Fu-Ming Pan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Fu-Ming Pan has a total of 85 co-authors. Here are the top co-authors by number of shared publications:
Te-Ming Chen
4 shared publicationsCheng-Yi Chang
National Chiao-Tung University
3 shared publications- Jia-Min Shieh
National Nano Device Laboratories, No. 26, Prosperity Road 1, Hsinchu 30078, Taiwan
3 shared publications Wen-Hsien Huang
National Chiao-Tung University 1 Department of Materials Science and Engineering Hsinchu 30010 Taiwan
3 shared publicationsChang-Hong Shen
National Nano Device Laboratories 2 , No. 26, Prosperity Road 1, Hsinchu 30078, Taiwan
2 shared publicationsCheng-Tzu Kuo
Department of Materials Science and Engineering, MinDao University, Changhua, Taiwan, ROC
2 shared publications
Latest Publications
- 17 July 2018
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 29 (17) , 15203-15211
Effect of hole blocking dielectric layer on microstructure and photoconducting properties of polycrystalline Se thin films
- 17 July 2018
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 29 (17) , 15203-15211
Effect of hole blocking dielectric layer on microstructure and photoconducting properties of polycrystalline Se thin films
- 2 November 2015
- Published by AIP Publishing in Applied Physics Letters
- Vol. 107 (18) , 183506
Charge-trap non-volatile memories fabricated by laser-enabled low-thermal budget processes
We fabricated charge-trap non-volatile memories (NVMs) using low thermal budget processes, including laser-crystallization of poly-Si thin film, chemical vapor deposition deposition of a stacked memory layer, and far-infrared-laser dopant activation. The thin poly-Si channel has a low defect-density at the interface with the bulk, resulting in a steep subthreshold swing for the NVM transistors. The introduction of the stacked SiO2/AlOxNy tunnel layer and the SiNx charge-trap layer with a gradient bandgap leads to reliable retention and endurance at low voltage for the NVMs. The low thermal budget processes are desirable for the integration of the nano-scaled NVMs into system on panels.
- 2 November 2015
- Published by AIP Publishing in Applied Physics Letters
- Vol. 107 (18) , 183506
Charge-trap non-volatile memories fabricated by laser-enabled low-thermal budget processes
We fabricated charge-trap non-volatile memories (NVMs) using low thermal budget processes, including laser-crystallization of poly-Si thin film, chemical vapor deposition deposition of a stacked memory layer, and far-infrared-laser dopant activation. The thin poly-Si channel has a low defect-density at the interface with the bulk, resulting in a steep subthreshold swing for the NVM transistors. The introduction of the stacked SiO2/AlOxNy tunnel layer and the SiNx charge-trap layer with a gradient bandgap leads to reliable retention and endurance at low voltage for the NVMs. The low thermal budget processes are desirable for the integration of the nano-scaled NVMs into system on panels.
- 9 December 2014
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 17 (5) , 3039-3049
A mechanistic study of hydrogen gas sensing by PdO nanoflake thin films at temperatures below 250 °C
Kinetic competition between PdO reduction and reoxidation governs the H2 sensing behavior of PdO nanoflakes at temperatures below 200 °C.
- 9 December 2014
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 17 (5) , 3039-3049
A mechanistic study of hydrogen gas sensing by PdO nanoflake thin films at temperatures below 250 °C
Kinetic competition between PdO reduction and reoxidation governs the H2 sensing behavior of PdO nanoflakes at temperatures below 200 °C.
- 1 May 2014
- Published by Elsevier in Current Applied Physics
- Vol. 14 (5) , 659-664
Dark current suppression of amorphous selenium based photosensors by the ZnO hole blocking layer
- 1 May 2014
- Published by Elsevier in Current Applied Physics
- Vol. 14 (5) , 659-664
Dark current suppression of amorphous selenium based photosensors by the ZnO hole blocking layer
- 12 August 2013
- Published by AIP Publishing in Applied Physics Letters
- Vol. 103 (7) , 073107
Multi-functional stacked light-trapping structure for stabilizing and boosting solar-electricity efficiency of hydrogenated amorphous silicon solar cells
A sandwiched light-trapping electrode structure, which consists of a capping aluminum-doped ZnO (AZO) layer, dispersed plasmonic Au-nanoparticles (Au-NPs), and a micro-structured transparent conductive substrate, is employed to stabilize and boost the conversion-efficiency of hydrogenated amorphous silicon (a-Si:H) solar cells. The conformal AZO ultrathin layer (5 nm) smoothened the Au-NP-dispersed electrode surface, thereby reducing defects across the AZO/a-Si:H interface and resulting in a high resistance to photo-degradation in the ultraviolet-blue photoresponse band. With the plasmonic light-trapping structure, the cell has a high conversion-efficiency of 10.1% and the photo-degradation is as small as 7%.
- 12 August 2013
- Published by AIP Publishing in Applied Physics Letters
- Vol. 103 (7) , 073107
Multi-functional stacked light-trapping structure for stabilizing and boosting solar-electricity efficiency of hydrogenated amorphous silicon solar cells
A sandwiched light-trapping electrode structure, which consists of a capping aluminum-doped ZnO (AZO) layer, dispersed plasmonic Au-nanoparticles (Au-NPs), and a micro-structured transparent conductive substrate, is employed to stabilize and boost the conversion-efficiency of hydrogenated amorphous silicon (a-Si:H) solar cells. The conformal AZO ultrathin layer (5 nm) smoothened the Au-NP-dispersed electrode surface, thereby reducing defects across the AZO/a-Si:H interface and resulting in a high resistance to photo-degradation in the ultraviolet-blue photoresponse band. With the plasmonic light-trapping structure, the cell has a high conversion-efficiency of 10.1% and the photo-degradation is as small as 7%.
