Hassene Mnif
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Hassene Mnif has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Mourad Loulou
Research Laboratory On Electronics and Information Technologies, National Engineering School of Sfax (ENIS), University of Sfax, Sfax, Tunisia
5 shared publications - David Cordeau
CNRS-XLIM, UMR 7252, University of Poitiers, Angoulême, France
2 shared publications - Dorra Mellouli
LIAS, University of Poitiers, Poitiers, France
2 shared publications - Jean-Marie Paillot
Chasseneuil-du-Poitou, France, 86360
2 shared publications - Dorra Mellouli Moalla1 shared publication
Frederic Alicalapa
LE2P Lab-University of La Reunion Saint Denis
1 shared publication
Latest Publications
- 1 January 2016
- Published by Walter de Gruyter GmbH in Frequenz
- Vol. 70 (1-2)
A Low Phase Noise Fully Monolithic 6 GHz Differential Coupled NMOS LC-VCO
A fully monolithic 6 GHz low-phase noise Voltage-Controlled-Oscillator (VCO) is presented in this paper. It consists in two LC-NMOS differential VCOs coupled through a resistive network and is implemented on a 0.25 µm BiCMOS SiGe process. This proposed integrated VCO can be used also for phased-array applications to steer the beam over the entire spatial range. In this case, the radiation pattern of the phased antenna array is steered in a particular direction by establishing a constant phase progression in the oscillator chain which can be obtained by detuning the free-running frequencies of the two oscillators in the array. At 2.5 V power supply voltage and a power dissipation of 62.5 mW, the coupled VCO array features a measured worst case phase noise of
- 1 January 2016
- Published by Walter de Gruyter GmbH in Frequenz
- Vol. 70 (1-2)
A Low Phase Noise Fully Monolithic 6 GHz Differential Coupled NMOS LC-VCO
A fully monolithic 6 GHz low-phase noise Voltage-Controlled-Oscillator (VCO) is presented in this paper. It consists in two LC-NMOS differential VCOs coupled through a resistive network and is implemented on a 0.25 µm BiCMOS SiGe process. This proposed integrated VCO can be used also for phased-array applications to steer the beam over the entire spatial range. In this case, the radiation pattern of the phased antenna array is steered in a particular direction by establishing a constant phase progression in the oscillator chain which can be obtained by detuning the free-running frequencies of the two oscillators in the array. At 2.5 V power supply voltage and a power dissipation of 62.5 mW, the coupled VCO array features a measured worst case phase noise of
- 30 April 2015
- Published by Praise Worthy Prize in International Review of Electrical Engineering (IREE)
- Vol. 10 (2) , 257
Micropower Clock Generator Circuit Using an Optimized Band-Gap Reference for Energy Harvesting Charge Pumps
- 30 April 2015
- Published by Praise Worthy Prize in International Review of Electrical Engineering (IREE)
- Vol. 10 (2) , 257
Micropower Clock Generator Circuit Using an Optimized Band-Gap Reference for Energy Harvesting Charge Pumps
- 16 June 2013
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 76 (2) , 179-193
Design and implementation of a 6-GHz array of four differential VCOs coupled through a resistive network
- 16 June 2013
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 76 (2) , 179-193
Design and implementation of a 6-GHz array of four differential VCOs coupled through a resistive network
- 1 January 2012
- Published by IGI Global Scientific Publishing
- p. 89-103
Optimization of CMOS Quadrature VCO Using a Graphical Method
This chapter describes the design and the optimization of Quadrature Voltage Controlled Oscillators (QVCOs) based on the coupling of two LC-tank VCO. This work covers the phase noise analysis, a graphical optimization approach, already used to optimize LC oscillator phase noise (Andreani, Bonfanti, Romano, & Samori, 2002), to optimize QVCO phase noise while satisfying design constraints such as power dissipation, tank amplitude, tuning range and start up condition. The cross-coupling transistors impact on phase noise for different configurations is especially addressed. The obtained BS-QVCO, using 0.35µm CMOS process, can be tuned between 2.2GHz and 2.58GHz, and shows a phase noise of -129 dBc/Hz at 1MHz offset from a 2.4 GHz carrier, for a current consumption of 9.25mW. The equivalent phase error and amplitude error between I and Q signals are respectively 0.65° and 1.87%.
- 1 January 2012
- Published by IGI Global Scientific Publishing
- p. 89-103
Optimization of CMOS Quadrature VCO Using a Graphical Method
This chapter describes the design and the optimization of Quadrature Voltage Controlled Oscillators (QVCOs) based on the coupling of two LC-tank VCO. This work covers the phase noise analysis, a graphical optimization approach, already used to optimize LC oscillator phase noise (Andreani, Bonfanti, Romano, & Samori, 2002), to optimize QVCO phase noise while satisfying design constraints such as power dissipation, tank amplitude, tuning range and start up condition. The cross-coupling transistors impact on phase noise for different configurations is especially addressed. The obtained BS-QVCO, using 0.35µm CMOS process, can be tuned between 2.2GHz and 2.58GHz, and shows a phase noise of -129 dBc/Hz at 1MHz offset from a 2.4 GHz carrier, for a current consumption of 9.25mW. The equivalent phase error and amplitude error between I and Q signals are respectively 0.65° and 1.87%.