Noureddine Dechemi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Noureddine Dechemi has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- Salim Heddam
Faculty of Science, Agronomy Department, Hydraulics Division, University 20 Août 1955 Skikda, Skikda, Algeria
3 shared publications - Abdelmalek Bermad
Assistant Professor, Faculty of Science, Agronomy Dept., Univ. 20 Août 1955, Route El Hadaik, BP 26, Skikda, Algeria
2 shared publications Bachir Achour
Research Laboratory in Subterranean and Surface hydraulics, University of Biskra, Algeria
1 shared publication- Larbi Houichi
Hydraulics Department, Faculty of Technology, University of Batna, Batna, Algeria
1 shared publication
Latest Publications
- 21 September 2012
- Published by IWA Publishing in Journal of Hydroinformatics
- Vol. 15 (1) , 147-154
An evaluation of ANN methods for estimating the lengths of hydraulic jumps in U-shaped channel
Modelling of hydraulic characteristics of jump using theoretical and empirical models has always been a difficult task. The length of jump may be defined as the distance measured from the toe of the jump to the location of the surface rise. Due to high turbulence this length cannot be determined easily by theory. However, it has been investigated experimentally so as to design the stilling basins with hydraulic jumps. In this work, the control of a hydraulic jump by broad-crested sills in a U-shaped channel is recalled theoretically and experimentally examined. The study begins with a multiple regression (MR) analysis. Then, and in order to model the relative lengths of hydraulic jumps, we have implemented and evaluated two different artificial neural networks (ANN): multilayer perceptron neural network (MLPNN) and generalized regression neural network (GRNN). The results demonstrate the predictive strength of GRNN and its potential to predict hydraulic problems with an adaptive spread value. However, the MLPNN model remains best classified by these indexes of performance.
- 21 September 2012
- Published by IWA Publishing in Journal of Hydroinformatics
- Vol. 15 (1) , 147-154
An evaluation of ANN methods for estimating the lengths of hydraulic jumps in U-shaped channel
Modelling of hydraulic characteristics of jump using theoretical and empirical models has always been a difficult task. The length of jump may be defined as the distance measured from the toe of the jump to the location of the surface rise. Due to high turbulence this length cannot be determined easily by theory. However, it has been investigated experimentally so as to design the stilling basins with hydraulic jumps. In this work, the control of a hydraulic jump by broad-crested sills in a U-shaped channel is recalled theoretically and experimentally examined. The study begins with a multiple regression (MR) analysis. Then, and in order to model the relative lengths of hydraulic jumps, we have implemented and evaluated two different artificial neural networks (ANN): multilayer perceptron neural network (MLPNN) and generalized regression neural network (GRNN). The results demonstrate the predictive strength of GRNN and its potential to predict hydraulic problems with an adaptive spread value. However, the MLPNN model remains best classified by these indexes of performance.
- 1 December 2011
- Published by American Society of Civil Engineers (ASCE) in Journal of Environmental Engineering
- Vol. 137 (12) , 1209-1214
Applications of Radial-Basis Function and Generalized Regression Neural Networks for Modeling of Coagulant Dosage in a Drinking Water-Treatment Plant: Comparative Study
The coagulation process, which involves many complex physical and chemical phenomena, is one of the most important stages in water-treatment plants. The coagulant dosage rate is nonlinearly correlated to raw water characteristics such as turbidity, conductivity, and pH. The coagulation reaction is hard or even impossible to control satisfactorily by conventional methods. The coagulant dosage has typically been determined through the jar test, which requires a long experiment time in a field-water-treatment plant. Modeling can be used to overcome these limitations. In this study, a model for the approximation of coagulant dosage rates in water-treatment plants in Algeria has been developed using artificial neural network (ANN) techniques. Two different ANN techniques, the generalized regression neural network (GRNN) and the radial-basis function neural network (RBFNN), were tested for this purpose. The trained GRNN model outperforms the corresponding RBFNN model.
