Shutao Wang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Shutao Wang has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Baicang Liu
State Key Laboratory of Hydraulics and Mountain River Engineering, College of Architecture and Environment, Sichuan University, Chengdu, Sichuan 610065, PR China; Yibin Institute of Industrial Technology, Sichuan University Yibin Park, Yibin, Sichuan 644000, PR China
2 shared publications Jun Ma
2 shared publicationsGuang-De Zhang
1 shared publicationHaiyang Zhang
1 shared publicationHong Wang
1 shared publication- Hui-Ling Liu1 shared publication
Latest Publications
- 1 May 2010
- Published by American Society of Civil Engineers (ASCE) in Journal of Environmental Engineering
- Vol. 136 (5) , 501-507
Two-Dimensional LDV Measurement, Modeling, and Optimal Design of Rectangular Primary Settling Tanks
To optimize the design parameters of rectangular primary settling tanks, we used two-dimensional laser Doppler velocimetry (2D LDV) to conduct flow field measurements in five cases and used a previous model to simulate the flow field. The relative baffle submergence height and the ratio of tank length to height were optimized in a low suspended solid (LSS) concentration . The experimental and simulation results show that a large recirculation zone exists behind the reaction baffle and the flow magnitude is small in the recirculation region; the length of recirculation increases with an increasing flow rate; the length of recirculation increases as the depth of the submerged reaction baffle increases; and the variation of the reaction baffle height can affect the flow field more significantly than does the variation of the flow rate. We also determined that to reach a higher removal rate and to optimize the area dimensions of a sedimentation tank, a length-to-height design ratio between 8 and 12 is optimal.- 1 May 2010
- Published by American Society of Civil Engineers (ASCE) in Journal of Environmental Engineering
- Vol. 136 (5) , 501-507
Two-Dimensional LDV Measurement, Modeling, and Optimal Design of Rectangular Primary Settling Tanks
To optimize the design parameters of rectangular primary settling tanks, we used two-dimensional laser Doppler velocimetry (2D LDV) to conduct flow field measurements in five cases and used a previous model to simulate the flow field. The relative baffle submergence height and the ratio of tank length to height were optimized in a low suspended solid (LSS) concentration . The experimental and simulation results show that a large recirculation zone exists behind the reaction baffle and the flow magnitude is small in the recirculation region; the length of recirculation increases with an increasing flow rate; the length of recirculation increases as the depth of the submerged reaction baffle increases; and the variation of the reaction baffle height can affect the flow field more significantly than does the variation of the flow rate. We also determined that to reach a higher removal rate and to optimize the area dimensions of a sedimentation tank, a length-to-height design ratio between 8 and 12 is optimal.- 15 April 2009
- Vol. 30 (4) , 1099-104
[Analysis of the secondary effluent of municipal wastewater in north China].
The secondary effluent from a municipal sewage treatment plant was fractionated into three parts: the dissolved, the near-colloidal and the suspended. The variation of each composition was investigated individually during winter, spring and summer. The fractionation study revealed that the dissolved COD and DOC accounted for 78.2%-86.5% of total COD and 82.6%-86.6% of TOC, respectively. The molecular weight distribution (MWD) of the secondary effluent indicated that the organics with molecular weight (MW) < 1000 accounted for 56.3%-62.8% of total organics. The organic components constituted 75.54%-89.93 % of the mixture of suspended and near-colloidal matter. The size distribution of the particles showed that the particles ranging from 2.00 to 6.84 microm constituted more than 80% of the total particles. The secondary effluent was relatively poor biodegradable with only 0.195-0.283 of BOD5/COD ratio and 0.156-0.26 of BDOC/DOC ratio. The GC/MS analysis detected 43 and 26 kinds of compounds in dissolved and in suspended forms, respectively, and most of them are bio-refractory according to the functional groups of the chemicals. Biodegradability of the secondary effluent should be enhanced for improving the sequential biochemical removal efficiency for the organic matter.
- 15 April 2009
- Vol. 30 (4) , 1099-104
[Analysis of the secondary effluent of municipal wastewater in north China].
The secondary effluent from a municipal sewage treatment plant was fractionated into three parts: the dissolved, the near-colloidal and the suspended. The variation of each composition was investigated individually during winter, spring and summer. The fractionation study revealed that the dissolved COD and DOC accounted for 78.2%-86.5% of total COD and 82.6%-86.6% of TOC, respectively. The molecular weight distribution (MWD) of the secondary effluent indicated that the organics with molecular weight (MW) < 1000 accounted for 56.3%-62.8% of total organics. The organic components constituted 75.54%-89.93 % of the mixture of suspended and near-colloidal matter. The size distribution of the particles showed that the particles ranging from 2.00 to 6.84 microm constituted more than 80% of the total particles. The secondary effluent was relatively poor biodegradable with only 0.195-0.283 of BOD5/COD ratio and 0.156-0.26 of BDOC/DOC ratio. The GC/MS analysis detected 43 and 26 kinds of compounds in dissolved and in suspended forms, respectively, and most of them are bio-refractory according to the functional groups of the chemicals. Biodegradability of the secondary effluent should be enhanced for improving the sequential biochemical removal efficiency for the organic matter.
- 1 January 2008
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 150 (1) , 109-114
Degradation characteristics of secondary effluent of domestic wastewater by combined process of ozonation and biofiltration
- 1 January 2008
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 150 (1) , 109-114
Degradation characteristics of secondary effluent of domestic wastewater by combined process of ozonation and biofiltration