LWLarry Weber

Larry Weber

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Larry Weber has a total of 54 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Monitoring Phosphorus During High Flows: Critical for Implementing Surrogacy Models

    by Elliot S. Anderson, Keith E. Schilling, Larry J. Weber

    Phosphorus (P) is a problematic waterborne pollutant, and considerable efforts have been taken to monitor its presence and transport in locales struggling with eutrophication. Most historical P datasets consist of intermittent grab samples, necessitating the construction of surrogacy models to explore P at high resolutions. In Iowa, models using historical data to relate turbidity to particulate P (PartP) have successfully been created. However, it is unknown how comprehensively historical datasets reflect Iowa’s hydrologic conditions and how well these models perform during flows not well represented within the existing data. In this study, we analyzed historical P datasets from 16 major Iowa rivers to determine how well they captured the rivers’ full range of streamflow conditions. While these datasets contained sufficient samples during low and average flows, they typically under-sampled high flows—containing few values above the 85–95th percentiles. Therefore, we collected new data in each river during wet conditions, with ~300 samples taken from 2021 to 2024. These new sampling results largely aligned with the existing surrogacy models and slightly improved model performance, suggesting that utilizing turbidity to predict PartP is appropriate in nearly all streamflow conditions. These findings may prove consequential for robustly modeling PartP due to its dynamic nature and disproportionately high transport during wet weather events.


  • Open Access

    Iowa’s Annual Phosphorus Budget: Quantifying the Inputs and Outputs of Phosphorus Transport Processes

    by Elliot Anderson, Keith Schilling, Christopher Jones, Larry Weber, Calvin Wolter

    Phosphorus (P) plays an integral part in Iowa’s economic and environmental activities through its role as an essential nutrient and waterborne pollutant. However, the amount of phosphorus transported through these activities has not been well quantified. This study estimates the annual mass of P entering and exiting Iowa’s landscape from 1998 to 2022 through seven transport pathways. Four input pathways (fertilizer application, manure production, industrial sources, and human sources) and three output pathways (harvesting, livestock grazing, and stream export) were quantified using various agricultural, economic, and water quality datasets. We also estimated the total mass of P present in the top 0.61 m layer of Iowa’s landscape using results from a statewide soil sampling survey. The harvest component was the largest, with annual values consistently above 200 million kg. This was followed by the fertilizer and manure components, with annual values near 100 million kg. The other components were much smaller; the mean grazing and stream export values were 15 and 19 million kg, respectively, and human and industrial sources were less than 4 million kg. Stream export was the most dynamic pathway, with the largest coefficient of variation (0.59). The net P budget (inputs–outputs) was negative in 20 of the 25 years assessed, indicating that Iowa typically runs a P deficit. A trend analysis revealed that the manure, human, industry, and harvesting components increased across the 1998–2022 period while the grazing component decreased. The mass of P in Iowa’s top layer of soil was 81.5 billion kg—orders of magnitude larger than any individual budget component. This analysis provides a new perspective on P transport pathways in Iowa and may help inform policymakers as they make decisions on the many activities involving P.


  • Open Access

    Assessment of Spatial Nitrate Patterns in An Eastern Iowa Watershed Using Boat-Deployed Sensors

    by Matthew J. Meulemans, Christopher S. Jones, Keith E. Schilling, Nathan C. Young, Larry J. Weber

    Water quality sensors deployed on boats, buoys, and fixed monitoring stations along rivers allow high frequency monitoring at dense spatial and temporal resolutions. Research characterizing nitrate (NO3–N) delivery along extended reaches of navigable rivers, however, is sparse. Since land use and stream biogeochemistry can vary within agricultural watersheds, identifying detailed spatial patterns of stream NO3–N can help identify source area contributions that can be used to develop strategies for water quality improvement. Identifying spatial patterns is especially critical in agricultural watersheds that span multiple landscapes and have dynamic hydrological regimes. We developed and tested a new method that quantifies NO3–N delivery to streams at a high spatial resolution by continuously measuring stream NO3–N using a boat-deployed sensor. Traveling up the Iowa and Cedar Rivers (located within agricultural Upper Mississippi River Basin) and their major tributaries with the system, we automatically measured NO3–N concentrations every 15 s during four excursions spanning the months of May to August, 2018, and characterized stream NO3–N both laterally and longitudinally in river flow. Iowa River NO3–N concentrations were highest nearest the headwaters and gradually declined as the river flowed toward the Mississippi River. Conversely, Cedar River NO3–N concentrations increased from the headwaters toward the mid-watershed areas due to elevated NO3–N delivery from tributaries of the Middle Cedar River; NO3–N concentrations declined in the lower reaches. Our results confirm that NO3–N mitigation efforts should focus on level and intensely-farmed subwatersheds. Data collected with our sensor system compliments permanently deployed sensors and provides an option to support NO3–N removal efforts.


