Stanley I. Sandler
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Stanley I. Sandler has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
Gaurav Arora
Center for Molecular and Engineering Thermodynamics, Department of Chemical Engineering, University of Delaware, Newark, Delaware 19716, USA
2 shared publications- Marcelo Castier
Center for the Advancement of Technology in Society and Industry
2 shared publications Aaron M Scurto
Department of Chemical Engineering, Center for Molecular and Engineering Thermodynamics, University of Delaware, Newark, DE 19716, USA
1 shared publicationGonzalo Escobedo Alvarado
Dept. of Chemical Engineering, University of Delaware, Newark, DE 19716, USA
1 shared publicationGonzalo N Escobedo-Alvarado
Department of Chemical Engineering, Center for Molecular and Engineering Thermodynamics, University of Delaware, Newark, DE 19716, USA
1 shared publication- Luis Alejandro Galicia-Luna
Laboratorio de Termodinámica, SEPI-ESIQIE, Instituto Politécnico Nacional, UPALM, Ed. Z, Secc. 6, 1ER piso, Lindavista, C.P. 07738, México, D.F., México
1 shared publication
Latest Publications
- 23 February 2006
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 124 (8) , 084702
Air separation by single wall carbon nanotubes: Mass transport and kinetic selectivity
Mass transport of pure nitrogen, pure oxygen, and their mixture (air) has been studied at 100 K in a single wall carbon nanotube of 12.53 Å diameter. Phenomenological coefficients, and self- and corrected diffusivities are calculated using molecular-dynamics simulations, and transport diffusivities are obtained by combining these results with thermodynamic factors obtained from previous grand canonical Monte Carlo simulations [G. Arora and S. I. Sandler, J. Chem. Phys. 123, 044705 (2005)]. For mixtures, cross-term diffusion coefficients are found to be of similar order of magnitude as main-term diffusion coefficients over the entire range of pressure studied. These results are then combined with a continuum description of mass transport to determine the ideal and kinetic separation factors for a nanotube membrane. High permeances are observed for both pure components and the mixture inside the nanotubes. The concentration profiles, diffusivity profiles, and membrane fluxes are calculated, and it is demonstrated that by carefully adjusting the upstream and downstream pressures, a good kinetic selectivity can be achieved for air separation using single wall carbon nanotubes.
- 23 February 2006
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 124 (8) , 084702
Air separation by single wall carbon nanotubes: Mass transport and kinetic selectivity
Mass transport of pure nitrogen, pure oxygen, and their mixture (air) has been studied at 100 K in a single wall carbon nanotube of 12.53 Å diameter. Phenomenological coefficients, and self- and corrected diffusivities are calculated using molecular-dynamics simulations, and transport diffusivities are obtained by combining these results with thermodynamic factors obtained from previous grand canonical Monte Carlo simulations [G. Arora and S. I. Sandler, J. Chem. Phys. 123, 044705 (2005)]. For mixtures, cross-term diffusion coefficients are found to be of similar order of magnitude as main-term diffusion coefficients over the entire range of pressure studied. These results are then combined with a continuum description of mass transport to determine the ideal and kinetic separation factors for a nanotube membrane. High permeances are observed for both pure components and the mixture inside the nanotubes. The concentration profiles, diffusivity profiles, and membrane fluxes are calculated, and it is demonstrated that by carefully adjusting the upstream and downstream pressures, a good kinetic selectivity can be achieved for air separation using single wall carbon nanotubes.
- 22 July 2005
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 123 (4) , 044705
Air separation by single wall carbon nanotubes: Thermodynamics and adsorptive selectivity
Separation of a nitrogen–oxygen mixture (air) by single wall carbon nanotubes has been studied using grand canonical Monte Carlo simulations at a range of nanotube diameters, temperatures, and pressures. It is demonstrated that depending on these operating parameters, the extent of adsorptive selectivity can vary significantly. Detailed calculations are also presented for the adsorption isotherms, energies, and isosteric heats of pure nitrogen, oxygen, and their mixture at 100K in a carbon nanotube of 12.53-Å diameter. In single-component simulations, it is found that near saturation loading nitrogen forms only an annular layer close to the nanotube wall, while smaller-sized oxygen also occupies the region near the center of the nanotube. In mixture adsorption, the energetically favored nitrogen is preferentially adsorbed at low loadings. However, at high loadings oxygen replaces nitrogen due to the dominant entropic effects, and therefore a high selectivity towards oxygen is observed close to the saturation loading. The effect of the entropic change on mixture adsorption is evident from the calculated isosteric heats of adsorption. The mixture isotherms obtained from simulations are found to be in good agreement with the predictions based only on the pure component simulation results.
