Keizo Ugai
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Keizo Ugai has a total of 39 co-authors. Here are the top co-authors by number of shared publications:
- Aly Ahmed
Beni-Suef University
7 shared publications - Akihiko Wakai
Gunma University
6 shared publications - Fei Cai
Gunma University
4 shared publications - Takeshi Kamei
Department of Civil and Environmental Engineering, University of Miyazaki
4 shared publications - Akihiko Wakai
Gunma University
3 shared publications - Fei Cai
Gunma University
3 shared publications
Latest Publications
- 20 April 2014
- Published by Springer Nature in Journal of Material Cycles and Waste Management
- Vol. 17 (2) , 380-390
A novel solidification technique for fluorine-contaminated bassanite using waste materials in ground improvement applications
- 20 April 2014
- Published by Springer Nature in Journal of Material Cycles and Waste Management
- Vol. 17 (2) , 380-390
A novel solidification technique for fluorine-contaminated bassanite using waste materials in ground improvement applications
- 6 February 2013
- Published by Springer Nature
- p. 185-189
Mechanism of Landslide Composed of Strongly Weathered Mudstone Induced by the 2004 Mid-Niigata Earthquake
- 6 February 2013
- Published by Springer Nature
- p. 185-189
Mechanism of Landslide Composed of Strongly Weathered Mudstone Induced by the 2004 Mid-Niigata Earthquake
- 25 October 2012
- Published by Springer Nature
- p. 609-615
Three-Dimensional Virtual Reality Modeling of the Cikangkareng Rock Avalanche in Indonesia
- 25 October 2012
- Published by Springer Nature
- p. 609-615
Three-Dimensional Virtual Reality Modeling of the Cikangkareng Rock Avalanche in Indonesia
- 25 October 2012
- Published by Springer Nature
- p. 599-608
Numerical Analysis of Two Wooden House Damages Induced by Dune Liquefaction During 2007 Niigata Chuetsu-Offshore Earthquake
- 25 October 2012
- Published by Springer Nature
- p. 599-608
Numerical Analysis of Two Wooden House Damages Induced by Dune Liquefaction During 2007 Niigata Chuetsu-Offshore Earthquake
- 25 October 2012
- Published by Springer Nature
- p. 495-500
Three-Dimensional Stability Analysis for Evaluation of Drainage Effect for Earthquake-Triggered Large Landslides
- 25 October 2012
- Published by Springer Nature
- p. 495-500
Three-Dimensional Stability Analysis for Evaluation of Drainage Effect for Earthquake-Triggered Large Landslides
- 25 October 2012
- Published by Springer Nature
- p. 253-260
On the Tasikmalaya Earthquake Induced Landslide in Indonesia: Field Investigation
- 25 October 2012
- Published by Springer Nature
- p. 253-260
On the Tasikmalaya Earthquake Induced Landslide in Indonesia: Field Investigation
- 25 October 2012
- Published by Springer Nature
- p. 591-597
Fully Coupled Dynamic Effective Stress Analysis of the Nigiri Landslide Triggered by 2004 Niigata-Chuetsu Earthquake
- 25 October 2012
- Published by Springer Nature
- p. 591-597
Fully Coupled Dynamic Effective Stress Analysis of the Nigiri Landslide Triggered by 2004 Niigata-Chuetsu Earthquake
- 13 September 2012
- Published by Taylor & Francis
- p. 272-280
Performance assessment of clay soil stabilized with recycled gypsum based on SEM and XRD
- 13 September 2012
- Published by Taylor & Francis
- p. 272-280
Performance assessment of clay soil stabilized with recycled gypsum based on SEM and XRD
- 16 May 2011
- Published by American Society of Civil Engineers (ASCE)
- p. 173-179
Key Technologies of Dynamic Flume Test for Earthquake Induced Rock Avalanches
Model test plays an important role in the research of rock avalanches. However, there is a problem that test results are sometimes too scattered to establish a trend. A series of small-scale flume tests on shaking table were conducted to analyze the influencing effects of dynamic factors acting on the rock avalanches, and the similar problem was found. Efforts were paid to obtain much more reasonable test results by adopting adjustments for operations, especially those that would affect the test results with high sensitivity. It was found that releasing geometry performed a much more obvious influence on the results in the dynamic tests than in the static tests and acquired a sample emplacement method with higher standard. Some individual particles would be forced out of the flume by shaking, with much higher speed than in static tests. Attention should be paid to recycle these particles, or it would result in shorter run-out in the next tests. Besides, attentions were suggested to pay in many manual operations which were regards as key technologies of the tests, such as sample arrangement, vibration applying and sample releasing, run-out measurement, et al. The introductions of the operating techniques in our tests would form a basis for future test design and help to understand the mechanism of earthquake induced rock avalanches.
- 16 May 2011
- Published by American Society of Civil Engineers (ASCE)
- p. 173-179
Key Technologies of Dynamic Flume Test for Earthquake Induced Rock Avalanches
Model test plays an important role in the research of rock avalanches. However, there is a problem that test results are sometimes too scattered to establish a trend. A series of small-scale flume tests on shaking table were conducted to analyze the influencing effects of dynamic factors acting on the rock avalanches, and the similar problem was found. Efforts were paid to obtain much more reasonable test results by adopting adjustments for operations, especially those that would affect the test results with high sensitivity. It was found that releasing geometry performed a much more obvious influence on the results in the dynamic tests than in the static tests and acquired a sample emplacement method with higher standard. Some individual particles would be forced out of the flume by shaking, with much higher speed than in static tests. Attention should be paid to recycle these particles, or it would result in shorter run-out in the next tests. Besides, attentions were suggested to pay in many manual operations which were regards as key technologies of the tests, such as sample arrangement, vibration applying and sample releasing, run-out measurement, et al. The introductions of the operating techniques in our tests would form a basis for future test design and help to understand the mechanism of earthquake induced rock avalanches.