  • Spillway jet regime and total dissolved gas prediction with a multiphase flow model

    by Yushi Wang, Marcela Politano, Larry Weber

    A numerical model, based on the open source code OpenFOAM, was developed to predict jet regimes and total dissolved gas downstream of spillways. The model utilizes the volume of fluid method to track the interface between air and water. A detached eddy simulation model is used for turbulence closure. Transport and dissolution of bubbles are predicted using an Eulerian approach. A bubble number density equation was implemented to predict bubble size changes caused by dissolution and compression. Total dissolved gas was computed using a transport equation that includes the mass transfer between bubbles and water. The model simultaneously captured spillway jet regimes and distribution of total dissolved gas in a spillway sectional model of McNary Dam. Model parameters, gas volume fraction and bubble size at the entrainment region, were calibrated to match total dissolved gas measured in the field under different dam operations.


  • Open Access

    Evaluating the Timing and Interdependence of Hydrologic Processes at the Watershed Scale Based on Continuously Monitored Data

    by Antonio Arenas, Keith Schilling, James Niemeier, Larry Weber

    A quantitative understanding of the interplay between the different components of the hydrologic cycle at the watershed scale can be gained from analyzing high-frequency hydrologic time series. High-frequency measurements of precipitation, soil water content, shallow groundwater, and streamflow were collected and analyzed in Otter Creek, a 122 km2 watershed located in Northeast Iowa, USA. For selected rainfall events occurring in 2014, it was found that there is at least 4 h of delay between soil water content and water table time series response and streamflow peak. This is true even when the water table was approximately 6.5 m below the ground surface before rainfall started. Data reveal a strong linear dependence between the soil water content and the water table, which suggests the existence of a capillary fringe that extends approximately 2.5 m above the water table. The highest streamflow values in Otter Creek occurred when both the water table was close to the ground surface and the near surface soil (top 65 cm) was close to full saturation. Analyses show that, in the study area, data on depth to water table or deep soil water content have the potential to play a key role in the development of a flood warning system. The transformation of rainfall into streamflow is a complex process that we simplified in this study. Additional analyses using physically based coupled surface-subsurface models or non-linear or stochastic models are recommended for more rigorous analysis.


  • The Iowa Watersheds Project: Iowa's prototype for engaging communities and professionals in watershed hazard mitigation

    by Larry J. Weber, Marian Muste, A. Allen Bradley, Antonio Arenas Amado, Ibrahim Demir, Chad W. Drake, Witold F. Krajewski, Tony J. Loeser, Marcela S. Politano, Breanna R. Shea, et al.

    After more than a century of intensive changes in the state's agricultural watersheds, repeated record floods motivated Iowa to innovate in its flood recovery and disaster mitigation efforts following the 2008 floods. The state created the Iowa Flood Center (IFC) and authorized the creation of Watershed Management Authorities. With enhanced funding from the federal government for disaster recovery, the groups collaborated in four watersheds as part of the Iowa Watersheds Project. The Watershed Management Authorities brought together governmental organizations and local stakeholders, developed watershed plans, defined potential flood and nutrient reduction projects, identified willing landowners for project locations in one subwatershed, and hired consultants to design and build the projects. The IFC coordinated efforts across the four watershed areas, provided hydrologic assessments for each, carried out monitoring and modelling to evaluate the performance of all the constructed projects, and developed water resources information systems to support ongoing activities. The Iowa Watersheds Project adopted a watershed systems approach, and the resulting synergy between engaged communities and technical professionals demonstrates avenues for implementing elements of an Integrated Water Resources Management framework in a highly decentralized setting.


