Takenori Oida
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Takenori Oida has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
Tetsuo Kobayashi
Department of Electrical Engineering, Kyoto University, Kyoto, Japan
2 shared publications- Tetsuo Kobayashi
Department of Biological Mechanisms and Functions, Graduate School of Bioagricultural Sciences, Nagoya University, Nagoya, Japan
2 shared publications - Yosuke Ito
Department of Electrical Engineering, Graduate School of Engineering, Kyoto University , Kyoto
2 shared publications Atsushi Fukuma
Institute for Frontier Medical Sciences, Kyoto University
1 shared publicationHiroaki Natsukawa
Graduate School of Engineering, Kyoto University, Kyoto 615-8510, Japan
1 shared publicationHiroaki Seki
Department of Electrical Engineering, Graduate School of Engineering, Kyoto University, Kyoto-Daigaku-Katsura, Nishikyo-Ku, Kyoto 615-8510, Japan
1 shared publication
Latest Publications
- 1 October 2018
- Published by Elsevier in Journal of Magnetic Resonance
- Vol. 295, 38-44
Dynamics of magnetization under stimulus-induced rotary saturation sequence
- 1 October 2018
- Published by Elsevier in Journal of Magnetic Resonance
- Vol. 295, 38-44
Dynamics of magnetization under stimulus-induced rotary saturation sequence
- 1 January 2017
- Published by Elsevier in Journal of Magnetic Resonance
- Vol. 274, 89-94
Remote detected Low-Field MRI using an optically pumped atomic magnetometer combined with a liquid cooled pre-polarization coil
- 1 January 2017
- Published by Elsevier in Journal of Magnetic Resonance
- Vol. 274, 89-94
Remote detected Low-Field MRI using an optically pumped atomic magnetometer combined with a liquid cooled pre-polarization coil
- 24 October 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 15 (3) , 1732-1737
Actively Shielded Bias Field Tuning Coil for Optically Pumped Atomic Magnetometer Toward Ultralow Field MRI
In this paper, we describe a method for directly detecting magnetic resonance (MR) signals using optically pumped atomic magnetometers (OPAMs) in ultra-low-field MR imaging (ULF-MRI). For direct detection with OPAMs in ULF-MRI, we propose the use of an actively shielded bias field tuning coil to match the resonant frequencies between MR signals and OPAM. Design of the tuning coil was based on both a target field approach and a stream function method. The results of field distribution analyses demonstrated that the resonant frequency of an OPAM could be tuned by the actively shielded bias field tuning coil. In addition, the actively shielded bias field tuning coil minimized the distortion of an external magnetic field in the sample region. These results indicate that actively shielded bias field tuning coil can be designed to match the resonant frequencies of MR signal and an OPAM with the inhomogeneity of sample region <;0.25%. However, the actively shielded bias field tuning coil must be fabricated with an error of 0.5 mm or less between the centers of the primary and shield coils.
- 24 October 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 15 (3) , 1732-1737
Actively Shielded Bias Field Tuning Coil for Optically Pumped Atomic Magnetometer Toward Ultralow Field MRI
In this paper, we describe a method for directly detecting magnetic resonance (MR) signals using optically pumped atomic magnetometers (OPAMs) in ultra-low-field MR imaging (ULF-MRI). For direct detection with OPAMs in ULF-MRI, we propose the use of an actively shielded bias field tuning coil to match the resonant frequencies between MR signals and OPAM. Design of the tuning coil was based on both a target field approach and a stream function method. The results of field distribution analyses demonstrated that the resonant frequency of an OPAM could be tuned by the actively shielded bias field tuning coil. In addition, the actively shielded bias field tuning coil minimized the distortion of an external magnetic field in the sample region. These results indicate that actively shielded bias field tuning coil can be designed to match the resonant frequencies of MR signal and an OPAM with the inhomogeneity of sample region <;0.25%. However, the actively shielded bias field tuning coil must be fabricated with an error of 0.5 mm or less between the centers of the primary and shield coils.
