Arne Sieber
Research Subjects
Arne Sieber has a total of 34 co-authors. Here are the top co-authors by number of shared publications:
- Benjamin Kuch
Real-Time Systems Laboratory
4 shared publications - Paolo Dario
CRIM Lab, Polo Sant′Anna Valdera
4 shared publications Antonio L'abbate
3 shared publications- Arianna Menciassi
Scuola Superiore Sant’Anna, Pisa, Italy
3 shared publications Bernhard Koss
Scuola Superiore Sant’Anna
3 shared publicationsGiorgio Buttazzo
3 shared publications
Latest Publications
- 1 July 2012
- Published by Society for Underwater Technology in Underwater Technology
- Vol. 30 (4) , 189-194
GPS diving computer for underwater tracking and mapping
- 1 July 2012
- Published by Society for Underwater Technology in Underwater Technology
- Vol. 30 (4) , 189-194
GPS diving computer for underwater tracking and mapping
- Open Access
- 27 January 2012
- Published by IntechOpen
Sensorized Tools for Haptic Force Feedback in Computer Assisted Surgery
Sensorized Tools for Haptic Force Feedback in Computer Assisted Surgery | InTechOpen, Published on: 2012-01-27. Authors: Arne Sieber, Keith Houston, Christian Woegerer, et
- 27 January 2012
- Published by IntechOpen
Open AccessSensorized Tools for Haptic Force Feedback in Computer Assisted Surgery
Sensorized Tools for Haptic Force Feedback in Computer Assisted Surgery | InTechOpen, Published on: 2012-01-27. Authors: Arne Sieber, Keith Houston, Christian Woegerer, et
- 1 June 2011
- Vol. 41 (2) , 90-96
Solid-state electrolyte sensors for rebreather applications: a preliminary investigation
(Sieber A, Baumann R, Fasoulas S, Krozer A. Solid-state electrolyte sensors for rebreather applications: a preliminary investigation. Diving and Hyperbaric Medicine. 2011;41 (2):90-6.) Introduction: Recently developed prototypes of zirconium dioxide and NASICON-based micro solid-state electrolyte oxygen (O(2)) and carbon dioxide (CO(2)) sensors were tested for their potential suitability in rebreathers. The O(2) sensor has a quasi-indefinite lifetime, whilst that of the CO(2) sensor is approximately 700 h. This is a preliminary report of a new technological application. Methods: The O(2) sensor was tested in a small pressure chamber to a partial pressure of oxygen (PO(2)) of 405 kPa (4 bar). The CO, sensor was tested up to 10 kPa CO(2). The response times to a step change of pressure were measured, and cross-sensitivity for helium tested using trimix. A rebreather mouthpiece was modified so that breath-by-breath gas recordings could be observed. Power consumption to heat the sensors was measured. Results: The O(2) sensor demonstrated non-linearity, particularly above 101.3 kPa (1 bar) PO(2), whereas the output of the CO(2) sensor showed an inverse logarithmic relationship. Cross-sensitivity to helium was observed. The mean t90 response times were 90 (SD 10) ms for the O(2) sensor, and 100 (SD 10) ms for the CO(2) sensor. Breath-by-breath recordings showed slight damping of the CO(2) trace due to electronic filtering. Power consumption was 1.5-2 W per sensor. Conclusions: The fast response times would allow accurate breath-by-breath measurement. Even though the O(2) sensor has a non-linear response, measurement is possible using multi-point calibration. Further design is necessary to allow trimix to be used as the diluent. A major disadvantage is the high power consumption needed to heat the sensors to high temperatures.
- 1 June 2011
- Vol. 41 (2) , 90-96
Solid-state electrolyte sensors for rebreather applications: a preliminary investigation
(Sieber A, Baumann R, Fasoulas S, Krozer A. Solid-state electrolyte sensors for rebreather applications: a preliminary investigation. Diving and Hyperbaric Medicine. 2011;41 (2):90-6.) Introduction: Recently developed prototypes of zirconium dioxide and NASICON-based micro solid-state electrolyte oxygen (O(2)) and carbon dioxide (CO(2)) sensors were tested for their potential suitability in rebreathers. The O(2) sensor has a quasi-indefinite lifetime, whilst that of the CO(2) sensor is approximately 700 h. This is a preliminary report of a new technological application. Methods: The O(2) sensor was tested in a small pressure chamber to a partial pressure of oxygen (PO(2)) of 405 kPa (4 bar). The CO, sensor was tested up to 10 kPa CO(2). The response times to a step change of pressure were measured, and cross-sensitivity for helium tested using trimix. A rebreather mouthpiece was modified so that breath-by-breath gas recordings could be observed. Power consumption to heat the sensors was measured. Results: The O(2) sensor demonstrated non-linearity, particularly above 101.3 kPa (1 bar) PO(2), whereas the output of the CO(2) sensor showed an inverse logarithmic relationship. Cross-sensitivity to helium was observed. The mean t90 response times were 90 (SD 10) ms for the O(2) sensor, and 100 (SD 10) ms for the CO(2) sensor. Breath-by-breath recordings showed slight damping of the CO(2) trace due to electronic filtering. Power consumption was 1.5-2 W per sensor. Conclusions: The fast response times would allow accurate breath-by-breath measurement. Even though the O(2) sensor has a non-linear response, measurement is possible using multi-point calibration. Further design is necessary to allow trimix to be used as the diluent. A major disadvantage is the high power consumption needed to heat the sensors to high temperatures.
