Dan Ritter
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Dan Ritter has a total of 30 co-authors. Here are the top co-authors by number of shared publications:
Arkady Gavrilov
Department of Electrical Engineering, Technion-Israel Institute of Technology, Haifa 32000, Israel
5 shared publicationsShimon Cohen
Department of Electrical Engineering, Technion-Israel Institute of Technology, Haifa 32000, Israel
5 shared publications- Yonatan Calahorra
Department of Materials Science and Metallurgy University of Cambridge CB3 0FS Cambrdige UK
5 shared publications Moshe Eizenberg
Department of Materials Science and Engineering, Technion–Israel Institute of Technology, Haifa, Israel
3 shared publications- Shlomo Mehari
Materials Department, University of California, Santa Barbara, California 93106, USA
2 shared publications Alex Kelrich
1 shared publication
Latest Publications
- Open Access
- 16 September 2019
- Published by MDPI AG in Nanomaterials
- Vol. 9 (9) , 1327
Strain-Mediated Bending of InP Nanowires through the Growth of an Asymmetric InAs Shell
Controlling nanomaterial shape beyond its basic dimensionality is a concurrent challenge tackled by several growth and processing avenues. One of these is strain engineering of nanowires, implemented through the growth of asymmetrical heterostructures. Here, we report metal–organic molecular beam epitaxy of bent InP/InAs core/shell nanowires brought by precursor flow directionality in the growth chamber. We observe the increase of bending with decreased core diameter. We further analyze the composition of a single nanowire and show through supporting finite element simulations that strain accommodation following the lattice mismatch between InP and InAs dominates nanowire bending. The simulations show the interplay between material composition, shell thickness, and tapering in determining the bending. The simulation results are in good agreement with the experimental bending curvature, reproducing the radius of 4.3 µm (±10%), for the 2.3 µm long nanowire. The InP core of the bent heterostructure was found to be compressed at about 2%. This report provides evidence of shape control and strain engineering in nanostructures, specifically through the exchange of group-V materials in III–V nanowire growth.
- 16 September 2019
- Published by MDPI AG in Nanomaterials
- Vol. 9 (9) , 1327
Open AccessStrain-Mediated Bending of InP Nanowires through the Growth of an Asymmetric InAs Shell
Controlling nanomaterial shape beyond its basic dimensionality is a concurrent challenge tackled by several growth and processing avenues. One of these is strain engineering of nanowires, implemented through the growth of asymmetrical heterostructures. Here, we report metal–organic molecular beam epitaxy of bent InP/InAs core/shell nanowires brought by precursor flow directionality in the growth chamber. We observe the increase of bending with decreased core diameter. We further analyze the composition of a single nanowire and show through supporting finite element simulations that strain accommodation following the lattice mismatch between InP and InAs dominates nanowire bending. The simulations show the interplay between material composition, shell thickness, and tapering in determining the bending. The simulation results are in good agreement with the experimental bending curvature, reproducing the radius of 4.3 µm (±10%), for the 2.3 µm long nanowire. The InP core of the bent heterostructure was found to be compressed at about 2%. This report provides evidence of shape control and strain engineering in nanostructures, specifically through the exchange of group-V materials in III–V nanowire growth.
- 24 March 2016
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 49 (16) , 165309
Reduction of nanowire diameter beyond lithography limits by controlled catalyst dewetting
Catalyst assisted vapour-liquid–solid is the most common method to realize bottom-up nanowire growth; establishing a parallel process for obtaining nanoscale catalysts at pre-defined locations is paramount for further advancement towards commercial nanowire applications. Herein, the effect of a selective area mask on the dewetting of metallic nanowire catalysts, deposited within lithography-defined mask pinholes, is reported. It was found that thin disc-like catalysts, with diameters of 120–450 nm, were transformed through dewetting into hemisphere-like catalysts, having diameters 2–3 fold smaller; the process was optimized to about 95% yield in preventing catalyst splitting, as would otherwise be expected due to their thickness-to-diameter ratio, which was as low as 1/60. The catalysts subsequently facilitated InP and InAs nanowire growth. We suggest that the mask edges prevent surface migration mediated spreading of the dewetted metal, and therefore induce its agglomeration into a single particle. This result presents a general strategy to diminish lithography-set dimensions for NW growth, and may answer a fundamental challenge faced by bottom-up nanowire technology.
