X. Z. Li
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
X. Z. Li has a total of 41 co-authors. Here are the top co-authors by number of shared publications:
- David J. Sellmyer
Nebraska Center for Materials and Nanoscience, University of Nebraska, Lincoln, Nebraska 68588, USA
5 shared publications - Ralph Skomski
University of Nebraska
3 shared publications - Jeffrey E. Shield
University of Nebraska
2 shared publications B. Balamurugan
University of Nebraska Lincoln
1 shared publicationD. J. Sellmyer
University of Nebraska-Lincoln
1 shared publicationD.J. Sellmyer
Nebraska Center for Materials and Nanoscience, University of Nebraska , Lincoln, NE, 68588-0656, USA ; Department of Physics and Astronomy , University of Nebraska , Lincoln, NE, 68588-0656, USA
1 shared publication
Latest Publications
- 6 May 2017
- Published by Wolters Kluwer Health
- Vol. 51 (5) , 381-385
[Research and suggestion on occupational exposure limits of titanium dioxide nanoparticles in workplaces].
- 6 May 2017
- Published by Wolters Kluwer Health
- Vol. 51 (5) , 381-385
[Research and suggestion on occupational exposure limits of titanium dioxide nanoparticles in workplaces].
- 15 July 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Magnetics
- Vol. 49 (7) , 3353-3355
Magnetism of Rapidly Quenched Sm$_{1 - {\rm x}}$Zr$_{{\rm x}}$Co$_{5}$ Nanocrystalline Materials
The effect of Zr addition on nanostructure and magnetic properties in nanocrystalline Sm1-xZrxCo5 (x = 0-0.6) has been investigated. (Sm, Zr)Co5 with the CaCu5 structure was synthesized by melt spinning. The lattice parameters a and b decrease with x, whereas c increases. Thus, the unit cell volume of (Sm, Zr)Co5 shrinks because the smaller Zr atoms occupy the sites of the larger Sm atoms. Zr addition decreases the grain size and induces the formation of planar defects. The coercivity decreases with x, due to weakening of magnetocrystalline anisotropy energy and effective intergrain exchange coupling. A very high coercivity of 39 kOe and energy product of 13.9 MGOe are obtained for x = 0. The remanence of (Sm, Zr)Co5 increases with x. For x ≤ 0.4, the energy product slightly decreases with x. The results show that 40% of the Sm can be replaced by the less expensive Zr, with an energy-product reduction of only 10%. In addition, the planar defects are responsible for the change of coercivity mechanism from the nucleation-type of reverse domain for the x = 0 to the pinning-type of domain wall for the x = 0.4.
- 15 July 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Magnetics
- Vol. 49 (7) , 3353-3355
Magnetism of Rapidly Quenched Sm$_{1 - {\rm x}}$Zr$_{{\rm x}}$Co$_{5}$ Nanocrystalline Materials
The effect of Zr addition on nanostructure and magnetic properties in nanocrystalline Sm1-xZrxCo5 (x = 0-0.6) has been investigated. (Sm, Zr)Co5 with the CaCu5 structure was synthesized by melt spinning. The lattice parameters a and b decrease with x, whereas c increases. Thus, the unit cell volume of (Sm, Zr)Co5 shrinks because the smaller Zr atoms occupy the sites of the larger Sm atoms. Zr addition decreases the grain size and induces the formation of planar defects. The coercivity decreases with x, due to weakening of magnetocrystalline anisotropy energy and effective intergrain exchange coupling. A very high coercivity of 39 kOe and energy product of 13.9 MGOe are obtained for x = 0. The remanence of (Sm, Zr)Co5 increases with x. For x ≤ 0.4, the energy product slightly decreases with x. The results show that 40% of the Sm can be replaced by the less expensive Zr, with an energy-product reduction of only 10%. In addition, the planar defects are responsible for the change of coercivity mechanism from the nucleation-type of reverse domain for the x = 0 to the pinning-type of domain wall for the x = 0.4.