- 1 March 2011
- Published by Society for Underwater Technology in Underwater Technology
- Vol. 29 (4) , 203-208
Development of a graphical head-up display (HUD) for rebreather diving
- 1 March 2011
- Published by Society for Underwater Technology in Underwater Technology
- Vol. 29 (4) , 203-208
Development of a graphical head-up display (HUD) for rebreather diving
- Open Access
- 1 March 2011
- Published by Society for Underwater Technology in Underwater Technology
- Vol. 29 (4) , 195-202
Bubble model based decompression algorithm optimised for implementation on a low power microcontroller
- 1 March 2011
- Published by Society for Underwater Technology in Underwater Technology
- Vol. 29 (4) , 195-202
Open AccessBubble model based decompression algorithm optimised for implementation on a low power microcontroller
- 1 January 2011
- Published by ACTA Press in International Journal of Robotics and Automation
- Vol. 26 (3)
A TELEOPERATION SYSTEM WITH NOVEL HAPTIC DEVICE FOR MICRO-MANIPULATION
- 1 January 2011
- Published by ACTA Press in International Journal of Robotics and Automation
- Vol. 26 (3)
A TELEOPERATION SYSTEM WITH NOVEL HAPTIC DEVICE FOR MICRO-MANIPULATION
- 12 October 2010
- Vol. 37 (5) , 259-69
Advanced instrumentation for research in diving and hyperbaric medicine.
Improving the safety of diving and increasing knowledge about the adaptation of the human body to underwater and hyperbaric environment require specifically developed underwater instrumentation for physiological measurements. In fact, none of the routine clinical devices for health control is suitable for in-water and/or under-pressure operation. The present paper addresses novel technological acquisitions and the development of three dedicated devices: * an underwater data logger for recording O2 saturation (reflective pulsoxymetry), two-channel ECG, depth and temperature; * an underwater blood pressure meter based on the oscillometric method; and * an underwater echography system. Moreover, examples of recordings are presented and discussed.
- 12 October 2010
- Vol. 37 (5) , 259-69
Advanced instrumentation for research in diving and hyperbaric medicine.
Improving the safety of diving and increasing knowledge about the adaptation of the human body to underwater and hyperbaric environment require specifically developed underwater instrumentation for physiological measurements. In fact, none of the routine clinical devices for health control is suitable for in-water and/or under-pressure operation. The present paper addresses novel technological acquisitions and the development of three dedicated devices: * an underwater data logger for recording O2 saturation (reflective pulsoxymetry), two-channel ECG, depth and temperature; * an underwater blood pressure meter based on the oscillometric method; and * an underwater echography system. Moreover, examples of recordings are presented and discussed.
- 1 March 2010
- Vol. 40 (1) , 34-40
A novel wearable apnea dive computer for continuous plethysmographic monitoring of oxygen saturation and heart rate.
We describe the development of a novel wrist-mounted apnea dive computer. The device is able to measure and display transcutaneous oxygen saturation, heart rate, plethysmographic pulse waveform, depth, time and temperature during breath-hold dives. All measurements are stored in an external memory chip. The data-processing software reads from the chip and writes the processed data into a comma-separated values file which can be analysed by applications such as Microsoft Excel™ or Open Office™. The housing is waterproof and pressure-resistant to more than 20 bar (2.026 MPa) (breath-hold divers have already exceeded 200 metres' sea water depth). It is compact, lightweight, has low power requirements and is easy to use.
- 1 March 2010
- Vol. 40 (1) , 34-40
A novel wearable apnea dive computer for continuous plethysmographic monitoring of oxygen saturation and heart rate.
We describe the development of a novel wrist-mounted apnea dive computer. The device is able to measure and display transcutaneous oxygen saturation, heart rate, plethysmographic pulse waveform, depth, time and temperature during breath-hold dives. All measurements are stored in an external memory chip. The data-processing software reads from the chip and writes the processed data into a comma-separated values file which can be analysed by applications such as Microsoft Excel™ or Open Office™. The housing is waterproof and pressure-resistant to more than 20 bar (2.026 MPa) (breath-hold divers have already exceeded 200 metres' sea water depth). It is compact, lightweight, has low power requirements and is easy to use.
- 1 March 2009
- Vol. 39 (1) , 38-45
Oxygen sensor signal validation for the safety of the rebreather diver.
In electronically controlled, closed-circuit rebreather diving systems, the partial pressure of oxygen inside the breathing loop is controlled with three oxygen sensors, a microcontroller and a solenoid valve - critical components that may fail. State-of-the-art detection of sensor failure, based on a voting algorithm, may fail under circumstances where two or more sensors show the same but incorrect values. The present paper details a novel rebreather controller that offers true sensor-signal validation, thus allowing efficient and reliable detection of sensor failure. The core components of this validation system are two additional solenoids, which allow an injection of oxygen or diluent gas directly across the sensor membrane.
- 1 March 2009
- Vol. 39 (1) , 38-45
Oxygen sensor signal validation for the safety of the rebreather diver.
In electronically controlled, closed-circuit rebreather diving systems, the partial pressure of oxygen inside the breathing loop is controlled with three oxygen sensors, a microcontroller and a solenoid valve - critical components that may fail. State-of-the-art detection of sensor failure, based on a voting algorithm, may fail under circumstances where two or more sensors show the same but incorrect values. The present paper details a novel rebreather controller that offers true sensor-signal validation, thus allowing efficient and reliable detection of sensor failure. The core components of this validation system are two additional solenoids, which allow an injection of oxygen or diluent gas directly across the sensor membrane.