- 24 March 2016
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 49 (16) , 165309
Reduction of nanowire diameter beyond lithography limits by controlled catalyst dewetting
Catalyst assisted vapour-liquid–solid is the most common method to realize bottom-up nanowire growth; establishing a parallel process for obtaining nanoscale catalysts at pre-defined locations is paramount for further advancement towards commercial nanowire applications. Herein, the effect of a selective area mask on the dewetting of metallic nanowire catalysts, deposited within lithography-defined mask pinholes, is reported. It was found that thin disc-like catalysts, with diameters of 120–450 nm, were transformed through dewetting into hemisphere-like catalysts, having diameters 2–3 fold smaller; the process was optimized to about 95% yield in preventing catalyst splitting, as would otherwise be expected due to their thickness-to-diameter ratio, which was as low as 1/60. The catalysts subsequently facilitated InP and InAs nanowire growth. We suggest that the mask edges prevent surface migration mediated spreading of the dewetted metal, and therefore induce its agglomeration into a single particle. This result presents a general strategy to diminish lithography-set dimensions for NW growth, and may answer a fundamental challenge faced by bottom-up nanowire technology.
- 7 September 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 36 (11) , 1124-1127
Role of Transport During Transient Phenomena in AlGaN/GaN Heterostructure FETs
Transient phenomena in AlGaN/GaN heterostructure field-effect transistors are attributed to trapping and detrapping of electrons from deep localized states, and the measured activation energies are conventionally associated with the electron capture and emission processes. This standard interpretation ignores, however, transport between the two-dimensional electron gas and the trap. Using gated van der Pauw structures, we demonstrate that the transient behavior is determined by transport (at least for the trapping process). The measured activation energy is, therefore, a characteristic of the transport process rather than the emission-capture processes.
- 7 September 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 36 (11) , 1124-1127
Role of Transport During Transient Phenomena in AlGaN/GaN Heterostructure FETs
Transient phenomena in AlGaN/GaN heterostructure field-effect transistors are attributed to trapping and detrapping of electrons from deep localized states, and the measured activation energies are conventionally associated with the electron capture and emission processes. This standard interpretation ignores, however, transport between the two-dimensional electron gas and the trap. Using gated van der Pauw structures, we demonstrate that the transient behavior is determined by transport (at least for the trapping process). The measured activation energy is, therefore, a characteristic of the transport process rather than the emission-capture processes.
- 18 August 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 61 (10) , 3558-3561
Comparison of Simulation and Measurement of Gate Leakage Current in Metal/Al2O3/GaN/AlGaN/AlN/GaN Capacitors
We compare the simulations and measurements of gate leakage current in metal-insulator-semiconductor capacitors fabricated on standard AlGaN/GaN transistor layers. In the simulations, a fixed charge density at the interface between the Al 2 O 3 layer and the GaN cap layer was assumed for simplicity. The fixed charge layer (which depends on bias and device history) was obtained from capacitance-voltage measurements. The calculated tunneling current due to field emission from localized states in the GaN cap layer agreed with the experimental results. No additional leakage mechanisms had to be invoked.
- 18 August 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 61 (10) , 3558-3561
Comparison of Simulation and Measurement of Gate Leakage Current in Metal/Al2O3/GaN/AlGaN/AlN/GaN Capacitors
We compare the simulations and measurements of gate leakage current in metal-insulator-semiconductor capacitors fabricated on standard AlGaN/GaN transistor layers. In the simulations, a fixed charge density at the interface between the Al 2 O 3 layer and the GaN cap layer was assumed for simplicity. The fixed charge layer (which depends on bias and device history) was obtained from capacitance-voltage measurements. The calculated tunneling current due to field emission from localized states in the GaN cap layer agreed with the experimental results. No additional leakage mechanisms had to be invoked.
