Mikhail Y. Loktev
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Mikhail Y. Loktev has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
- Gleb Vdovin
Technische Univ. Delft (Netherlands)
2 shared publications Pasqualina M. Sarro
Technische Univ. Delft (Netherlands)
2 shared publicationsAlexander Naumov
Physical Optics Corp. (United States)
1 shared publication- Davies William de Lima Monteiro
Univ. Federal de Minas Gerais (Brazil)
1 shared publication Gleb Vdovin
M. Loktevand G. Vdovin are with the Electronic Instrumentation Laboratory, Delft University of Technology, Mekelweg 4, P.O. Box 5031, 2600 GA Delft, The Netherlands.I. Guralnik is with the Department of Physics, Samara State University, Ac. Pavlova 1, 443011 Samara, Russia
1 shared publication- Gleb Vdovin
Technische Univ. Delft (Netherlands)
1 shared publication
Latest Publications
- 12 April 2005
- Published by SPIE-Intl Soc Optical Eng
- Vol. 5741, 163-171
Modal wavefront correction with liquid crystals: different options
Liquid crystal (LC) wavefront correctors with modal addressing are described. Three different approaches are considered. The first one is based on a continuous thin-film resistive layer. This layer is used for forming of the local voltage profile that controls the phase distribution across the corrector’s aperture. The second approach is a modification of the first one, where the continuous resistive coating is replaced by a network of discrete resistors. It is based on silicon technology. The third approach makes use of distributed electric field in thick dielectric layers for forming of the modal response of an actuator. Technologies, methods of control and experimental results are discussed for each case.
- 12 April 2005
- Published by SPIE-Intl Soc Optical Eng
- Vol. 5741, 163-171
Modal wavefront correction with liquid crystals: different options
Liquid crystal (LC) wavefront correctors with modal addressing are described. Three different approaches are considered. The first one is based on a continuous thin-film resistive layer. This layer is used for forming of the local voltage profile that controls the phase distribution across the corrector’s aperture. The second approach is a modification of the first one, where the continuous resistive coating is replaced by a network of discrete resistors. It is based on silicon technology. The third approach makes use of distributed electric field in thick dielectric layers for forming of the modal response of an actuator. Technologies, methods of control and experimental results are discussed for each case.
- 10 April 2004
- Published by Optica Publishing Group in Applied Optics
- Vol. 43 (11) , 2209-2225
Operation modes of a liquid-crystal modal wave-front corrector.
Liquid-crystal modal wave-front correctors provide much better wave-front correction than do piston correctors with the same number of actuators; moreover, use of additional degrees of freedom of the driving ac voltage signals may further improve device performance. Some practical aspects of the operation of liquid-crystal modal wave-front correctors are discussed. Special attention is paid to the interference of various contact responses and to the formation of required phase shapes through wider control of signal frequencies and electric phase shifts. The study is based on an analytic approach and numerical investigation; major theoretical conclusions are verified experimentally.
- 10 April 2004
- Published by Optica Publishing Group in Applied Optics
- Vol. 43 (11) , 2209-2225
Operation modes of a liquid-crystal modal wave-front corrector.
Liquid-crystal modal wave-front correctors provide much better wave-front correction than do piston correctors with the same number of actuators; moreover, use of additional degrees of freedom of the driving ac voltage signals may further improve device performance. Some practical aspects of the operation of liquid-crystal modal wave-front correctors are discussed. Special attention is paid to the interference of various contact responses and to the formation of required phase shapes through wider control of signal frequencies and electric phase shifts. The study is based on an analytic approach and numerical investigation; major theoretical conclusions are verified experimentally.
- 24 January 2004
- Published by SPIE-Intl Soc Optical Eng
- Vol. 5348, 135-150
Silicon micro-optics for smart light control
We present an overview of the results of our recent research in the field of adaptive optical components based on silicon microtechnologies, including membrane deformable mirrors, spatial light modulators, liquid-crystal correctors, wavefront sensors, and both spherical and aspherical micro-optical components. We aim at the realization of adaptive optical systems using standard-technology solutions.
- 24 January 2004
- Published by SPIE-Intl Soc Optical Eng
- Vol. 5348, 135-150
Silicon micro-optics for smart light control
We present an overview of the results of our recent research in the field of adaptive optical components based on silicon microtechnologies, including membrane deformable mirrors, spatial light modulators, liquid-crystal correctors, wavefront sensors, and both spherical and aspherical micro-optical components. We aim at the realization of adaptive optical systems using standard-technology solutions.
- 1 July 2003
- Published by SPIE-Intl Soc Optical Eng
- Vol. 5036, 558-565
Development of a silicon-based modal liquid crystal wavefront corrector
- 1 July 2003
- Published by SPIE-Intl Soc Optical Eng
- Vol. 5036, 558-565
Development of a silicon-based modal liquid crystal wavefront corrector