YAYann Aman

Yann Aman

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Yann Aman has a total of 2 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Spark Plasma Sintering Kinetics of Pure α‐Alumina

    by Yann Aman, Vincent Garnier, Elisabeth Djurado

    The microstructure development of sintered alumina at different stages in the spark plasma sintering process has been investigated. Based on classical kinetics laws and adapted Coble creep models of hot pressing, the densification and grain growth kinetics were analyzed as a function of various parameters such as heating rate, sintering temperature, and dwell duration. It is found that sintering kinetics are greatly influenced by heating rates. The local temperature gradients at interparticle contacts during high heating rate can be from three to 10 times higher than in low heating rate cycles. Plastic yield might lead to instantaneous densification at an early stage of sintering. However, grain‐boundary diffusion probably dominates at low heating rate whereas grain coarsening, in respect of thermal equilibrium establishment, is unavoidable with high heating rate during the initial‐stage sintering at low temperatures. During the final‐stage sintering, fast grain growth mechanisms such as surface diffusion and pore‐controlled grain‐boundary migration may dominate over densification controlled by grain‐boundary sliding or lattice diffusion. The grain size–density trajectory corroborates that low heating rate is much favorable to achieve near full density with fine grain size at low sintering temperatures.


  • A Screening Design Approach for the Understanding of Spark Plasma Sintering Parameters: A Case of Translucent Polycrystalline Undoped Alumina

    by Yann Aman, Vincent Garnier, Elisabeth Djurado

    An experimental screening design was used to evaluate the effects of spark plasma sintering (SPS) parameters such as heating rate, sintering temperature, dwell duration, and green‐shaping processing on the relative density, grain size, and the optical properties of polycrystalline alumina (PCA). It is shown that heating rate and sintering temperature are the most critical factors for the densification of PCA during SPS. Green‐shaping processing could prevent grain growth at low SPS sintering temperatures. No predominant SPS parameters are observed on the optical properties. Hence, the optical properties of PCA are controlled by microstructural evolution during the SPS process.