C. T. Foxon
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
C. T. Foxon has a total of 179 co-authors. Here are the top co-authors by number of shared publications:
- Sergei V. Novikov
School of Physics and Astronomy, University of Nottingham, Nottingham, UK
28 shared publications - Richard P. Campion
School of Physics and Astronomy, University of Nottingham , University Park, Nottingham NG7 2RD, United Kingdom
23 shared publications I. Harrison
School of Electrical and Electronic Engineering, University of Nottingham, Nottingham, NG7 2RD, UK
18 shared publicationsT. S. Cheng
School of Physics and Astronomy, University of Nottingham, Nottingham NG7 2RD, United Kingdom
10 shared publicationsA.J. Winser
Nottingham Univ., UK
8 shared publications- Anthony J. Kent
University of Nottingham
7 shared publications
Latest Publications
- Open Access
- 1 January 2014
- Published by Elsevier in Journal of Crystal Growth
- Vol. 386, 135-138
Molecular beam epitaxy of InN nanorods on Si- and C-faces of SiC substrates
- 1 January 2014
- Published by Elsevier in Journal of Crystal Growth
- Vol. 386, 135-138
Open AccessMolecular beam epitaxy of InN nanorods on Si- and C-faces of SiC substrates
- 21 December 2012
- Published by Wiley in physica status solidi (c)
- Vol. 10 (3) , 453-456
Microstructure of Mg doped GaNAs alloys
- 21 December 2012
- Published by Wiley in physica status solidi (c)
- Vol. 10 (3) , 453-456
Microstructure of Mg doped GaNAs alloys
- Open Access
- 1 September 2012
- Published by Elsevier in Journal of Crystal Growth
- Vol. 354 (1) , 44-48
Plasma-assisted electroepitaxy of GaN layers from the liquid Ga melt
- 1 September 2012
- Published by Elsevier in Journal of Crystal Growth
- Vol. 354 (1) , 44-48
Open AccessPlasma-assisted electroepitaxy of GaN layers from the liquid Ga melt
- 14 May 2012
- Published by Wiley in physica status solidi (c)
- Vol. 9 (7) , 1586-1589
Structural studies of GaN1‐x Asx and GaN1‐x Bix alloys for solar cell applications
- 14 May 2012
- Published by Wiley in physica status solidi (c)
- Vol. 9 (7) , 1586-1589
Structural studies of GaN1‐x Asx and GaN1‐x Bix alloys for solar cell applications
- 14 March 2011
- Published by Wiley in physica status solidi (c)
- Vol. 8 (5) , 1439-1444
Zinc‐blende (cubic) GaN bulk crystals grown by molecular beam epitaxy
- 14 March 2011
- Published by Wiley in physica status solidi (c)
- Vol. 8 (5) , 1439-1444
Zinc‐blende (cubic) GaN bulk crystals grown by molecular beam epitaxy
- 4 October 2010
- Published by AIP Publishing in Applied Physics Letters
- Vol. 97 (14) , 141919
GaN1−xBix: Extremely mismatched semiconductor alloys
Through nonequilibrium low-temperature molecular beam epitaxy, we have grown alloys on sapphire substrates with up to 0.11. The alloys are found to be amorphous with GaN crystals distributed throughout the film. A dramatic reduction in the optical band gap from 3.4 eV in GaN to as low as 1.2 eV for was qualitatively explained by formation of a narrow band originating from anticrossing interaction between Bi localized states and the extended states of the GaN matrix.- 4 October 2010
- Published by AIP Publishing in Applied Physics Letters
- Vol. 97 (14) , 141919
GaN1−xBix: Extremely mismatched semiconductor alloys
Through nonequilibrium low-temperature molecular beam epitaxy, we have grown alloys on sapphire substrates with up to 0.11. The alloys are found to be amorphous with GaN crystals distributed throughout the film. A dramatic reduction in the optical band gap from 3.4 eV in GaN to as low as 1.2 eV for was qualitatively explained by formation of a narrow band originating from anticrossing interaction between Bi localized states and the extended states of the GaN matrix.- 26 March 2010
- Published by American Vacuum Society in Journal of Vacuum Science & Technology B
- Vol. 28 (3) , C3F1-C3F4
Modulated beam mass spectrometer studies of a Mark V Veeco cracker
Mass spectrometer studies provide a powerful means to evaluate both the major species coming from a Knudsen source used for molecular beam epitaxy and also impurities, which may be detrimental to device performance. To distinguish signals from the source from those due to background gases in the ultrahigh vacuum system it is essential to have direct line of sight from the source to the ionizer of the mass spectrometer. For condensable species this criterion combined with a liquid nitrogen cryopanel is sufficient to ensure the species detected come from the source. However, for volatile species, such as arsenic, this is not the case and to adequately identify material from the source it is necessary to use modulated beam mass spectrometer studies as has previously been demonstrated in studies of the evaporation of GaAs [C. T. Foxon et al., J. Phys. Chem. Solids34, 1693 (1973)]. The authors have recently constructed a new version of this apparatus using a Hiden HAL IV mass spectrometer, which has both pre and postfilters to improve transmission and sensitivity at high mass numbers. The new apparatus has several improvements compared to the original system used by one of the authors. In particular, in addition to the improved intrinsic sensitivity of the mass spectrometer, it is now possible to tune the electron ionization energy to a low enough value to prevent cracking of species within the ionizer of the mass spectrometer, thus simplifying the interpretation of the data. This new system has been used to study the performance of a Veeco Mark V arsenic valved cracker equipped with a variety of different baffles. In all cases, at a sufficiently high temperature of the hot (cracker) zone, complete decomposition of the arsenic from tetramers ( As 4 ) to dimers ( As 2 ) is achieved. Surprisingly, the source with an open tube achieves significant cracking at very low cracker temperatures. In this case the flux would not be sufficiently uniform over the area of a growth sample, so additional beam forming apertures or a series of baffle plates are typically used to alleviate this situation. With such apertures or baffles present, complete decomposition can also be achieved, but at a slightly higher operating temperature, suggesting some recombination takes place. In this article, the authors concentrate on baffle assemblies that will be familiar to users of most of the current models of cracker in service today. Aperture plates of various designs will be the subject of future work.
