Francois D. Botha
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Francois D. Botha has a total of 3 co-authors. Here are the top co-authors by number of shared publications:
Rudolph N. Kraus
FACI, Professor of Structural Engineering, and Academic Program Director, Center for By-Products Utilization, Univ. of Wisconsin-Milwaukee, P.O. Box 784, Milwaukee, WI 53201
1 shared publication- Tarun R. Naik
UWM Center for By-Products Utilization, University of Wisconsin-Milwaukee, Milwaukee, WI 53201, USA
1 shared publication - Yoon-Moon Chun
FACI, Professor of Structural Engineering, and Academic Program Director, Center for By-Products Utilization, Univ. of Wisconsin–Milwaukee, P.O. Box 784, Milwaukee, WI 53201
1 shared publication
Latest Publications
- 1 December 2005
- Published by American Society of Civil Engineers (ASCE) in Journal of Materials in Civil Engineering
- Vol. 17 (6) , 659-663
Cast-Concrete Products Made with FBC Ash and Wet-Collected Coal-Ash
Cast-concrete hollow blocks, solid blocks, and paving stones were produced at a manufacturing plant by replacing up to 45% (by mass) of portland cement with fluidized bed combustion (FBC) coal ash and up to 9% of natural aggregates with wet-collected, low-lime, coarse coal-ash (WA). Cast-concrete product specimens of all three types exceeded the compressive strength requirements of ASTM from early ages, with the exception of one paving-stone mixture, which fell short of the requirement by less than 10%. The cast-concrete products made by replacing up to 40% of cement with FBC ash were equivalent in strength (89–113% of control) to the products without ash. The abrasion resistance of paving stones was equivalent for up to 34% FBC ash content. Partial replacement of aggregates with WA decreased strength of the products. The resistance of hollow blocks and paving stones to freezing and thawing decreased appreciably with increasing ash contents. The cast-concrete products could be used indoors in regions where freezing and thawing is a concern, and outdoors in a moderate climate.
- 1 December 2005
- Published by American Society of Civil Engineers (ASCE) in Journal of Materials in Civil Engineering
- Vol. 17 (6) , 659-663
Cast-Concrete Products Made with FBC Ash and Wet-Collected Coal-Ash
Cast-concrete hollow blocks, solid blocks, and paving stones were produced at a manufacturing plant by replacing up to 45% (by mass) of portland cement with fluidized bed combustion (FBC) coal ash and up to 9% of natural aggregates with wet-collected, low-lime, coarse coal-ash (WA). Cast-concrete product specimens of all three types exceeded the compressive strength requirements of ASTM from early ages, with the exception of one paving-stone mixture, which fell short of the requirement by less than 10%. The cast-concrete products made by replacing up to 40% of cement with FBC ash were equivalent in strength (89–113% of control) to the products without ash. The abrasion resistance of paving stones was equivalent for up to 34% FBC ash content. Partial replacement of aggregates with WA decreased strength of the products. The resistance of hollow blocks and paving stones to freezing and thawing decreased appreciably with increasing ash contents. The cast-concrete products could be used indoors in regions where freezing and thawing is a concern, and outdoors in a moderate climate.