Yasuyuki Ishida
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Yasuyuki Ishida has a total of 30 co-authors. Here are the top co-authors by number of shared publications:
Hajime Ohtani
Nagoya Inst Technol, Grad Sch Engn, Dept Mat Sci & Engn, Nagoya, Aichi 4668555, Japan
3 shared publications- Hajime Ohtani
Department of Applied Chemistry, Graduate School of Engineering, Nagoya University, Furo‐cho, Chikusa‐ku, Nagoya 464‐8603, Japan
2 shared publications - Hajime Ohtani
Department of Life Science and Applied Chemistry, Graduate School of Engineering, Nagoya Institute of Technology, Nagoya 466-8555, Japan
2 shared publications - Shin Tsuge
Department of Applied Chemistry, Graduate School of Engineering, Nagoya University
2 shared publications Tsuneo Yamane
Chubu Univ, Dept Environm Biol, Coll Biosci & Biotechnol, Kasugai, Aichi 4878501, Japan
2 shared publicationsAkira Maki
Department of Biological Chemistry, College of Bioscience and Biotechnology, Chubu University
1 shared publication
Latest Publications
- Open Access
- 31 March 2025
- Published by Japan Society of Lipid Nutrition in Journal of Lipid Nutrition
- Vol. 34 (1) , 49-57
Rapid and Precise Analysis of n-6 / n-3 Fatty Acid Ratio in Human Serum by Reactive Pyrolysis-Gas Chromatography
- 31 March 2025
- Published by Japan Society of Lipid Nutrition in Journal of Lipid Nutrition
- Vol. 34 (1) , 49-57
Open AccessRapid and Precise Analysis of n-6 / n-3 Fatty Acid Ratio in Human Serum by Reactive Pyrolysis-Gas Chromatography
- 10 February 2015
- Published by Springer Nature in Analytical Sciences
- Vol. 31 (2) , 79-83
Rapid and Direct Compositional Analysis of Poly(3-hydroxybutyrate-co-3-hydroxyvalerate) in Whole Bacterial Cells by Thermally Assisted Hydrolysis and Methylation-Gas Chromatography
Thermally assisted hydrolysis and methylation-gas chromatography (THM-GC) in the presence of an organic alkali was applied to the direct analysis of copolymer composition for poly(3-hydroxybutyrate-co-3-hydroxyvalerate) [P(3HB-co-3HV)] accumulated in whole bacterial cells. Cupriavidus necator was grown on a liquid medium with different molar ratios of valeric acid (V) to glucose (G) in order to control the compositions of P(3HB-co-3HV) produced in the cells. Trace amounts (0.03 mg) of dried Cupriavidus necator cells were directly subjected to THM-GC in the presence of tetramethylammonium hydroxide (TMAH) at 400 degrees C. The obtained chromatograms clearly showed nine characteristic peaks, attributed to the THM products from 3HB and 3HV units in the polymer chains, without any appreciable interference by the bacterial matrix components. Based on these peak intensities, the copolymer compositions were determined rapidly without using any cumbersome sample pretreatment. Moreover, the compositions thus obtained were in good agreement with those obtained by the conventional technique.
- 10 February 2015
- Published by Springer Nature in Analytical Sciences
- Vol. 31 (2) , 79-83
Rapid and Direct Compositional Analysis of Poly(3-hydroxybutyrate-co-3-hydroxyvalerate) in Whole Bacterial Cells by Thermally Assisted Hydrolysis and Methylation-Gas Chromatography
Thermally assisted hydrolysis and methylation-gas chromatography (THM-GC) in the presence of an organic alkali was applied to the direct analysis of copolymer composition for poly(3-hydroxybutyrate-co-3-hydroxyvalerate) [P(3HB-co-3HV)] accumulated in whole bacterial cells. Cupriavidus necator was grown on a liquid medium with different molar ratios of valeric acid (V) to glucose (G) in order to control the compositions of P(3HB-co-3HV) produced in the cells. Trace amounts (0.03 mg) of dried Cupriavidus necator cells were directly subjected to THM-GC in the presence of tetramethylammonium hydroxide (TMAH) at 400 degrees C. The obtained chromatograms clearly showed nine characteristic peaks, attributed to the THM products from 3HB and 3HV units in the polymer chains, without any appreciable interference by the bacterial matrix components. Based on these peak intensities, the copolymer compositions were determined rapidly without using any cumbersome sample pretreatment. Moreover, the compositions thus obtained were in good agreement with those obtained by the conventional technique.
