Akira Fujishima
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Akira Fujishima has a total of 29 co-authors. Here are the top co-authors by number of shared publications:
- Donald A. Tryk
Hydrogen and Fuel Cell Nanomaterials Center, University of Yamanashi, Miyamae 6-43, Kofu 400-0021, Japan
3 shared publications Dongchan Shin
Department of Applied Chemistry, School of Engineering, The University of Tokyo, 7‐3‐1 Hongo, Bunkyo‐ku, Tokyo 113‐8656, Japan
2 shared publicationsKenichi Honda
2 shared publications- Osamu Sato
Institute for Materials Chemistry and Engineering and IRCCS, Kyushu University, 744 Motooka, Nishi-ku, Fukuoka 819-0395, Japan
2 shared publications - Xintong Zhang
Northeast Normal University
2 shared publications - Zhongze Gu
Institute of Microphysiological Systems, State Key Laboratory of Digital Medical Engineering, School of Biological Science and Medical Engineering, Southeast University, Nanjing, 210096, China
2 shared publications
Latest Publications
- 1 July 2008
- Published by Elsevier in Applied Surface Science
- Vol. 254 (18) , 5891-5894
Novel hydrophobic/hydrophilic patterning process by photocatalytic Ag nucleation on TiO2 thin film and electroless Cu deposition
- 1 July 2008
- Published by Elsevier in Applied Surface Science
- Vol. 254 (18) , 5891-5894
Novel hydrophobic/hydrophilic patterning process by photocatalytic Ag nucleation on TiO2 thin film and electroless Cu deposition
- 30 November 2004
- Published by Wiley in Electroanalysis
- Vol. 17 (4) , 305-311
Resistance to Surfactant and Protein Fouling Effects at Conducting Diamond Electrodes
Boron‐doped diamond thin‐film electrodes display negligible fouling effects in the presence of high levels of surface‐active materials, including proteins. Dramatic improvements in the stability of the analyte response (compared to common glassy carbon and carbon paste electrodes) are illustrated using bovine serum albumin (BSA), gelatin, and Triton X‐100 in connection with repetitive square‐wave voltammetric (SWV) measurements. The voltammetric response of ascorbic acid at the diamond electrode exhibits negligible shifts in peak potentials and minimal depressions of current signals over a wide range of surfactant concentrations (0–750 ppm). For example, the diamond electrode exhibited 70, 50 and 60 mV potential shifts for 10 repetitive voltammetric scans in the presence of 100 ppm BSA, gelatin and Triton X‐100, respectively, compared to 120, 190, and 280 mV shifts observed at the glassy carbon electrode. Furthermore, only 4.3 and 6.2% of the initial current decays were observed in the presence of 100 ppm Triton X‐100 and gelatin, respectively (compared to 45.2 and 34.4% diminutions at the glassy carbon electrode). Such improved performance was also confirmed from the SWV measurements of uric acid, dihydroxyphenylacetic acid, and catechol. The greatly improved resistance to surfactant interference reflects the fact that the as‐grown diamond thin film, composed of oxide‐free and hydrogen‐terminated surface, has a relatively lower surface energy and minimal electrostatic attributes, either specific or general, so that little adsorption of surface‐active agents occurs. The topographic AFM images of the diamond electrode surface confirm a negligible BSA fouling effect after repetitive SWV measurements. Such enhanced antifouling features make diamond electrodes very attractive for numerous real‐life electroanalytical applications.
