bore of the hole. The magnet was applied to a weakly ionized neon plasma column. Both the magnet and discharge glass tube were immersed in liquid nitrogen. The spatial distribution in the tube of red fluorescence of the plasma showed that the magnet certainly confined the plasma. These results would provide a clue to applications of the compact magnet of strong magnetic field.
- 28 April 2003
- Published by AIP Publishing in Applied Physics Letters
- Vol. 82 (17) , 2850-2852
Magnetic confinement of weakly ionized plasma with superconducting bulk magnets
This letter describes the application of single-domain superconducting bulk magnets as a plasma confinement. A through-hole was drilled at the center of a Sm123 bulk superconductor of 39 mm diameter and 17 mm thickness. When the sample was field cooled to 77 K, the resulting bulk magnet trapped a magnetic field of ∼0.65 T called a magnetic mirror, in the bore of the hole. The magnet was applied to a weakly ionized neon plasma column. Both the magnet and discharge glass tube were immersed in liquid nitrogen. The spatial distribution in the tube of red fluorescence of the plasma showed that the magnet certainly confined the plasma. These results would provide a clue to applications of the compact magnet of strong magnetic field.
- 1 January 2003
- Published by Japan Society of Mechanical Engineers in The proceedings of the JSME annual meeting
- Vol. 2003.1, 465-466
Development of a Sputtering Cathode Using a Superconducting Bulk Magnet
We fabricated large single-domain Sm-Ba-Cu-O bulk superconductors 60mm in diameter, which can trap magnetic fields exceeding 2 T at 77 K. We have proposed the construction of a superconducting bulk magnet (SBM) system by using the extremely powerful bulk superconductor cooled by a refrigerator. As one of promising applications, we have constructed a magnetron sputtering device by replacing a conventional Nd-Fe-B permanent magnet with an SBM. In our system, the magnetic field parallel to the target surface reached 0.6 T, which is more than ten times stronger than that of a conventional magnetron cathode. This strong magnet field enabled us to deposit films from various targets including a 3mm thick Fe at pressures lower than 1×(10)^<-2> Pa. To the best of our knowledge, the present magnetron sputtering is the only one which can be operated under such a low pressure range. For example, plasma damage-free films can be prepared by extending the target to substrate distance to 30-50cm, since the mean free path of sputtered particles becomes so long that they can reach the substrate without involving repeated collisions during their flight.
- 1 January 2003
- Published by Japan Society of Mechanical Engineers in The proceedings of the JSME annual meeting
- Vol. 2003.1, 465-466
Development of a Sputtering Cathode Using a Superconducting Bulk Magnet
We fabricated large single-domain Sm-Ba-Cu-O bulk superconductors 60mm in diameter, which can trap magnetic fields exceeding 2 T at 77 K. We have proposed the construction of a superconducting bulk magnet (SBM) system by using the extremely powerful bulk superconductor cooled by a refrigerator. As one of promising applications, we have constructed a magnetron sputtering device by replacing a conventional Nd-Fe-B permanent magnet with an SBM. In our system, the magnetic field parallel to the target surface reached 0.6 T, which is more than ten times stronger than that of a conventional magnetron cathode. This strong magnet field enabled us to deposit films from various targets including a 3mm thick Fe at pressures lower than 1×(10)^<-2> Pa. To the best of our knowledge, the present magnetron sputtering is the only one which can be operated under such a low pressure range. For example, plasma damage-free films can be prepared by extending the target to substrate distance to 30-50cm, since the mean free path of sputtered particles becomes so long that they can reach the substrate without involving repeated collisions during their flight.