- 22 July 2005
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 123 (4) , 044705
Air separation by single wall carbon nanotubes: Thermodynamics and adsorptive selectivity
Separation of a nitrogen–oxygen mixture (air) by single wall carbon nanotubes has been studied using grand canonical Monte Carlo simulations at a range of nanotube diameters, temperatures, and pressures. It is demonstrated that depending on these operating parameters, the extent of adsorptive selectivity can vary significantly. Detailed calculations are also presented for the adsorption isotherms, energies, and isosteric heats of pure nitrogen, oxygen, and their mixture at 100K in a carbon nanotube of 12.53-Å diameter. In single-component simulations, it is found that near saturation loading nitrogen forms only an annular layer close to the nanotube wall, while smaller-sized oxygen also occupies the region near the center of the nanotube. In mixture adsorption, the energetically favored nitrogen is preferentially adsorbed at low loadings. However, at high loadings oxygen replaces nitrogen due to the dominant entropic effects, and therefore a high selectivity towards oxygen is observed close to the saturation loading. The effect of the entropic change on mixture adsorption is evident from the calculated isosteric heats of adsorption. The mixture isotherms obtained from simulations are found to be in good agreement with the predictions based only on the pure component simulation results.
- Open Access
- 1 December 2004
- Published by FapUNIFESP (SciELO) in Brazilian Journal of Chemical Engineering
- Vol. 21 (4) , 659-666
Modeling the high-pressure behavior of binary mixtures of carbon dioxide+alkanols using an excess free energy mixing rule
The behavior of binary mixtures of carbon dioxide+alkanol (1-butanol, 2-butanol, 1-pentanol, or 2-pentanol) at high pressures was modeled using the Stryjek-Vera version of the Peng-Robinson equation of state. Two mixing rules were compared for this purpose: the classical one-fluid van der Waals and the Wong-Sandler mixing rules. In the case of the latter mixing rule, the NRTL model for the excess Gibbs free energy was used. We observed that both mixing rules can reproduce the qualitative aspects of the critical diagrams of these binary mixtures. A comparison of the results shows that there is no clear superiority of one mixing rule over the other in terms of the ability to predict the critical behavior of these mixtures.
- 1 December 2004
- Published by FapUNIFESP (SciELO) in Brazilian Journal of Chemical Engineering
- Vol. 21 (4) , 659-666
Open AccessModeling the high-pressure behavior of binary mixtures of carbon dioxide+alkanols using an excess free energy mixing rule
The behavior of binary mixtures of carbon dioxide+alkanol (1-butanol, 2-butanol, 1-pentanol, or 2-pentanol) at high pressures was modeled using the Stryjek-Vera version of the Peng-Robinson equation of state. Two mixing rules were compared for this purpose: the classical one-fluid van der Waals and the Wong-Sandler mixing rules. In the case of the latter mixing rule, the NRTL model for the excess Gibbs free energy was used. We observed that both mixing rules can reproduce the qualitative aspects of the critical diagrams of these binary mixtures. A comparison of the results shows that there is no clear superiority of one mixing rule over the other in terms of the ability to predict the critical behavior of these mixtures.
- 1 October 2001
- Published by Elsevier in The Journal of Supercritical Fluids
- Vol. 21 (2) , 123-134
Modeling of solid–supercritical fluid phase equilibria with a cubic equation of state—Gex model
- 1 October 2001
- Published by Elsevier in The Journal of Supercritical Fluids
- Vol. 21 (2) , 123-134
Modeling of solid–supercritical fluid phase equilibria with a cubic equation of state—Gex model
- 1 November 1999
- Published by Elsevier in Fluid Phase Equilibria
- Vol. 165 (1) , 87-97
The effect of salt and temperature on the infinite dilution activity coefficients of volatile organic chemicals in water
- 1 November 1999
- Published by Elsevier in Fluid Phase Equilibria
- Vol. 165 (1) , 87-97
The effect of salt and temperature on the infinite dilution activity coefficients of volatile organic chemicals in water
- 15 June 1998
- Published by Elsevier in The Journal of Supercritical Fluids
- Vol. 13 (1-3) , 49-54
Predictions of critical behavior using the Wong–Sandler mixing rule
- 15 June 1998
- Published by Elsevier in The Journal of Supercritical Fluids
- Vol. 13 (1-3) , 49-54
Predictions of critical behavior using the Wong–Sandler mixing rule