- 30 November 2004
- Published by Wiley in Electroanalysis
- Vol. 17 (4) , 305-311
Resistance to Surfactant and Protein Fouling Effects at Conducting Diamond Electrodes
Boron‐doped diamond thin‐film electrodes display negligible fouling effects in the presence of high levels of surface‐active materials, including proteins. Dramatic improvements in the stability of the analyte response (compared to common glassy carbon and carbon paste electrodes) are illustrated using bovine serum albumin (BSA), gelatin, and Triton X‐100 in connection with repetitive square‐wave voltammetric (SWV) measurements. The voltammetric response of ascorbic acid at the diamond electrode exhibits negligible shifts in peak potentials and minimal depressions of current signals over a wide range of surfactant concentrations (0–750 ppm). For example, the diamond electrode exhibited 70, 50 and 60 mV potential shifts for 10 repetitive voltammetric scans in the presence of 100 ppm BSA, gelatin and Triton X‐100, respectively, compared to 120, 190, and 280 mV shifts observed at the glassy carbon electrode. Furthermore, only 4.3 and 6.2% of the initial current decays were observed in the presence of 100 ppm Triton X‐100 and gelatin, respectively (compared to 45.2 and 34.4% diminutions at the glassy carbon electrode). Such improved performance was also confirmed from the SWV measurements of uric acid, dihydroxyphenylacetic acid, and catechol. The greatly improved resistance to surfactant interference reflects the fact that the as‐grown diamond thin film, composed of oxide‐free and hydrogen‐terminated surface, has a relatively lower surface energy and minimal electrostatic attributes, either specific or general, so that little adsorption of surface‐active agents occurs. The topographic AFM images of the diamond electrode surface confirm a negligible BSA fouling effect after repetitive SWV measurements. Such enhanced antifouling features make diamond electrodes very attractive for numerous real‐life electroanalytical applications.
- 22 November 2004
- Published by AIP Publishing in Applied Physics Letters
- Vol. 85 (21) , 5067-5069
Biomimetic titanium dioxide film with structural color and extremely stable hydrophilicity
We biomimeticly fabricated titanium dioxide films with three-dimensionally ordered structure. These films exhibit structural color, photocatalysis, and photoinduced superhydrophilicity. In addition, this biomimetic approach solves the problem of the stability of the superhydrophilicity of titanium dioxide.
- 22 November 2004
- Published by AIP Publishing in Applied Physics Letters
- Vol. 85 (21) , 5067-5069
Biomimetic titanium dioxide film with structural color and extremely stable hydrophilicity
We biomimeticly fabricated titanium dioxide films with three-dimensionally ordered structure. These films exhibit structural color, photocatalysis, and photoinduced superhydrophilicity. In addition, this biomimetic approach solves the problem of the stability of the superhydrophilicity of titanium dioxide.
- 30 August 2004
- Published by Wiley in Electrophoresis
- Vol. 25 (17) , 3017-3023
Microchip capillary electrophoresis with a boron‐doped diamond electrochemical detector for analysis of aromatic amines
The attractive features of a boron‐doped diamond (BDD) thin‐film detector for microchip capillary electrophoretic (CE) separations of dye‐related amino‐substituted aromatic compounds are described. The diamond electrode was employed in the end‐column amperometric detection of 4‐aminophenol (4‐AP), 1,2‐phenylenediamine (1,2‐PDA), 2‐aminonaphthalene (2‐AN), 2‐chloroaniline (2‐CA), and o‐aminobenzoic acid (o‐ABA), and its attractive behavior was compared to commonly used screen‐printed carbon and glassy‐carbon electrodes. These conventional electrode materials exhibit a significant degree of passivation and low sensitivity to the above‐mentioned environmental pollutants. The diamond‐based electrochemical detection system displayed a favorable analytical performance, including lower noise levels, higher peak resolution with enhanced sensitivity, and improved resistance against electrode passivation. Factors influencing the on‐chip analysis were assessed and optimized. The diamond detector displayed detection limits of 2.0 and 1.3 μM for 4‐AP and 2‐AN, respectively, and a wide linear response for these compounds over the 2–50 μM range. The enhanced stability was demonstrated by relative standard deviation (RSD) values of 1.4% and 4.7% for 100 μM 1,2‐PDA and 200 μM 2‐CA, respectively, for repetitive detections (n = 7). Besides, the simultaneously observed current decrease was 2.4 and 9.1% for 1,2‐PDA and 2‐CA, respectively (compared to 21.8 and 41.0% at the screen‐printed carbon electrode and 28.3 and 34.1% at the glassy carbon electrode, respectively). The favorable properties of the diamond electrode indicate great promise for environmental applications in CE and other microchip devices.
