Francesco Carrara
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Francesco Carrara has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
G. Palmisano
Facolta di Ingegneria, Catania Univ., Italy
2 shared publications- Giuseppe Palmisano
Dipartimento di Ingegneria Elettrica Elettronica e dei Sistemi, Facoltà di Ingegneria, Università di Catania, V.le. A. Doria 6, 95125, Catania, Italia
2 shared publications - Angelo Scuderi
STMicroelectronics, Str.le Primosole 50, 95121, Catania, Italia
1 shared publication - Angelo Scuderi
LCD Onlus
1 shared publication - Antonino Scuderi
STMicroelectronics, Stradale Primosole 50, 95121 Catania, Italy
1 shared publication C.D. Presti
Department of Electrical and Computer Engineering, University of California at San Diego, 9500 Gilman Drive, La Jolla, CA 92093-0407, USA
1 shared publication
Latest Publications
- 1 September 2010
- Published by Elsevier in Solid-State Electronics
- Vol. 54 (9) , 957-964
Single-transistor latch-up and large-signal reliability in SOI CMOS RF power transistors
- 1 September 2010
- Published by Elsevier in Solid-State Electronics
- Vol. 54 (9) , 957-964
Single-transistor latch-up and large-signal reliability in SOI CMOS RF power transistors
- 7 August 2009
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 57 (9) , 2122-2130
A 2.4-GHz 24-dBm SOI CMOS Power Amplifier With Fully Integrated Reconfigurable Output Matching Network
In this paper, the potential of load adaptation for enhanced backoff efficiency in RF power amplifiers (PAs) has been investigated through a 0.13-mum silicon-on-insulator (SOI) CMOS fabrication technology. The RF power performance of the adopted SOI CMOS process has been preliminarily characterized by on-wafer load-pull measurements on a custom unit power transistor. A 2.4-GHz 24-dBm 2-V SOI CMOS PA with fully integrated reconfigurable output matching network has then been designed and experimentally characterized. A significant efficiency improvement of up to 34% has been achieved through load adaptation, peak efficiency being as high as 65%. Linear operation has also been demonstrated under two-tone excitation, as a 16-dBm output power has been attained while complying with a - 40-dBc third-order intermodulation distortion specification.
- 7 August 2009
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 57 (9) , 2122-2130
A 2.4-GHz 24-dBm SOI CMOS Power Amplifier With Fully Integrated Reconfigurable Output Matching Network
In this paper, the potential of load adaptation for enhanced backoff efficiency in RF power amplifiers (PAs) has been investigated through a 0.13-mum silicon-on-insulator (SOI) CMOS fabrication technology. The RF power performance of the adopted SOI CMOS process has been preliminarily characterized by on-wafer load-pull measurements on a custom unit power transistor. A 2.4-GHz 24-dBm 2-V SOI CMOS PA with fully integrated reconfigurable output matching network has then been designed and experimentally characterized. A significant efficiency improvement of up to 34% has been achieved through load adaptation, peak efficiency being as high as 65%. Linear operation has also been demonstrated under two-tone excitation, as a 16-dBm output power has been attained while complying with a - 40-dBc third-order intermodulation distortion specification.
- 1 May 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 02714302,p. 3884-3887
Fast Peak Detector with Improved Accuracy and Linearity for High-Frequency Waveform Processing
A novel peak detection technique and its integrated circuit implementation are presented. In high-frequency circuits it is often required to know with precision and linearity the peak value of a voltage waveform, in order to compare it with a reference value and act accordingly. The classic peak detectors underestimate the peak value of sharp-peaked signals, and are affected by non-linearity. These limitations can be traded-off with detection speed. The proposed solution improves both linearity and accuracy without compromising speed. This is accomplished by properly combining the output signals of two fast peak detectors. Results show a 3times improvement in detection accuracy.
- 1 May 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 02714302,p. 3884-3887
Fast Peak Detector with Improved Accuracy and Linearity for High-Frequency Waveform Processing
A novel peak detection technique and its integrated circuit implementation are presented. In high-frequency circuits it is often required to know with precision and linearity the peak value of a voltage waveform, in order to compare it with a reference value and act accordingly. The classic peak detectors underestimate the peak value of sharp-peaked signals, and are affected by non-linearity. These limitations can be traded-off with detection speed. The proposed solution improves both linearity and accuracy without compromising speed. This is accomplished by properly combining the output signals of two fast peak detectors. Results show a 3times improvement in detection accuracy.
- 27 July 2005
- Published by Institute of Electrical and Electronics Engineers (IEEE)
Silicon Bipolar Linear Power Amplifier for WCDMA Mobile Applications
A monolithic 1.9-GHz linear power amplifier for wideband code-division multiple access wireless transmitters was integrated using a low-cost pure-silicon bipolar process. At a 3.3-V supply voltage, the circuit exhibits a 31-dBm saturated output power, 57% maximum power-added efficiency, and 29-dBm output 1-dB compression point, while using a low quiescent current of 80 mA. Thanks to a linearizing bias network, the power amplifier is able to comply with the standard -33-dBc adjacent-channel leakage power ratio specification up to a 28.3-dBm output power level. The circuit also features temperature-stable RF gain as well as quiescent current control and shut-down functionalities.
- 27 July 2005
- Published by Institute of Electrical and Electronics Engineers (IEEE)
Silicon Bipolar Linear Power Amplifier for WCDMA Mobile Applications
A monolithic 1.9-GHz linear power amplifier for wideband code-division multiple access wireless transmitters was integrated using a low-cost pure-silicon bipolar process. At a 3.3-V supply voltage, the circuit exhibits a 31-dBm saturated output power, 57% maximum power-added efficiency, and 29-dBm output 1-dB compression point, while using a low quiescent current of 80 mA. Thanks to a linearizing bias network, the power amplifier is able to comply with the standard -33-dBc adjacent-channel leakage power ratio specification up to a 28.3-dBm output power level. The circuit also features temperature-stable RF gain as well as quiescent current control and shut-down functionalities.
- 27 July 2005
- Published by Institute of Electrical and Electronics Engineers (IEEE)
Variable-Gain Up-Converter with Current Reuse for WCDMA Wireless Transmitters
In this paper a variable-gain up-conversion mixer based on a novel variable-transconductance input stage is presented. The proposed topology allows dc current reuse and reduces the overall transmitter power consumption in wideband code-division multiple access applications. Temperature compensation and decibel-linear characteristic are achieved by means of a control circuit providing a lower than /spl plusmn/1 dB gain error over a 46-dB dynamic range. A 3-dBm output compression point, 13-dB noise figure, and -45-dB adjacent-channel leakage power ratio are obtained under maximum gain conditions.
- 27 July 2005
- Published by Institute of Electrical and Electronics Engineers (IEEE)
Variable-Gain Up-Converter with Current Reuse for WCDMA Wireless Transmitters
In this paper a variable-gain up-conversion mixer based on a novel variable-transconductance input stage is presented. The proposed topology allows dc current reuse and reduces the overall transmitter power consumption in wideband code-division multiple access applications. Temperature compensation and decibel-linear characteristic are achieved by means of a control circuit providing a lower than /spl plusmn/1 dB gain error over a 46-dB dynamic range. A 3-dBm output compression point, 13-dB noise figure, and -45-dB adjacent-channel leakage power ratio are obtained under maximum gain conditions.