- 19 April 2012
- Published by American Chemical Society (ACS) in Journal of Agricultural and Food Chemistry
- Vol. 60 (17) , 4222-4226
Validation of Thermally Assisted Hydrolysis and Methylation–Gas Chromatography Using a Vertical Microfurnace Pyrolyzer for the Compositional Analysis of Fatty Acid Components in Microalgae
Thermally assisted hydrolysis and methylation–gas chromatography (THM-GC) in the presence of trimethylsulfonium hydroxide, using a vertical microfurnace pyrolyzer, was validated for the compositional analysis of fatty acid components in microalgae. The chromatograms of a microalga, Pavlova lutheri, obtained under optimized THM conditions clearly showed a series of fatty acid methyl esters including thermally labile polyunsaturated fatty acid components. On the basis of these peak areas, their chemical compositions were rapidly determined without using any tedious sample pretreatment with a precision of Coccomyxa gloeobotrydiformis. The obtained data showed a high abundance (24 mol %) of α-linolenic acid components, suggesting its potential usefulness as feed sources and/or functional foods.
- 19 April 2012
- Published by American Chemical Society (ACS) in Journal of Agricultural and Food Chemistry
- Vol. 60 (17) , 4222-4226
Validation of Thermally Assisted Hydrolysis and Methylation–Gas Chromatography Using a Vertical Microfurnace Pyrolyzer for the Compositional Analysis of Fatty Acid Components in Microalgae
Thermally assisted hydrolysis and methylation–gas chromatography (THM-GC) in the presence of trimethylsulfonium hydroxide, using a vertical microfurnace pyrolyzer, was validated for the compositional analysis of fatty acid components in microalgae. The chromatograms of a microalga, Pavlova lutheri, obtained under optimized THM conditions clearly showed a series of fatty acid methyl esters including thermally labile polyunsaturated fatty acid components. On the basis of these peak areas, their chemical compositions were rapidly determined without using any tedious sample pretreatment with a precision of Coccomyxa gloeobotrydiformis. The obtained data showed a high abundance (24 mol %) of α-linolenic acid components, suggesting its potential usefulness as feed sources and/or functional foods.
- 9 January 2012
- Published by Taylor & Francis in International Journal of Polymer Analysis and Characterization
- Vol. 17 (1) , 29-37
Evaluation of Biodegradability of Poly(Butylene succinate-co-butylene Adipate) on the Basis of Copolymer Composition Determined by Thermally Assisted Hydrolysis and Methylation-Gas Chromatography
Biodegradability of poly(butylene succinate-co-butylene adipate) (PBSA) was studied based on its copolymer composition determined by thermally assisted hydrolysis and methylation-gas chromatography (THM-GC) using trace amounts (20 µg) of the film samples. The copolymer compositions of butylene adipate (BA) units gradually decreased with soil burial degradation time, reflecting preferential biodegradation of BA moieties during soil burial due to their lower crystallinity. Furthermore, local differences in biodegradability of a given PBSA film after soil burial were also successfully evaluated.
- 9 January 2012
- Published by Taylor & Francis in International Journal of Polymer Analysis and Characterization
- Vol. 17 (1) , 29-37
Evaluation of Biodegradability of Poly(Butylene succinate-co-butylene Adipate) on the Basis of Copolymer Composition Determined by Thermally Assisted Hydrolysis and Methylation-Gas Chromatography
Biodegradability of poly(butylene succinate-co-butylene adipate) (PBSA) was studied based on its copolymer composition determined by thermally assisted hydrolysis and methylation-gas chromatography (THM-GC) using trace amounts (20 µg) of the film samples. The copolymer compositions of butylene adipate (BA) units gradually decreased with soil burial degradation time, reflecting preferential biodegradation of BA moieties during soil burial due to their lower crystallinity. Furthermore, local differences in biodegradability of a given PBSA film after soil burial were also successfully evaluated.
- Open Access
- 10 October 2011
- Published by Springer Nature in Analytical Sciences
- Vol. 27 (10) , 1053-1056
Rapid Determination of Terephthalic Acid in the Hydrothermal Decomposition Product of Poly(ethylene terephthalate) by Thermochemolysis-Gas Chromatography in the Presence of Tetramethylammonium Acetate
Thermochemolysis–gas chromatography in the presence of tetramethylammonium acetate was applied to the direct determination of terephthalic acid (TPA) contained in solid decomposition products obtained from the hydrothermal recycling process of poly(ethylene terephthalate) (PET). On the chromatograms of the hydrothermal decomposition products of PET, a sharp peak of the TPA component was clearly observed as its corresponding dimethyl ester formed through the thermochemolysis reaction. Based on the peak intensities, the contents of TPA in the decomposition products were determined precisely and rapidly without using any cumbersome sample pretreatments.