- 1 December 2011
- Published by American Society of Civil Engineers (ASCE) in Journal of Environmental Engineering
- Vol. 137 (12) , 1209-1214
Applications of Radial-Basis Function and Generalized Regression Neural Networks for Modeling of Coagulant Dosage in a Drinking Water-Treatment Plant: Comparative Study
The coagulation process, which involves many complex physical and chemical phenomena, is one of the most important stages in water-treatment plants. The coagulant dosage rate is nonlinearly correlated to raw water characteristics such as turbidity, conductivity, and pH. The coagulation reaction is hard or even impossible to control satisfactorily by conventional methods. The coagulant dosage has typically been determined through the jar test, which requires a long experiment time in a field-water-treatment plant. Modeling can be used to overcome these limitations. In this study, a model for the approximation of coagulant dosage rates in water-treatment plants in Algeria has been developed using artificial neural network (ANN) techniques. Two different ANN techniques, the generalized regression neural network (GRNN) and the radial-basis function neural network (RBFNN), were tested for this purpose. The trained GRNN model outperforms the corresponding RBFNN model.
- 12 May 2011
- Published by Springer Nature in Environmental Monitoring and Assessment
- Vol. 184 (4) , 1953-1971
ANFIS-based modelling for coagulant dosage in drinking water treatment plant: a case study
Coagulation is the most important stage in drinking water treatment processes for the maintenance of acceptable treated water quality and economic plant operation, which involves many complex physical and chemical phenomena. Moreover, coagulant dosing rate is non-linearly correlated to raw water characteristics such as turbidity, conductivity, pH, temperature, etc. As such, coagulation reaction is hard or even impossible to control satisfactorily by conventional methods. Traditionally, jar tests are used to determine the optimum coagulant dosage. However, this is expensive and time-consuming and does not enable responses to changes in raw water quality in real time. Modelling can be used to overcome these limitations. In this study, an Adaptive Neuro-Fuzzy Inference System (ANFIS) was used for modelling of coagulant dosage in drinking water treatment plant of Boudouaou, Algeria. Six on-line variables of raw water quality including turbidity, conductivity, temperature, dissolved oxygen, ultraviolet absorbance, and the pH of water, and alum dosage were used to build the coagulant dosage model. Two ANFIS-based Neuro-fuzzy systems are presented. The two Neuro-fuzzy systems are: (1) grid partition-based fuzzy inference system (FIS), named ANFIS-GRID, and (2) subtractive clustering based (FIS), named ANFIS-SUB. The low root mean square error and high correlation coefficient values were obtained with ANFIS-SUB method of a first-order Sugeno type inference. This study demonstrates that ANFIS-SUB outperforms ANFIS-GRID due to its simplicity in parameter selection and its fitness in the target problem.
- 12 May 2011
- Published by Springer Nature in Environmental Monitoring and Assessment
- Vol. 184 (4) , 1953-1971
ANFIS-based modelling for coagulant dosage in drinking water treatment plant: a case study
Coagulation is the most important stage in drinking water treatment processes for the maintenance of acceptable treated water quality and economic plant operation, which involves many complex physical and chemical phenomena. Moreover, coagulant dosing rate is non-linearly correlated to raw water characteristics such as turbidity, conductivity, pH, temperature, etc. As such, coagulation reaction is hard or even impossible to control satisfactorily by conventional methods. Traditionally, jar tests are used to determine the optimum coagulant dosage. However, this is expensive and time-consuming and does not enable responses to changes in raw water quality in real time. Modelling can be used to overcome these limitations. In this study, an Adaptive Neuro-Fuzzy Inference System (ANFIS) was used for modelling of coagulant dosage in drinking water treatment plant of Boudouaou, Algeria. Six on-line variables of raw water quality including turbidity, conductivity, temperature, dissolved oxygen, ultraviolet absorbance, and the pH of water, and alum dosage were used to build the coagulant dosage model. Two ANFIS-based Neuro-fuzzy systems are presented. The two Neuro-fuzzy systems are: (1) grid partition-based fuzzy inference system (FIS), named ANFIS-GRID, and (2) subtractive clustering based (FIS), named ANFIS-SUB. The low root mean square error and high correlation coefficient values were obtained with ANFIS-SUB method of a first-order Sugeno type inference. This study demonstrates that ANFIS-SUB outperforms ANFIS-GRID due to its simplicity in parameter selection and its fitness in the target problem.