Mourad Loulou
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Mourad Loulou has a total of 30 co-authors. Here are the top co-authors by number of shared publications:
- Hassene Mnif
University of Sfax- LETI Laboratory
5 shared publications - Farid Touati
Department of Electrical Engineering, College of Engineering, Qatar University, Doha 2713, Qatar
4 shared publications - Mourad Fakhfakh
University of Sfax
4 shared publications - Skandar Douss
National School of Engineering of Sfax
4 shared publications - David Cordeau
CNRS-XLIM, UMR 7252, University of Poitiers, Angoulême, France
2 shared publications - Dorra Mellouli
LIAS, University of Poitiers, Poitiers, France
2 shared publications
Latest Publications
- 1 June 2021
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 108 (2) , 277-289
An ultra-low power hybrid 2nd order feed forward ΔΣ modulator design for implantable medical devices
- 1 June 2021
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 108 (2) , 277-289
An ultra-low power hybrid 2nd order feed forward ΔΣ modulator design for implantable medical devices
- 13 March 2020
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 106 (2) , 375-383
Ultra-low-power wideband NMOS LC-VCO design for autonomous connected objects
- 13 March 2020
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 106 (2) , 375-383
Ultra-low-power wideband NMOS LC-VCO design for autonomous connected objects
- 26 July 2019
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 101 (2) , 255-265
Low power CMOS variable gain amplifier design for a multistandard receiver WLAN/WIMAX/LTE
- 26 July 2019
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 101 (2) , 255-265
Low power CMOS variable gain amplifier design for a multistandard receiver WLAN/WIMAX/LTE
- Open Access
- 1 September 2018
- Published by University of Slavonski Brod in Tehnicki vjesnik - Technical Gazette
- Vol. 25 (Supplement) , 487-494
A ΔΣ Modulator Automated Synthesis Tool for Wireless Standards
This paper presents the prediction of single-bit discrete-time feed-forward Delta-Sigma (DT FF ΔΣ) modulators performance for wireless standards with the use of two methods. The presented work uses the MAPLE tool and a new design...
- 1 September 2018
- Published by University of Slavonski Brod in Tehnicki vjesnik - Technical Gazette
- Vol. 25 (Supplement) , 487-494
Open AccessA ΔΣ Modulator Automated Synthesis Tool for Wireless Standards
This paper presents the prediction of single-bit discrete-time feed-forward Delta-Sigma (DT FF ΔΣ) modulators performance for wireless standards with the use of two methods. The presented work uses the MAPLE tool and a new design...
- 1 January 2016
- Published by Walter de Gruyter GmbH in Frequenz
- Vol. 70 (1-2)
A Low Phase Noise Fully Monolithic 6 GHz Differential Coupled NMOS LC-VCO
A fully monolithic 6 GHz low-phase noise Voltage-Controlled-Oscillator (VCO) is presented in this paper. It consists in two LC-NMOS differential VCOs coupled through a resistive network and is implemented on a 0.25 µm BiCMOS SiGe process. This proposed integrated VCO can be used also for phased-array applications to steer the beam over the entire spatial range. In this case, the radiation pattern of the phased antenna array is steered in a particular direction by establishing a constant phase progression in the oscillator chain which can be obtained by detuning the free-running frequencies of the two oscillators in the array. At 2.5 V power supply voltage and a power dissipation of 62.5 mW, the coupled VCO array features a measured worst case phase noise of
- 1 January 2016
- Published by Walter de Gruyter GmbH in Frequenz
- Vol. 70 (1-2)
A Low Phase Noise Fully Monolithic 6 GHz Differential Coupled NMOS LC-VCO
A fully monolithic 6 GHz low-phase noise Voltage-Controlled-Oscillator (VCO) is presented in this paper. It consists in two LC-NMOS differential VCOs coupled through a resistive network and is implemented on a 0.25 µm BiCMOS SiGe process. This proposed integrated VCO can be used also for phased-array applications to steer the beam over the entire spatial range. In this case, the radiation pattern of the phased antenna array is steered in a particular direction by establishing a constant phase progression in the oscillator chain which can be obtained by detuning the free-running frequencies of the two oscillators in the array. At 2.5 V power supply voltage and a power dissipation of 62.5 mW, the coupled VCO array features a measured worst case phase noise of
- 30 April 2015
- Published by Praise Worthy Prize in International Review of Electrical Engineering (IREE)
- Vol. 10 (2) , 257
Micropower Clock Generator Circuit Using an Optimized Band-Gap Reference for Energy Harvesting Charge Pumps
- 30 April 2015
- Published by Praise Worthy Prize in International Review of Electrical Engineering (IREE)
- Vol. 10 (2) , 257
Micropower Clock Generator Circuit Using an Optimized Band-Gap Reference for Energy Harvesting Charge Pumps
- 16 June 2013
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 76 (2) , 179-193
Design and implementation of a 6-GHz array of four differential VCOs coupled through a resistive network
- 16 June 2013
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 76 (2) , 179-193
Design and implementation of a 6-GHz array of four differential VCOs coupled through a resistive network
- 8 July 2012
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 73 (1) , 99-100
Introduction to the special issue on ICECS 2009
- 8 July 2012
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 73 (1) , 99-100
Introduction to the special issue on ICECS 2009
- 1 January 2012
- Published by IGI Global Scientific Publishing
- p. 89-103
Optimization of CMOS Quadrature VCO Using a Graphical Method
This chapter describes the design and the optimization of Quadrature Voltage Controlled Oscillators (QVCOs) based on the coupling of two LC-tank VCO. This work covers the phase noise analysis, a graphical optimization approach, already used to optimize LC oscillator phase noise (Andreani, Bonfanti, Romano, & Samori, 2002), to optimize QVCO phase noise while satisfying design constraints such as power dissipation, tank amplitude, tuning range and start up condition. The cross-coupling transistors impact on phase noise for different configurations is especially addressed. The obtained BS-QVCO, using 0.35µm CMOS process, can be tuned between 2.2GHz and 2.58GHz, and shows a phase noise of -129 dBc/Hz at 1MHz offset from a 2.4 GHz carrier, for a current consumption of 9.25mW. The equivalent phase error and amplitude error between I and Q signals are respectively 0.65° and 1.87%.
- 1 January 2012
- Published by IGI Global Scientific Publishing
- p. 89-103
Optimization of CMOS Quadrature VCO Using a Graphical Method
This chapter describes the design and the optimization of Quadrature Voltage Controlled Oscillators (QVCOs) based on the coupling of two LC-tank VCO. This work covers the phase noise analysis, a graphical optimization approach, already used to optimize LC oscillator phase noise (Andreani, Bonfanti, Romano, & Samori, 2002), to optimize QVCO phase noise while satisfying design constraints such as power dissipation, tank amplitude, tuning range and start up condition. The cross-coupling transistors impact on phase noise for different configurations is especially addressed. The obtained BS-QVCO, using 0.35µm CMOS process, can be tuned between 2.2GHz and 2.58GHz, and shows a phase noise of -129 dBc/Hz at 1MHz offset from a 2.4 GHz carrier, for a current consumption of 9.25mW. The equivalent phase error and amplitude error between I and Q signals are respectively 0.65° and 1.87%.