José Refugio Parga-Torres
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
José Refugio Parga-Torres has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
- Alejandro Monserrat García-Alegría
Universidad de Sonora
2 shared publications H. Moreno
Chemical Engineering Department
2 shared publications- Rodrigo Martínez-Peñuñuri
Laboratorio Tecnológico de Metalurgia LTM, Hermosillo, Mexico
2 shared publications D. L. Cocke
Lamar University, Gill Chair of Chemistry and Chemical Engineering, Beaumont, TX 77710, USA
1 shared publicationD. Mencer
Wilkes University, Dept. of Chemistry, Wilkes‐Barre, PA 18766, USA
1 shared publicationD.L. Cocke
Lamar University, Chemistry and Chemical Engineering Department, Beaumont Texas 77710, USA
1 shared publication
Latest Publications
- 10 August 2023
- Published by Springer Nature in MAPAN
- Vol. 38 (4) , 1005-1018
Validation of the ASTM E1898-21 Method with Estimation of Analytical Uncertainty for the Determination of Silver by FAAS
- 10 August 2023
- Published by Springer Nature in MAPAN
- Vol. 38 (4) , 1005-1018
Validation of the ASTM E1898-21 Method with Estimation of Analytical Uncertainty for the Determination of Silver by FAAS
- Open Access
Thermodynamic and Kinetic Aspects of Gold Adsorption in Micrometric Activated Carbon and the Impact of Their Loss in Adsorption, Desorption, and Reactivation Plants
The production and loss of fine particles of activated carbon (AC) loaded with gold in the adsorption processes is a worldwide problem, mainly due to the behavior of increasing its adsorption capacity with respect to the decrease in particle size, which becomes relevant to determine the thermodynamic and kinetic activity of the gold adsorption and the economic impact of its loss, with the escape towards the later stages of the system of adsorption, desorption, and reactivation (ADR) plants of AC. Through the adsorption of gold in a synthetic medium with sodium cyanide concentration, using different particle sizes, AC weights, and adsorption times, data were generated for analysis by three different isotherm models, resulting in a better tendency for the Freundlich isotherm, from which thermodynamic parameters of ΔG equal to −2.022 kcal/mol, ΔH equal to −16.710 kcal/mol, and ΔS equal to −0.049 kcal/molK were obtained, which shows that it is a spontaneous, exothermic process with a lower degree of disorder. The kinetic analysis was performed with two different models, from which the pseudo-second-order model was used due to a better tendency and displayed a behavior that leaves open the interpretation of the increase in adsorption with respect to the decrease in the AC particle size but demonstrated the importance of recovering these particles in relation to their gold concentration and the economic impact from their poor recovery, which, for this case study, amounted to ~0.3 million dollars per year.
Open AccessThermodynamic and Kinetic Aspects of Gold Adsorption in Micrometric Activated Carbon and the Impact of Their Loss in Adsorption, Desorption, and Reactivation Plants
The production and loss of fine particles of activated carbon (AC) loaded with gold in the adsorption processes is a worldwide problem, mainly due to the behavior of increasing its adsorption capacity with respect to the decrease in particle size, which becomes relevant to determine the thermodynamic and kinetic activity of the gold adsorption and the economic impact of its loss, with the escape towards the later stages of the system of adsorption, desorption, and reactivation (ADR) plants of AC. Through the adsorption of gold in a synthetic medium with sodium cyanide concentration, using different particle sizes, AC weights, and adsorption times, data were generated for analysis by three different isotherm models, resulting in a better tendency for the Freundlich isotherm, from which thermodynamic parameters of ΔG equal to −2.022 kcal/mol, ΔH equal to −16.710 kcal/mol, and ΔS equal to −0.049 kcal/molK were obtained, which shows that it is a spontaneous, exothermic process with a lower degree of disorder. The kinetic analysis was performed with two different models, from which the pseudo-second-order model was used due to a better tendency and displayed a behavior that leaves open the interpretation of the increase in adsorption with respect to the decrease in the AC particle size but demonstrated the importance of recovering these particles in relation to their gold concentration and the economic impact from their poor recovery, which, for this case study, amounted to ~0.3 million dollars per year.
