Doosun Kang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Doosun Kang has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- Kevin Lansey
University of Arizona
2 shared publications - Fei Du
Dept. of Chemical and Environmental Engineering, Univ. of Arizona, Tucson, AZ
1 shared publication - Gwendolyn J. Woods
Dept. of Chemical and Environmental Engineering, Univ. of Arizona, Tucson, AZ
1 shared publication - Robert G. Arnold
Department of Chemical and Environmental Engineering, University of Arizona, Tucson, AZ 85721, USA, Tel.: +1 (520) 621-2410
1 shared publication
Latest Publications
- 1 May 2013
- Published by American Society of Civil Engineers (ASCE) in Journal of Environmental Engineering
- Vol. 139 (5) , 703-711
Life Cycle Analysis for Water and Wastewater Pipe Materials
A life cycle analysis (LCA) was performed for six commonly used types of water and wastewater pipe materials: polyvinyl chloride (PVC), ductile iron, cast iron, high density polyethylene (HDPE), concrete, and reinforced concrete. The objectives were to (1) compare the six pipe materials in terms of global warming potential (GWP) through four LCA phases: pipe production, transport, installation, and use; (2) determine the primary source(s) of differences in LCA results; and (3) examine the effectiveness of currently used pipe size selection criteria when LCA GWP is considered. The results for unit lengths of discrete pipe sizes were used to generate functions relating GWP per kilometer of pipe to diameter and material selections. The LCA results were monetized using an emission penalty of ton of . For pipe diameters , GWP due to pipe manufacture, transport, and installation of ductile iron pipe was the largest among the six materials. At diameters , the GWP of PVC was highest. Concrete pipe resulted in the lowest GWP across the entire range of pipe sizes investigated. The GWP for pipe production, transport, and installation in a high-growth planning area in southeast Tucson, Arizona, was approximately one-tenth of the GWP derived from pipe network operation. The lifetime GWP from production, transport, and installation increased monotonically with pipe diameter for all materials analyzed, whereas, for a given flow, GWP from energy loss due to friction in flow simulations was inversely related to pipe diameter. The tradeoff suggests that there is an optimum diameter that minimizes lifetime GWP. However, optimum pipe sizes based on GWP were similar to pipe diameters selected based on economic cost alone, suggesting that LCA of water distribution and wastewater collection systems will not yield major changes in criteria for selection of pipe size.- 1 May 2013
- Published by American Society of Civil Engineers (ASCE) in Journal of Environmental Engineering
- Vol. 139 (5) , 703-711
Life Cycle Analysis for Water and Wastewater Pipe Materials
A life cycle analysis (LCA) was performed for six commonly used types of water and wastewater pipe materials: polyvinyl chloride (PVC), ductile iron, cast iron, high density polyethylene (HDPE), concrete, and reinforced concrete. The objectives were to (1) compare the six pipe materials in terms of global warming potential (GWP) through four LCA phases: pipe production, transport, installation, and use; (2) determine the primary source(s) of differences in LCA results; and (3) examine the effectiveness of currently used pipe size selection criteria when LCA GWP is considered. The results for unit lengths of discrete pipe sizes were used to generate functions relating GWP per kilometer of pipe to diameter and material selections. The LCA results were monetized using an emission penalty of ton of . For pipe diameters , GWP due to pipe manufacture, transport, and installation of ductile iron pipe was the largest among the six materials. At diameters , the GWP of PVC was highest. Concrete pipe resulted in the lowest GWP across the entire range of pipe sizes investigated. The GWP for pipe production, transport, and installation in a high-growth planning area in southeast Tucson, Arizona, was approximately one-tenth of the GWP derived from pipe network operation. The lifetime GWP from production, transport, and installation increased monotonically with pipe diameter for all materials analyzed, whereas, for a given flow, GWP from energy loss due to friction in flow simulations was inversely related to pipe diameter. The tradeoff suggests that there is an optimum diameter that minimizes lifetime GWP. However, optimum pipe sizes based on GWP were similar to pipe diameters selected based on economic cost alone, suggesting that LCA of water distribution and wastewater collection systems will not yield major changes in criteria for selection of pipe size.- 1 May 2012
- Published by American Society of Civil Engineers (ASCE) in Journal of Water Resources Planning and Management
- Vol. 138 (3) , 208-217
Revisiting Optimal Water-Distribution System Design: Issues and a Heuristic Hierarchical Approach
For the past three decades, a number of studies have been dedicated to water-distribution system (WDS) optimal design using alternative optimization algorithms. Many of those, however, focused on the introduction and application of new optimization techniques. Application systems optimized in previous studies are generally limited to simple transmission networks, so-called benchmark systems, in which local distribution lines were mostly excluded. Efforts seeking logical approaches to solve complex problems with large number of decisions are lacking. In this paper, logical and efficient approaches that could be utilized to optimize real-life scale WDS by the aid of existing optimization techniques are presented. This study aimed two main objectives: first, the effect of local distribution lines in final system design is investigated, and second, a heuristic to improve the efficiency of meta-heuristic search methods is proposed. Applications to real WDS demonstrate that (1) by integrating the transm...
- 1 May 2012
- Published by American Society of Civil Engineers (ASCE) in Journal of Water Resources Planning and Management
- Vol. 138 (3) , 208-217
Revisiting Optimal Water-Distribution System Design: Issues and a Heuristic Hierarchical Approach
For the past three decades, a number of studies have been dedicated to water-distribution system (WDS) optimal design using alternative optimization algorithms. Many of those, however, focused on the introduction and application of new optimization techniques. Application systems optimized in previous studies are generally limited to simple transmission networks, so-called benchmark systems, in which local distribution lines were mostly excluded. Efforts seeking logical approaches to solve complex problems with large number of decisions are lacking. In this paper, logical and efficient approaches that could be utilized to optimize real-life scale WDS by the aid of existing optimization techniques are presented. This study aimed two main objectives: first, the effect of local distribution lines in final system design is investigated, and second, a heuristic to improve the efficiency of meta-heuristic search methods is proposed. Applications to real WDS demonstrate that (1) by integrating the transm...