  • Hydrodynamic modeling of juvenile mussel dispersal in a large river: the potential effects of bed shear stress and other parameters

    by Joseph A. Daraio, Larry J. Weber, Teresa J. Newton

    Because unionid mussels have a parasitic larval stage, they are able to disperse upstream and downstream as larvae while attached to their host fish and with flow as juveniles after excystment from the host. Understanding unionid population ecology requires knowledge of the processes that affect juvenile dispersal prior to establishment. We examined presettlement (transport and dispersion with flow) and early postsettlement (bed shear stress) hydraulic processes as negative censoring mechanisms. Our approach was to model dispersal using particle tracking through a 3-dimensional flow field output from hydrodynamic models of a reach of the Upper Mississippi River. We tested the potential effects of bed shear stress (τb) at 5 flow rates on juvenile mussel dispersal and quantified the magnitude of these effects as a function of flow rate. We explored the reach-scale relationships of Froude number (Fr), water depth (H), local bed slope (S), and unit stream power (QS) with the likelihood of juvenile set...


  • 3D Calculations of Equilibrium Conditions in Loose-Bed Open Channels with Significant Suspended Sediment Load

    by J. Zeng, G. Constantinescu, L. Weber

    The flow, sediment transport, and bathymetry at equilibrium conditions in loose-bed open channels are predicted using a fully three-dimensional (3D) Reynolds-Averaged Navier-Stokes model that was validated for cases in which the bed-load transport is dominant. The paper focuses on two test cases corresponding to laboratory experiments performed in an S-shaped channel in which the suspended sediment load is comparable to the bed load. A modified version of the original model that accounts for gravitational force effects due to the total sediment load is proposed. It is shown that the way bed-slope effects are accounted for plays a major role in improving the predictive capabilities of the model for a case in which the equilibrium bathymetry is characterized by relatively large values and sharp variations of the transverse slope. The model is then used to qualitatively and quantitatively analyze the distributions of several flow variables that are difficult to measure in the laboratory. They include the distributions of the bed-shear stress and of a Chezy-type friction coefficient assumed to be constant by most lower-order (e.g., two-dimensional depth-averaged) models.


  • Study of the Free Surface Flow on an Ogee-Crested Fish Bypass

    by Cagri Turan, Pablo M. Carrica, Troy Lyons, Duncan Hay, Larry Weber

    A study of the free surface flow on an ogee-crested fish bypass is presented. The commercial computational fluid dynamics (CFD) code Fluent 6.1 was used to perform the simulations. Structured/unstructured hybrid grids were used to accommodate the complex geometry that included gate slots, flow control gates, and an aeration slot. The volume of fluid (VOF) approach was used to model the water/air interface. The fish bypass exhibits complex free surface features including free nappes and air entrainment from the air slots. Free surface elevations on both sides of the nappe, pressure along the ogee surface, and discharge rating curves were compared against 1:24 experimental data from the laboratory model for different headwater elevations and gate settings. Limited comparison against measured velocities was also performed. Once deemed reliable through validation against experimental data, the computational model was used to analyze the flow field, supplementing the areas of limited experimental data. Though the paper presents the final fish bypass design, CFD was used to guide the design process and provide insight for several variations in the geometry.


  • Application of a Nonhydrostatic Model to Flow in a Free Surface Fish Passage Facility

    by Haegyun Lee, Ching-Long Lin, Larry J. Weber

    The free surface flow of two conceptual fish passage designs are investigated numerically by a level-set finite-element method. One design has a right-angled entrance from the reservoir to the fish passage chute, and the other has a curved-shaped entrance. The numerical results are validated with hydraulic experiments through comparison of the free surface location and the pressure distribution in the spillway. It is found that the right-angled design yields a curved free surface and pressure distribution in the vicinity of the entrance due to large strains, whereas the curved-shaped design yields a smooth flow transition with small strains. The negative pressure distributions near the ogee crest for both designs exhibit similar characteristics. Further downstream the free surface is elevated near the wall and is associated with counterrotating vortices. It is concluded that the curved-shaped design is favorable for fish passage because of the feature of a smooth flow transition with small strains.