- 10 October 2011
- Published by Springer Nature in Analytical Sciences
- Vol. 27 (10) , 1053-1056
Open AccessRapid Determination of Terephthalic Acid in the Hydrothermal Decomposition Product of Poly(ethylene terephthalate) by Thermochemolysis-Gas Chromatography in the Presence of Tetramethylammonium Acetate
Thermochemolysis–gas chromatography in the presence of tetramethylammonium acetate was applied to the direct determination of terephthalic acid (TPA) contained in solid decomposition products obtained from the hydrothermal recycling process of poly(ethylene terephthalate) (PET). On the chromatograms of the hydrothermal decomposition products of PET, a sharp peak of the TPA component was clearly observed as its corresponding dimethyl ester formed through the thermochemolysis reaction. Based on the peak intensities, the contents of TPA in the decomposition products were determined precisely and rapidly without using any cumbersome sample pretreatments.
- 1 April 2009
- Published by Elsevier in Journal of Chromatography A
- Vol. 1216 (15) , 3296-3299
Reaction efficiency of organic alkalis with various classes of lipids during thermally assisted hydrolysis and methylation
- 1 April 2009
- Published by Elsevier in Journal of Chromatography A
- Vol. 1216 (15) , 3296-3299
Reaction efficiency of organic alkalis with various classes of lipids during thermally assisted hydrolysis and methylation
- 1 January 2009
- Published by Japan Society for Analytical Chemistry in BUNSEKI KAGAKU
- Vol. 58 (8) , 731-736
Structural Analysis of Condensed Tannins in Hydrothermal Extracts from Wasted Bark by Matrix-Assisted Laser Desorption/Ionization Mass Spectrometry
- 1 January 2009
- Published by Japan Society for Analytical Chemistry in BUNSEKI KAGAKU
- Vol. 58 (8) , 731-736
Structural Analysis of Condensed Tannins in Hydrothermal Extracts from Wasted Bark by Matrix-Assisted Laser Desorption/Ionization Mass Spectrometry
- 1 January 1999
- Published by Royal Society of Chemistry (RSC) in The Analyst
- Vol. 124 (5) , 669-674
Characterization of within-tree variation of lignin components in Eucalyptus camaldulensis by pyrolysis–gas chromatography
Pyrolysis–gas chromatography (Py-GC) using a vertical microfurnace pyrolyzer was applied to the precise determination of the ‘within-tree variation’ of the ratio of syringyl and guaiacyl units (S/G ratio) for lignin in Eucalyptus camaldulensis. On the pyrogram of the Eucalyptus obtained at 450 °C, many characteristic peaks derived from syringyl and guaiacyl units of lignin were reproducibly observed, together with those from cellulose and hemicellulose. On the basis of the relative intensities of those characteristic peaks relating to the syringyl and guaiacyl units, the ‘within-tree variation’ of the S/G ratio was determined precisely in about 1 h using only about 0.1 mg of the powdered wood sample with a 2% relative standard deviation. The results obtained were also compared with those obtained by the thioacidolysis method.
- 1 January 1999
- Published by Royal Society of Chemistry (RSC) in The Analyst
- Vol. 124 (5) , 669-674
Characterization of within-tree variation of lignin components in Eucalyptus camaldulensis by pyrolysis–gas chromatography
Pyrolysis–gas chromatography (Py-GC) using a vertical microfurnace pyrolyzer was applied to the precise determination of the ‘within-tree variation’ of the ratio of syringyl and guaiacyl units (S/G ratio) for lignin in Eucalyptus camaldulensis. On the pyrogram of the Eucalyptus obtained at 450 °C, many characteristic peaks derived from syringyl and guaiacyl units of lignin were reproducibly observed, together with those from cellulose and hemicellulose. On the basis of the relative intensities of those characteristic peaks relating to the syringyl and guaiacyl units, the ‘within-tree variation’ of the S/G ratio was determined precisely in about 1 h using only about 0.1 mg of the powdered wood sample with a 2% relative standard deviation. The results obtained were also compared with those obtained by the thioacidolysis method.
- 1 January 1998
- Published by Springer Nature in Analytical Sciences
- Vol. 14 (2) , 431-434
Determination of Fortified Rosin-Glycerin Ester Sizing Agents in Paper by Reactive Pyrolysis-Gas Chromatography in the Presence of an Organic Alkali.
- 1 January 1998
- Published by Springer Nature in Analytical Sciences
- Vol. 14 (2) , 431-434
Determination of Fortified Rosin-Glycerin Ester Sizing Agents in Paper by Reactive Pyrolysis-Gas Chromatography in the Presence of an Organic Alkali.