- Open Access
- 15 November 2009
- Published by Wiley in Journal of Metallurgy
- Vol. 2009, 1-9
Thermodynamic Studies of the Arsenic Adsorption on Iron Species Generated by Electrocoagulation
Protection of global environment and sustainable sources of clean water are a necessity for human survival. The wide use of heavy metals by modern industries has generated heavy metals containing wastes and by-products. Specifically, large quantities of arsenic compounds are being discharged into the environment. The full potential of Electrocoagulation (EC) with air injection as an alternative wastewater treatment technique to remove arsenic from water showed more than 99 percent of removal without adding any chemicals. This study has been carried out to determine the feasibility of arsenic adsorption on iron species by EC process using the Langmuir’s Isotherm. Thermodynamic parameters such as , , and were calculated. It was found that the adsorption process is exothermic and spontaneous. Some experiments were conducted to determine the optimum operating conditions such as current density, pH, and residence time. Also in this study, X-Ray Diffraction, Scanning Electron Microscopy, Mössbauer Spectroscopy, and Fourier Transform infrared spectroscopy were used to characterize the EC solid products that revealed the expected crystalline iron oxides (lepidocrocite, magnetite, gohetite, and iron oxide).- 15 November 2009
- Published by Wiley in Journal of Metallurgy
- Vol. 2009, 1-9
Open AccessThermodynamic Studies of the Arsenic Adsorption on Iron Species Generated by Electrocoagulation
Protection of global environment and sustainable sources of clean water are a necessity for human survival. The wide use of heavy metals by modern industries has generated heavy metals containing wastes and by-products. Specifically, large quantities of arsenic compounds are being discharged into the environment. The full potential of Electrocoagulation (EC) with air injection as an alternative wastewater treatment technique to remove arsenic from water showed more than 99 percent of removal without adding any chemicals. This study has been carried out to determine the feasibility of arsenic adsorption on iron species by EC process using the Langmuir’s Isotherm. Thermodynamic parameters such as , , and were calculated. It was found that the adsorption process is exothermic and spontaneous. Some experiments were conducted to determine the optimum operating conditions such as current density, pH, and residence time. Also in this study, X-Ray Diffraction, Scanning Electron Microscopy, Mössbauer Spectroscopy, and Fourier Transform infrared spectroscopy were used to characterize the EC solid products that revealed the expected crystalline iron oxides (lepidocrocite, magnetite, gohetite, and iron oxide). - 28 April 2005
- Published by Wiley in Chemical Engineering & Technology
- Vol. 28 (5) , 605-612
Characterization of Electrocoagulation for Removal of Chromium and Arsenic
Protection of the global environment and, in particular, providing a sustainable source of clean water is a necessity for human survival. The wide use of heavy metals by modern industries has generated by‐products containing heavy metals. Specifically, large quantities of chromium and arsenic containing compounds are being discharged into the environment. This study has been conducted to determine the feasibility of an electrocoagulation (EC) process using air injection to remove these inorganic elements with iron electrodes. Powder X‐ray diffraction, scanning electron microscopy, and transmission Mössbauer spectroscopy were used to characterize the solid products formed at iron electrodes during EC. The results of this study suggest that magnetite particles and amorphous iron oxyhydroxides are present in the examined EC products. The field pilot‐scale study demonstrated the removal of Cr(VI)/Cr(III) and As(III)/As(V) with an efficiency of more than 99 % from both wastewater and wells.
- 28 April 2005
- Published by Wiley in Chemical Engineering & Technology
- Vol. 28 (5) , 605-612
Characterization of Electrocoagulation for Removal of Chromium and Arsenic
Protection of the global environment and, in particular, providing a sustainable source of clean water is a necessity for human survival. The wide use of heavy metals by modern industries has generated by‐products containing heavy metals. Specifically, large quantities of chromium and arsenic containing compounds are being discharged into the environment. This study has been conducted to determine the feasibility of an electrocoagulation (EC) process using air injection to remove these inorganic elements with iron electrodes. Powder X‐ray diffraction, scanning electron microscopy, and transmission Mössbauer spectroscopy were used to characterize the solid products formed at iron electrodes during EC. The results of this study suggest that magnetite particles and amorphous iron oxyhydroxides are present in the examined EC products. The field pilot‐scale study demonstrated the removal of Cr(VI)/Cr(III) and As(III)/As(V) with an efficiency of more than 99 % from both wastewater and wells.
- 27 March 2003
- Published by Wiley in Chemical Engineering & Technology
- Vol. 26 (4) , 503-507
Enhance Cyanide Recovery by UsingAir-Sparged Hydrocyclone
- 27 March 2003
- Published by Wiley in Chemical Engineering & Technology
- Vol. 26 (4) , 503-507
Enhance Cyanide Recovery by UsingAir-Sparged Hydrocyclone