Ghislain Tchuen
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Ghislain Tchuen has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
David E. Zeitoun
Ecole Polytechnique Universitaire de Marseille , DME, 5 rue Enrico Fermi, Technopole de Chateau Gombert, 13453, Marseille Cedex 13, France
2 shared publicationsYves Burtschell
Ecole Polytechnique Universitaire de Marseille , DME, 5 rue Enrico Fermi, Technopole de Chateau Gombert, 13453, Marseille Cedex 13, France
2 shared publications- Yves Burtschell
Ecole Polytechnique Universitaire de Marseille-DME, IUSTI, UMR 6595, Université de Provence, Marseille, France
2 shared publications - Aymar Kouam
GEEA, ENSAI Ngaoundéré, Université de Ngaoundéré, B.P. 455, Ngaoundéré-Cameroun
1 shared publication Ferdinand Fogang
1 shared publication- Fohagui Fodoup Cyrille Vincelas
Department of Electrical and Electronics Engineering, College of Technology, The University of Bamenda, Bambili P.O. Box 39, Cameroon
1 shared publication
Latest Publications
- Open Access
- 18 October 2023
- Published by Centre de Developpement des Energie Renouvelables in Journal of Renewable Energies
- Vol. 18 (4)
Optimisation d’un système hybride de production d’énergie pour site isolé: cas de la ville de Ngaoundéré
Ce travail, présente l’optimisation d’un système éolien-photovoltaïque-micro-turbine à gaz avec batterie pour l’électrification des populations n’ayant pas accès au réseau électrique. Les résultats de simulation montrent que l’insertion de la micro-turbine à gaz permet de réduire les émissions de gaz polluants de manière significative par rapport au système à générateur diesel.
- 18 October 2023
- Published by Centre de Developpement des Energie Renouvelables in Journal of Renewable Energies
- Vol. 18 (4)
Open AccessOptimisation d’un système hybride de production d’énergie pour site isolé: cas de la ville de Ngaoundéré
Ce travail, présente l’optimisation d’un système éolien-photovoltaïque-micro-turbine à gaz avec batterie pour l’électrification des populations n’ayant pas accès au réseau électrique. Les résultats de simulation montrent que l’insertion de la micro-turbine à gaz permet de réduire les émissions de gaz polluants de manière significative par rapport au système à générateur diesel.
- 6 August 2021
- Published by Springer Nature in Sādhanā
- Vol. 46 (3) , 1-18
Experimental comparison of energy performances of common types of buildings constructed in Cameroon and validation of their electrical model
- 6 August 2021
- Published by Springer Nature in Sādhanā
- Vol. 46 (3) , 1-18
Experimental comparison of energy performances of common types of buildings constructed in Cameroon and validation of their electrical model
- 22 May 2017
- Published by Taylor & Francis in International Journal of Ambient Energy
- Vol. 39 (6) , 637-648
A numerical investigation of three different thermosyphon solar water heating systems
This work presents a theoretical evaluation of the performance of three types of thermosyphon solar water heating (TSWH) systems with flat-plate collectors considering different weather conditions. The flat-plate solar collectors considered are the absorber–pipe lower bond configuration (Type I), the absorber–pipe side bond configuration (Type II) and the absorber–pipe upper bond configuration (Type III). The performance of the three heaters have been investigated numerically under the same conditions. The average values of the energetic and exergetic efficiencies, for one of the weather conditions are: 39.47% and 18.21% for Type I, 34.86% and 15.45% for Type II, 32.28% and 13.8% for Type III. This study reveals that, the thermal performances obtained with Type I TSWH is always greater than the two others, and that this configuration leads to an improvement in the efficiency–temperature rise couple, followed by Type II TSWH system.
- 22 May 2017
- Published by Taylor & Francis in International Journal of Ambient Energy
- Vol. 39 (6) , 637-648
A numerical investigation of three different thermosyphon solar water heating systems
This work presents a theoretical evaluation of the performance of three types of thermosyphon solar water heating (TSWH) systems with flat-plate collectors considering different weather conditions. The flat-plate solar collectors considered are the absorber–pipe lower bond configuration (Type I), the absorber–pipe side bond configuration (Type II) and the absorber–pipe upper bond configuration (Type III). The performance of the three heaters have been investigated numerically under the same conditions. The average values of the energetic and exergetic efficiencies, for one of the weather conditions are: 39.47% and 18.21% for Type I, 34.86% and 15.45% for Type II, 32.28% and 13.8% for Type III. This study reveals that, the thermal performances obtained with Type I TSWH is always greater than the two others, and that this configuration leads to an improvement in the efficiency–temperature rise couple, followed by Type II TSWH system.
- 21 April 2015
- Published by Taylor & Francis in International Journal of Sustainable Energy
- Vol. 36 (5) , 430-449
Comparative study of three thermosyphon solar water heaters made of flat-plate collectors with different absorber configurations
The paper presents a comparative study of three solar water heaters made of flat-plate collectors with different absorber configurations. The performance of the three solar water heaters is assessed under the same conditions. The collectors have the same surface area and are glazed. The theoretical model for each collector type, with the transient effects taken into account, is based on a control volume. By considering a small element of the collector in each case and the storage tank, six partial differential equations were developed for each solar water heater and were solved numerically for a cloudy day. This study shows that the thermal performance obtained with the solar water heater using the absorber-pipe lower bond configuration in the solar collector is always greater than the two others. These results showed that the solar water heater made of the absorber-pipe lower bond configuration is more efficient than the other systems.