- 19 May 2011
- Published by Taylor & Francis in Philosophical Magazine
- Vol. 91 (25) , 3406-3415
Synthesis and characterization of highly textured Pt–Bi thin films
Pt–Bi films were synthesized on glass and thermally oxidized silicon substrates by e-beam evaporation and annealing. The structures were characterized using X-ray diffraction (XRD) and transmission electron microscopy/selected area electron diffraction (TEM/SAED) techniques. Single-phase PtBi was obtained at an annealing temperature of 300°C, whereas a higher annealing temperature of 400°C was required to obtain the highly textured γ-PtBi2 phase. TEM/SAED analysis showed that the films annealed at 400°C contain a dominant γ-PtBi2 phase with a small amount of β-PtBi2 and α-PtBi2 phases. Both the PtBi and γ-PtBi2 phases are highly textured in these two kinds of film: the c-axis of the hexagonal PtBi phase is mostly in the film plane, whereas the c-axis of the trigonal γ-PtBi2 phase is perpendicular to the film plane. The electrical resistivity of the film with the γ-PtBi2 phase was smaller by one order of magnitude than that of the film with the PtBi phase.
- 19 May 2011
- Published by Taylor & Francis in Philosophical Magazine
- Vol. 91 (25) , 3406-3415
Synthesis and characterization of highly textured Pt–Bi thin films
Pt–Bi films were synthesized on glass and thermally oxidized silicon substrates by e-beam evaporation and annealing. The structures were characterized using X-ray diffraction (XRD) and transmission electron microscopy/selected area electron diffraction (TEM/SAED) techniques. Single-phase PtBi was obtained at an annealing temperature of 300°C, whereas a higher annealing temperature of 400°C was required to obtain the highly textured γ-PtBi2 phase. TEM/SAED analysis showed that the films annealed at 400°C contain a dominant γ-PtBi2 phase with a small amount of β-PtBi2 and α-PtBi2 phases. Both the PtBi and γ-PtBi2 phases are highly textured in these two kinds of film: the c-axis of the hexagonal PtBi phase is mostly in the film plane, whereas the c-axis of the trigonal γ-PtBi2 phase is perpendicular to the film plane. The electrical resistivity of the film with the γ-PtBi2 phase was smaller by one order of magnitude than that of the film with the PtBi phase.
- 1 April 2011
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 109 (7) , 07A707
Magnetism of cluster-deposited Y–Co nanoparticles
Nanoparticles of YCo2, YCo3, and YCo5 are produced by cluster-deposition and investigated bothstructurally and magnetically. The nanoparticles have sizes of less than 10 nm and aresuperparamagnetic at 300 K, irrespective of stoichiometry. As-produced nanoparticles exhibitdisordered structures with magnetic properties differing from those of the bulk particles.The temperature-dependent magnetization curves of the nanoparticles reveal blocking temperatures from 110 to 250 K, depending on stoichiometry. The magnetic anisotropy constant K1 of disordered YCo5 nanoparticles of 7.8 nm in size is 3.5 × 106 ergs/cm3, higher than those of thedisordered YCo2 (8.9 × 105 ergs/cm3) and YCo3 (1.0 × 106 ergs/cm3) nanoparticles.
- 1 April 2011
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 109 (7) , 07A707
Magnetism of cluster-deposited Y–Co nanoparticles
Nanoparticles of YCo2, YCo3, and YCo5 are produced by cluster-deposition and investigated bothstructurally and magnetically. The nanoparticles have sizes of less than 10 nm and aresuperparamagnetic at 300 K, irrespective of stoichiometry. As-produced nanoparticles exhibitdisordered structures with magnetic properties differing from those of the bulk particles.The temperature-dependent magnetization curves of the nanoparticles reveal blocking temperatures from 110 to 250 K, depending on stoichiometry. The magnetic anisotropy constant K1 of disordered YCo5 nanoparticles of 7.8 nm in size is 3.5 × 106 ergs/cm3, higher than those of thedisordered YCo2 (8.9 × 105 ergs/cm3) and YCo3 (1.0 × 106 ergs/cm3) nanoparticles.