- 1 April 2012
- Published by Elsevier in Journal of Magnetic Resonance
- Vol. 217, 6-9
Detecting rotating magnetic fields using optically pumped atomic magnetometers for measuring ultra-low-field magnetic resonance signals
- 1 April 2012
- Published by Elsevier in Journal of Magnetic Resonance
- Vol. 217, 6-9
Detecting rotating magnetic fields using optically pumped atomic magnetometers for measuring ultra-low-field magnetic resonance signals
- Open Access
- 1 January 2011
- Published by Japanese Society for Magnetic Resonance in Medicine in Magnetic Resonance in Medical Sciences
- Vol. 10 (2) , 121-128
Acquisition Parameters for Diffusion Tensor Imaging to Emphasize Fractional Anisotropy: Phantom Study
Diffusion tensor imaging (DTI) is a magnetic resonance (MR) imaging technique that has attracted attention in recent years for applications such as nerve fiber tracking, neurography, and tumor detection. In DTI measurements, 2 motion-probing gradient (MPG) pulses are applied to evaluate water diffusion. In DTI for nerve fiber tracking, acquisition parameters, such as strength, duration, and separation of MPGs, influence the MR signal. In this study, we set acquisition parameters in DTI to emphasize fractional anisotropy to clarify the direction of nerve fibers. We performed Monte Carlo simulations of restricted diffusion in a cylinder model and phantom measurements with capillary plates to examine the relationship between the acquisition parameters in DTI and the size of restricted structures, particularly their diameter and length, which we will refer to as “compartment size.” We confirmed that normalized signal intensities in DTI measurements depend on diffusion time, which, in turn, depends on the separation and duration of the MPG, and they decrease with increase in compartment size. Furthermore, our simulation and phantom results suggest that use of a longer diffusion time effectively emphasizes fractional anisotropy to clarify the direction of nerve fibers.
- 1 January 2011
- Published by Japanese Society for Magnetic Resonance in Medicine in Magnetic Resonance in Medical Sciences
- Vol. 10 (2) , 121-128
Open AccessAcquisition Parameters for Diffusion Tensor Imaging to Emphasize Fractional Anisotropy: Phantom Study
Diffusion tensor imaging (DTI) is a magnetic resonance (MR) imaging technique that has attracted attention in recent years for applications such as nerve fiber tracking, neurography, and tumor detection. In DTI measurements, 2 motion-probing gradient (MPG) pulses are applied to evaluate water diffusion. In DTI for nerve fiber tracking, acquisition parameters, such as strength, duration, and separation of MPGs, influence the MR signal. In this study, we set acquisition parameters in DTI to emphasize fractional anisotropy to clarify the direction of nerve fibers. We performed Monte Carlo simulations of restricted diffusion in a cylinder model and phantom measurements with capillary plates to examine the relationship between the acquisition parameters in DTI and the size of restricted structures, particularly their diameter and length, which we will refer to as “compartment size.” We confirmed that normalized signal intensities in DTI measurements depend on diffusion time, which, in turn, depends on the separation and duration of the MPG, and they decrease with increase in compartment size. Furthermore, our simulation and phantom results suggest that use of a longer diffusion time effectively emphasizes fractional anisotropy to clarify the direction of nerve fibers.
- Open Access
- 1 January 2006
- Published by Japan Society of Mechanical Engineers in The Proceedings of the Bioengineering Conference Annual Meeting of BED/JSME
- Vol. 2005.18, 303-304
502 Evaluation for in-vivo 3-D mechanical properties of skeletal muscles with Magnetic Resonance Elastography
- 1 January 2006
- Published by Japan Society of Mechanical Engineers in The Proceedings of the Bioengineering Conference Annual Meeting of BED/JSME
- Vol. 2005.18, 303-304
Open Access502 Evaluation for in-vivo 3-D mechanical properties of skeletal muscles with Magnetic Resonance Elastography