- 21 April 2015
- Published by Taylor & Francis in International Journal of Sustainable Energy
- Vol. 36 (5) , 430-449
Comparative study of three thermosyphon solar water heaters made of flat-plate collectors with different absorber configurations
The paper presents a comparative study of three solar water heaters made of flat-plate collectors with different absorber configurations. The performance of the three solar water heaters is assessed under the same conditions. The collectors have the same surface area and are glazed. The theoretical model for each collector type, with the transient effects taken into account, is based on a control volume. By considering a small element of the collector in each case and the storage tank, six partial differential equations were developed for each solar water heater and were solved numerically for a cloudy day. This study shows that the thermal performance obtained with the solar water heater using the absorber-pipe lower bond configuration in the solar collector is always greater than the two others. These results showed that the solar water heater made of the absorber-pipe lower bond configuration is more efficient than the other systems.
- 1 February 2014
- Published by Elsevier in Computer Physics Communications
- Vol. 185 (2) , 479-488
A hybrid numerical method and its application to inviscid compressible flow problems
- 1 February 2014
- Published by Elsevier in Computer Physics Communications
- Vol. 185 (2) , 479-488
A hybrid numerical method and its application to inviscid compressible flow problems
- Open Access
- 12 September 2011
- Published by IntechOpen
Physico - Chemical Modelling in Nonequilibrium Hypersonic Flow Around Blunt Bodies
- 12 September 2011
- Published by IntechOpen
Open AccessPhysico - Chemical Modelling in Nonequilibrium Hypersonic Flow Around Blunt Bodies
- 1 May 2008
- Published by Taylor & Francis in International Journal of Computational Fluid Dynamics
- Vol. 22 (4) , 209-220
Computation of non-equilibrium hypersonic flow with artificially upstream flux vector splitting (AUFS) schemes
The AUFS scheme has been presented for solving the Euler equations [Sun, M., Takayama, K., 2003. An artificially upstream flux vector splitting scheme for the Euler equations. Journal of Computational Physics, 189, 305–329]. An extension of this high resolution scheme-based on upwind numerical methods has been developed to calculate a two-dimensional hypersonic viscous flowfield in thermochemical non-equilibrium. The time-dependent Navier–Stokes governing equations are computed by using a multi-block finite volume technique on a structured mesh. The convective fluxes at the interfaces are evaluated using a flux vector splitting (FVS) method with a second-order reconstruction of the interface values and the viscous terms are discretised by second-order central differences. A better evaluation of aerodynamic parameters are obtained with this AUFS scheme and they are also compared to those obtained by previous works. The freestream flow conditions of these computations correspond to high-enthalpy flows with a Mach number range between 6.4 and 25.9. The obtained numerical results indicate that the AUFS scheme is accurate, robust, and efficient for the calculation of hypersonic flow.
- 1 May 2008
- Published by Taylor & Francis in International Journal of Computational Fluid Dynamics
- Vol. 22 (4) , 209-220
Computation of non-equilibrium hypersonic flow with artificially upstream flux vector splitting (AUFS) schemes
The AUFS scheme has been presented for solving the Euler equations [Sun, M., Takayama, K., 2003. An artificially upstream flux vector splitting scheme for the Euler equations. Journal of Computational Physics, 189, 305–329]. An extension of this high resolution scheme-based on upwind numerical methods has been developed to calculate a two-dimensional hypersonic viscous flowfield in thermochemical non-equilibrium. The time-dependent Navier–Stokes governing equations are computed by using a multi-block finite volume technique on a structured mesh. The convective fluxes at the interfaces are evaluated using a flux vector splitting (FVS) method with a second-order reconstruction of the interface values and the viscous terms are discretised by second-order central differences. A better evaluation of aerodynamic parameters are obtained with this AUFS scheme and they are also compared to those obtained by previous works. The freestream flow conditions of these computations correspond to high-enthalpy flows with a Mach number range between 6.4 and 25.9. The obtained numerical results indicate that the AUFS scheme is accurate, robust, and efficient for the calculation of hypersonic flow.
- 1 January 2006
- Published by EDP Sciences in Mécanique & Industries
- Vol. 7 (1) , 87-95
Étude numérique d'un écoulement externe faiblement ionisé en non-équilibre chimique, vibrationnel et électronique
Mechanics & Industry, An International Journal on Mechanical Sciences and Engineering Applications
- 1 January 2006
- Published by EDP Sciences in Mécanique & Industries
- Vol. 7 (1) , 87-95
Étude numérique d'un écoulement externe faiblement ionisé en non-équilibre chimique, vibrationnel et électronique
Mechanics & Industry, An International Journal on Mechanical Sciences and Engineering Applications