- 1 March 2014
- Published by Elsevier in Journal of Crystal Growth
- Vol. 389, 103-107
Tapering and crystal structure of indium phosphide nanowires grown by selective area vapor liquid solid epitaxy
- 1 March 2014
- Published by Elsevier in Journal of Crystal Growth
- Vol. 389, 103-107
Tapering and crystal structure of indium phosphide nanowires grown by selective area vapor liquid solid epitaxy
- 1 December 2013
- Published by Elsevier in Materials Letters
- Vol. 113, 38-41
Characterization of structural defects in highly mismatched GaP nanowires
- 1 December 2013
- Published by Elsevier in Materials Letters
- Vol. 113, 38-41
Characterization of structural defects in highly mismatched GaP nanowires
- 6 August 2012
- Published by AIP Publishing in Applied Physics Letters
- Vol. 101 (6) , 063504
Correlation between Ga-O signature and midgap states at the Al2O3/In0.53Ga0.47As interface
- 6 August 2012
- Published by AIP Publishing in Applied Physics Letters
- Vol. 101 (6) , 063504
Correlation between Ga-O signature and midgap states at the Al2O3/In0.53Ga0.47As interface
- 28 May 2012
- Published by IOP Publishing in Nanotechnology
- Vol. 23 (24) , 245603
Native-oxide-based selective area growth of InP nanowires via metal–organic molecular beam epitaxy mediated by surface diffusion
The growth of InP nanowires on an InP(111) B substrate is reported. The substrate native oxide was not removed from the surface prior to growth. Nanowires were grown at 400 °C from gold catalysts in a selective area manner, without bulk growth. Unlike SiO(2)-based metal-organic molecular beam epitaxy selective area growth, the growth reported here is mediated by surface diffusion with a characteristic diffusion length of 4 μm, about an order of magnitude larger than values for diffusion on bare substrates. A pre-growth heating treatment at 450 °C was found to increase the yield of nanowire nucleation from the gold catalysts.
- 28 May 2012
- Published by IOP Publishing in Nanotechnology
- Vol. 23 (24) , 245603
Native-oxide-based selective area growth of InP nanowires via metal–organic molecular beam epitaxy mediated by surface diffusion
The growth of InP nanowires on an InP(111) B substrate is reported. The substrate native oxide was not removed from the surface prior to growth. Nanowires were grown at 400 °C from gold catalysts in a selective area manner, without bulk growth. Unlike SiO(2)-based metal-organic molecular beam epitaxy selective area growth, the growth reported here is mediated by surface diffusion with a characteristic diffusion length of 4 μm, about an order of magnitude larger than values for diffusion on bare substrates. A pre-growth heating treatment at 450 °C was found to increase the yield of nanowire nucleation from the gold catalysts.
- 18 May 2010
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 57 (6) , 1466-1469
Electron Transport Through Abrupt Type I Double Heterojunction Bipolar Transistors
A model with two unknown parameters predicts the experimental current voltage characteristics of InP/GalnAs/InP double-heterojunction bipolar transistors. The model is based upon the calculation of the tunneling rate through the collector energy barrier. The two unknown parameters, i.e., electron temperature and electron lifetime in the base, are obtained by comparing experimental results and model calculations. The extracted electron temperature in the base ranged between 350 and 400 K, indicating that the energy relaxation times of electrons having energies lower than the longitudinal optical phonon energy are long compared with the electron lifetime.
- 18 May 2010
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 57 (6) , 1466-1469
Electron Transport Through Abrupt Type I Double Heterojunction Bipolar Transistors
A model with two unknown parameters predicts the experimental current voltage characteristics of InP/GalnAs/InP double-heterojunction bipolar transistors. The model is based upon the calculation of the tunneling rate through the collector energy barrier. The two unknown parameters, i.e., electron temperature and electron lifetime in the base, are obtained by comparing experimental results and model calculations. The extracted electron temperature in the base ranged between 350 and 400 K, indicating that the energy relaxation times of electrons having energies lower than the longitudinal optical phonon energy are long compared with the electron lifetime.
- 18 October 2004
- Published by AIP Publishing in Applied Physics Letters
- Vol. 85 (16) , 3578-3580
Gallium diffusion into self-assembled InAs quantum dots grown on indium phosphide substrates
The photoluminescence spectrum of small self-assembled In(Ga)As quantum dots grown on InP substrates is composed of distinct spectral lines. These lines correspond to monolayer variations in the dots smallest dimension: their heights. We use this phenomenon in order to study the diffusion of gallium atoms into the self-assembled quantum dots. We demonstrate that substantial amounts of gallium atoms diffuse from a strained GaInP layer underneath the quantum dots into the quantum dots.
- 18 October 2004
- Published by AIP Publishing in Applied Physics Letters
- Vol. 85 (16) , 3578-3580
Gallium diffusion into self-assembled InAs quantum dots grown on indium phosphide substrates
The photoluminescence spectrum of small self-assembled In(Ga)As quantum dots grown on InP substrates is composed of distinct spectral lines. These lines correspond to monolayer variations in the dots smallest dimension: their heights. We use this phenomenon in order to study the diffusion of gallium atoms into the self-assembled quantum dots. We demonstrate that substantial amounts of gallium atoms diffuse from a strained GaInP layer underneath the quantum dots into the quantum dots.