- 31 March 2010
- Published by Elsevier in Ultramicroscopy
- Vol. 110 (4) , 297-304
PCED2.0—A computer program for the simulation of polycrystalline electron diffraction pattern
- 31 March 2010
- Published by Elsevier in Ultramicroscopy
- Vol. 110 (4) , 297-304
PCED2.0—A computer program for the simulation of polycrystalline electron diffraction pattern
- 10 December 2009
- Published by Springer Nature in Journal of Failure Analysis and Prevention
- Vol. 10 (1) , 3-7
TEM Study of Lizardite-1T Particles in Toluene Solvent
- 10 December 2009
- Published by Springer Nature in Journal of Failure Analysis and Prevention
- Vol. 10 (1) , 3-7
TEM Study of Lizardite-1T Particles in Toluene Solvent
- 20 October 2009
- Published by Springer Nature in Journal of Nanoparticle Research
- Vol. 12 (3) , 789-794
Structure and magnetism of Co:CoO core–shell nanoclusters
- 20 October 2009
- Published by Springer Nature in Journal of Nanoparticle Research
- Vol. 12 (3) , 789-794
Structure and magnetism of Co:CoO core–shell nanoclusters
- 21 May 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Magnetics
- Vol. 43 (6) , 3115-3117
Ferromagnetic Multipods Fabricated by Solution Phase Synthesis and Hydrogen Reduction
A simple approach combining pyrolysis and hydrogen reduction is formulated for making ferromagnetic-branched nanostructures called Co multipods. The CoO multipods (branched nanostructures) were produced through the pyrolysis of cobalt-oleate in octadecane at 280degC with the presence of oleic acid under the protection of pure nitrogen. The angles between the nearest arms are 90deg. After the reduction of the branched CoO nanostructures in flowing hydrogen gas in a tubular oven at 290degC, the CoO is reduced to pure cobalt with hexagonal crystal structure and the branched shapes are retained. Anisotropic magnetic properties were found for cobalt multipods on silicon substrates
- 21 May 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Magnetics
- Vol. 43 (6) , 3115-3117
Ferromagnetic Multipods Fabricated by Solution Phase Synthesis and Hydrogen Reduction
A simple approach combining pyrolysis and hydrogen reduction is formulated for making ferromagnetic-branched nanostructures called Co multipods. The CoO multipods (branched nanostructures) were produced through the pyrolysis of cobalt-oleate in octadecane at 280degC with the presence of oleic acid under the protection of pure nitrogen. The angles between the nearest arms are 90deg. After the reduction of the branched CoO nanostructures in flowing hydrogen gas in a tubular oven at 290degC, the CoO is reduced to pure cobalt with hexagonal crystal structure and the branched shapes are retained. Anisotropic magnetic properties were found for cobalt multipods on silicon substrates
- Open Access
- 1 September 2006
- Published by Oxford University Press (OUP) in Microscopy Today
- Vol. 14 (5) , 32-35
JECP—a Java Electron Crystallography Project
JECP stands for a java electron crystallography project that includes a series of practical java stand-alone programs for electron diffraction/microscopy and crystallography applications. The aim of the JECP project is twofold, i) as teaching tools to show students the principles of electron diffraction/microscopy and crystallography, ii) as research tools to analyze experimental results. Although there are commercial and public domain computer programs available that allow a user to simulate electron diffraction patterns or processingHREMimages, there are always situations when we need to perform operations that are not a feature of any of the existing programs. The programs in the JECP can bemodified and extended tomeet the need in experiments.
- 1 September 2006
- Published by Oxford University Press (OUP) in Microscopy Today
- Vol. 14 (5) , 32-35
Open AccessJECP—a Java Electron Crystallography Project
JECP stands for a java electron crystallography project that includes a series of practical java stand-alone programs for electron diffraction/microscopy and crystallography applications. The aim of the JECP project is twofold, i) as teaching tools to show students the principles of electron diffraction/microscopy and crystallography, ii) as research tools to analyze experimental results. Although there are commercial and public domain computer programs available that allow a user to simulate electron diffraction patterns or processingHREMimages, there are always situations when we need to perform operations that are not a feature of any of the existing programs. The programs in the JECP can bemodified and extended tomeet the need in experiments.
- 13 May 2005
- Published by International Union of Crystallography (IUCr) in Journal of Applied Crystallography
- Vol. 38 (3) , 576-577
JECP/HOLZ – an interactive computer program for simulation of HOLZ patterns
- 13 May 2005
- Published by International Union of Crystallography (IUCr) in Journal of Applied Crystallography
- Vol. 38 (3) , 576-577
JECP/HOLZ – an interactive computer program for simulation of HOLZ patterns