- 1 December 2012
- Published by Elsevier in Applied Surface Science
- Vol. 263, 345-351
Enhanced photocatalytic decomposition of methylene blue by the heterostructure of PdO nanoflakes and TiO2 nanoparticles
- 1 December 2012
- Published by Elsevier in Applied Surface Science
- Vol. 263, 345-351
Enhanced photocatalytic decomposition of methylene blue by the heterostructure of PdO nanoflakes and TiO2 nanoparticles
- 1 January 2011
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 158 (10) , H1017-H1020
Photovoltaic Performance of HWCVD Deposited μc-Si:H Solar Cells Using Graded Hydrogen Dilution Window-Layer
The study prepared thin film solar cells using hydrogenated microcrystalline silicon (μc-Si:H) by hot-wire chemical vapor deposition (HWCVD). Hydrogen dilution profiling was used to deposit the boron-doped p-layer on the SnO2:F substrate. The μc-Si:H solar cell with triple hydrogen dilution grades in the p-layer has a high photoconversion efficiency of 4.5% as a result of the improvement in the electrical and the antireflection properties of the cell. The short circuit current (Jsc) and the open circuit voltage (Voc) of the solar cell are 19.7 mA/cm2 and 450 mV, respectively. The graded hydrogen concentration in the p-layer improves the crystallinity and the antireflection of the absorbing layer (intrinsic layer), thereby enhancing the Jsc. The high Voc is ascribed to that a high hydrogen dilution ratio may enhance boron doping in the p-layer leading to the improvement of the Voc.
- 1 January 2011
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 158 (10) , H1017-H1020
Photovoltaic Performance of HWCVD Deposited μc-Si:H Solar Cells Using Graded Hydrogen Dilution Window-Layer
The study prepared thin film solar cells using hydrogenated microcrystalline silicon (μc-Si:H) by hot-wire chemical vapor deposition (HWCVD). Hydrogen dilution profiling was used to deposit the boron-doped p-layer on the SnO2:F substrate. The μc-Si:H solar cell with triple hydrogen dilution grades in the p-layer has a high photoconversion efficiency of 4.5% as a result of the improvement in the electrical and the antireflection properties of the cell. The short circuit current (Jsc) and the open circuit voltage (Voc) of the solar cell are 19.7 mA/cm2 and 450 mV, respectively. The graded hydrogen concentration in the p-layer improves the crystallinity and the antireflection of the absorbing layer (intrinsic layer), thereby enhancing the Jsc. The high Voc is ascribed to that a high hydrogen dilution ratio may enhance boron doping in the p-layer leading to the improvement of the Voc.
- 1 January 2011
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 158 (4) , G97-G102
In Situ Two-Step Plasma Enhanced Atomic Layer Deposition of Ru/RuNx Barriers for Seedless Copper Electroplating
The study prepared Ru/RuNx bilayer barriers on mesoporous SiO2 (mp-SiO2) dielectric layers for direct Cu electroplating applications using in situ two-step plasma-enhanced atomic chemical vapor deposition (PEALD). For the 5 nm thick Ru/RuNx bilayer deposited at 200°C, obvious thermal decomposition begins at temperatures lower than 400°C. Copper can be successfully electroplated on the as-deposited Ru/RuNx bilayer, and the Cu/Ru/RuNx/mp-SiO2 film stack can withstand thermal treatment at temperatures up to 500°C without significant physical and chemical degradations according to TEM and SIMS analyses. The study shows that the electroplated Cu layer behaves like a passivation layer that improves the thermal stability of the Ru/RuNx barrier during the thermal annealing. Pull-off tensile test shows that interfaces in the Cu/Ru/RuNx/mp-SiO2 film stack have good adhesion strength, but delamination occurs at the interface between the Ru/RuNx bilayer and the mp-SiO2 layer at 600°C, resulting in Cu and Ru diffusion into the dielectric layer. The study has demonstrated that the PEALD Ru/RuNx bilayer structure prepared using the in situ two-step approach is suitable for the seedless Cu electroplating process in nanometer scale interconnect technology.
- 1 January 2011
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 158 (4) , G97-G102
In Situ Two-Step Plasma Enhanced Atomic Layer Deposition of Ru/RuNx Barriers for Seedless Copper Electroplating
The study prepared Ru/RuNx bilayer barriers on mesoporous SiO2 (mp-SiO2) dielectric layers for direct Cu electroplating applications using in situ two-step plasma-enhanced atomic chemical vapor deposition (PEALD). For the 5 nm thick Ru/RuNx bilayer deposited at 200°C, obvious thermal decomposition begins at temperatures lower than 400°C. Copper can be successfully electroplated on the as-deposited Ru/RuNx bilayer, and the Cu/Ru/RuNx/mp-SiO2 film stack can withstand thermal treatment at temperatures up to 500°C without significant physical and chemical degradations according to TEM and SIMS analyses. The study shows that the electroplated Cu layer behaves like a passivation layer that improves the thermal stability of the Ru/RuNx barrier during the thermal annealing. Pull-off tensile test shows that interfaces in the Cu/Ru/RuNx/mp-SiO2 film stack have good adhesion strength, but delamination occurs at the interface between the Ru/RuNx bilayer and the mp-SiO2 layer at 600°C, resulting in Cu and Ru diffusion into the dielectric layer. The study has demonstrated that the PEALD Ru/RuNx bilayer structure prepared using the in situ two-step approach is suitable for the seedless Cu electroplating process in nanometer scale interconnect technology.