- 26 March 2010
- Published by American Vacuum Society in Journal of Vacuum Science & Technology B
- Vol. 28 (3) , C3F1-C3F4
Modulated beam mass spectrometer studies of a Mark V Veeco cracker
Mass spectrometer studies provide a powerful means to evaluate both the major species coming from a Knudsen source used for molecular beam epitaxy and also impurities, which may be detrimental to device performance. To distinguish signals from the source from those due to background gases in the ultrahigh vacuum system it is essential to have direct line of sight from the source to the ionizer of the mass spectrometer. For condensable species this criterion combined with a liquid nitrogen cryopanel is sufficient to ensure the species detected come from the source. However, for volatile species, such as arsenic, this is not the case and to adequately identify material from the source it is necessary to use modulated beam mass spectrometer studies as has previously been demonstrated in studies of the evaporation of GaAs [C. T. Foxon et al., J. Phys. Chem. Solids34, 1693 (1973)]. The authors have recently constructed a new version of this apparatus using a Hiden HAL IV mass spectrometer, which has both pre and postfilters to improve transmission and sensitivity at high mass numbers. The new apparatus has several improvements compared to the original system used by one of the authors. In particular, in addition to the improved intrinsic sensitivity of the mass spectrometer, it is now possible to tune the electron ionization energy to a low enough value to prevent cracking of species within the ionizer of the mass spectrometer, thus simplifying the interpretation of the data. This new system has been used to study the performance of a Veeco Mark V arsenic valved cracker equipped with a variety of different baffles. In all cases, at a sufficiently high temperature of the hot (cracker) zone, complete decomposition of the arsenic from tetramers ( As 4 ) to dimers ( As 2 ) is achieved. Surprisingly, the source with an open tube achieves significant cracking at very low cracker temperatures. In this case the flux would not be sufficiently uniform over the area of a growth sample, so additional beam forming apertures or a series of baffle plates are typically used to alleviate this situation. With such apertures or baffles present, complete decomposition can also be achieved, but at a slightly higher operating temperature, suggesting some recombination takes place. In this article, the authors concentrate on baffle assemblies that will be familiar to users of most of the current models of cracker in service today. Aperture plates of various designs will be the subject of future work.
- 15 March 2010
- Published by Elsevier in Journal of Crystal Growth
- Vol. 312 (7) , 1029-1035
A theoretical model for the MBE growth of AlGaAsN using ammonia as the N source
- 15 March 2010
- Published by Elsevier in Journal of Crystal Growth
- Vol. 312 (7) , 1029-1035
A theoretical model for the MBE growth of AlGaAsN using ammonia as the N source
- 14 January 2010
- Published by American Physical Society (APS) in Physical Review B
- Vol. 81 (3)
Using randomly distributed charges to create quantum dots
Using a combination of modeling and tunneling spectroscopy, we investigate how electrostatic potential fluctuations generated by randomly distributed ionized donors close to a quantum well can produce deep and strongly confined quantum-dot-like potential minima with a rich spectrum of zero-dimensional electronic energy levels. We consider different types of random distribution of donors and how the electronic properties can be controlled and investigated in appropriately designed double barrier resonant tunneling diodes.
- 14 January 2010
- Published by American Physical Society (APS) in Physical Review B
- Vol. 81 (3)
Using randomly distributed charges to create quantum dots
Using a combination of modeling and tunneling spectroscopy, we investigate how electrostatic potential fluctuations generated by randomly distributed ionized donors close to a quantum well can produce deep and strongly confined quantum-dot-like potential minima with a rich spectrum of zero-dimensional electronic energy levels. We consider different types of random distribution of donors and how the electronic properties can be controlled and investigated in appropriately designed double barrier resonant tunneling diodes.
- 1 January 2009
- Published by Springer Nature in MRS Proceedings
- Vol. 1167
Growth by Molecular Beam Epitaxy of GaNAs Alloys with High As Content for Potential Photoanode Applications in Hydrogen Production
- 1 January 2009
- Published by Springer Nature in MRS Proceedings
- Vol. 1167
Growth by Molecular Beam Epitaxy of GaNAs Alloys with High As Content for Potential Photoanode Applications in Hydrogen Production