- 30 August 2004
- Published by Wiley in Electrophoresis
- Vol. 25 (17) , 3017-3023
Microchip capillary electrophoresis with a boron‐doped diamond electrochemical detector for analysis of aromatic amines
The attractive features of a boron‐doped diamond (BDD) thin‐film detector for microchip capillary electrophoretic (CE) separations of dye‐related amino‐substituted aromatic compounds are described. The diamond electrode was employed in the end‐column amperometric detection of 4‐aminophenol (4‐AP), 1,2‐phenylenediamine (1,2‐PDA), 2‐aminonaphthalene (2‐AN), 2‐chloroaniline (2‐CA), and o‐aminobenzoic acid (o‐ABA), and its attractive behavior was compared to commonly used screen‐printed carbon and glassy‐carbon electrodes. These conventional electrode materials exhibit a significant degree of passivation and low sensitivity to the above‐mentioned environmental pollutants. The diamond‐based electrochemical detection system displayed a favorable analytical performance, including lower noise levels, higher peak resolution with enhanced sensitivity, and improved resistance against electrode passivation. Factors influencing the on‐chip analysis were assessed and optimized. The diamond detector displayed detection limits of 2.0 and 1.3 μM for 4‐AP and 2‐AN, respectively, and a wide linear response for these compounds over the 2–50 μM range. The enhanced stability was demonstrated by relative standard deviation (RSD) values of 1.4% and 4.7% for 100 μM 1,2‐PDA and 200 μM 2‐CA, respectively, for repetitive detections (n = 7). Besides, the simultaneously observed current decrease was 2.4 and 9.1% for 1,2‐PDA and 2‐CA, respectively (compared to 21.8 and 41.0% at the screen‐printed carbon electrode and 28.3 and 34.1% at the glassy carbon electrode, respectively). The favorable properties of the diamond electrode indicate great promise for environmental applications in CE and other microchip devices.
- 1 March 2004
- Published by Springer Nature in Journal of Applied Electrochemistry
- Vol. 34 (3) , 249-254
Electrochemical oxidation of aniline at boron-doped diamond electrodes
- 1 March 2004
- Published by Springer Nature in Journal of Applied Electrochemistry
- Vol. 34 (3) , 249-254
Electrochemical oxidation of aniline at boron-doped diamond electrodes
- 1 February 2004
- Published by Elsevier in Solar Energy Materials and Solar Cells
- Vol. 81 (2) , 197-203
Slow interfacial charge recombination in solid-state dye-sensitized solar cell using Al2O3-coated nanoporous TiO2 films
- 1 February 2004
- Published by Elsevier in Solar Energy Materials and Solar Cells
- Vol. 81 (2) , 197-203
Slow interfacial charge recombination in solid-state dye-sensitized solar cell using Al2O3-coated nanoporous TiO2 films
- 19 September 2003
- Published by American Association for the Advancement of Science (AAAS) in Science
- Vol. 301 (5640) , 1673
Comment on "Efficient Photochemical Water Splitting by a Chemically Modified n-TiO 2 " (I)
- 19 September 2003
- Published by American Association for the Advancement of Science (AAAS) in Science
- Vol. 301 (5640) , 1673
Comment on "Efficient Photochemical Water Splitting by a Chemically Modified n-TiO 2 " (I)
- 18 July 2003
- Published by Elsevier in Electrochimica Acta
- Vol. 48 (19) , 2739-2748
AC impedance studies of anodically treated polycrystalline and homoepitaxial boron-doped diamond electrodes
- 18 July 2003
- Published by Elsevier in Electrochimica Acta
- Vol. 48 (19) , 2739-2748
AC impedance studies of anodically treated polycrystalline and homoepitaxial boron-doped diamond electrodes
- 17 June 2002
- Vol. 41 (12) , 2068-70
Patterning of a colloidal crystal film on a modified hydrophilic and hydrophobic surface.
- 17 June 2002
- Vol. 41 (12) , 2068-70
Patterning of a colloidal crystal film on a modified hydrophilic and hydrophobic surface.
- 1 January 1986
- Published by The Chemical Society of Japan in NIPPON KAGAKU KAISHI
- No. 1,p. 1-7
Photoanodic oxidation of D-glucose on a polycrystalline zinc oxide electrode in an alkaline solution.
- 1 January 1986
- Published by The Chemical Society of Japan in NIPPON KAGAKU KAISHI
- No. 1,p. 1-7
Photoanodic oxidation of D-glucose on a polycrystalline zinc oxide electrode in an alkaline solution.