Joel N. Ullom
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Joel N. Ullom has a total of 37 co-authors. Here are the top co-authors by number of shared publications:
- Galen C. O'NEil
National Institute of Standards and Technology Boulder CO
2 shared publications Gene C. Hilton
National Institute of Standards and Technology , Boulder, Colorado 80305, United States
2 shared publicationsJason M. Underwood
2 shared publications- Kent D. Irwin
Stanford University
2 shared publications Leila R. Vale
2 shared publicationsPeter J. Lowell
2 shared publications
Latest Publications
- 22 February 2017
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry Letters
- Vol. 8 (5) , 1099-1104
Ultrafast Time-Resolved X-ray Absorption Spectroscopy of Ferrioxalate Photolysis with a Laser Plasma X-ray Source and Microcalorimeter Array
The detailed pathways of photoactivity on ultrafast time scales are a topic of contemporary interest. Using a tabletop apparatus based on a laser plasma X-ray source and an array of cryogenic microcalorimeter X-ray detectors, we measured a transient X-ray absorption spectrum during the ferrioxalate photoreduction reaction. With these high-efficiency detectors, we observe the Fe K edge move to lower energies and the amplitude of the extended X-ray absorption fine structure reduce, consistent with a photoreduction mechanism in which electron transfer precedes disassociation. These results are compared to previously published transient X-ray absorption measurements on the same reaction and found to be consistent with the results from Ogi et al. and inconsistent with the results of Chen et al. ( Ogi , Y. ; et al. Struct. Dyn. 2015 , 2 , 034901; Chen , J. ; Zhang , H. ; Tomov , I. V. ; Ding , X. ; Rentzepis , P. M. Chem. Phys. Lett. 2007 , 437 , 50 – 55). We provide quantitative limits on the Fe–O bond length change. Finally, we review potential improvements to our measurement technique, highlighting the future potential of tabletop X-ray science using microcalorimeter sensors.
- 22 February 2017
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry Letters
- Vol. 8 (5) , 1099-1104
Ultrafast Time-Resolved X-ray Absorption Spectroscopy of Ferrioxalate Photolysis with a Laser Plasma X-ray Source and Microcalorimeter Array
The detailed pathways of photoactivity on ultrafast time scales are a topic of contemporary interest. Using a tabletop apparatus based on a laser plasma X-ray source and an array of cryogenic microcalorimeter X-ray detectors, we measured a transient X-ray absorption spectrum during the ferrioxalate photoreduction reaction. With these high-efficiency detectors, we observe the Fe K edge move to lower energies and the amplitude of the extended X-ray absorption fine structure reduce, consistent with a photoreduction mechanism in which electron transfer precedes disassociation. These results are compared to previously published transient X-ray absorption measurements on the same reaction and found to be consistent with the results from Ogi et al. and inconsistent with the results of Chen et al. ( Ogi , Y. ; et al. Struct. Dyn. 2015 , 2 , 034901; Chen , J. ; Zhang , H. ; Tomov , I. V. ; Ding , X. ; Rentzepis , P. M. Chem. Phys. Lett. 2007 , 437 , 50 – 55). We provide quantitative limits on the Fe–O bond length change. Finally, we review potential improvements to our measurement technique, highlighting the future potential of tabletop X-ray science using microcalorimeter sensors.
- 5 April 2012
- Published by American Physical Society (APS) in Physical Review B
- Vol. 85 (13)
Measurement and modeling of a large-area normal-metal/insulator/superconductor refrigerator with improved cooling
In a normal-metal/insulator/superconductor (NIS) tunnel junction refrigerator, the normal-metal electrons are cooled and the dissipated power heats the superconducting electrode. This paper presents a review of the mechanisms by which heat leaves the superconductor and introduces overlayer quasiparticle traps for more effective heat sinking. A comprehensive thermal model is presented that accounts for the described physics, including the behavior of athermal phonons generated by both quasiparticle recombination and trapped quasiparticles. We compare the model to measurements of a large-area (>400$\mu${}m2) NIS refrigerator with overlayer quasiparticle traps, and demonstrate that the model is in good agreement experiment. The refrigerator IV curve at a bath temperature of 300 mK is consistent with an electron temperature of 82 mK. However, evidence from independent thermometer junctions suggests that the refrigerator junction is creating an athermal electron whose total excitation energy corresponds to a higher temperature than is indicated by the refrigerator IV curve.
- 5 April 2012
- Published by American Physical Society (APS) in Physical Review B
- Vol. 85 (13)
Measurement and modeling of a large-area normal-metal/insulator/superconductor refrigerator with improved cooling
In a normal-metal/insulator/superconductor (NIS) tunnel junction refrigerator, the normal-metal electrons are cooled and the dissipated power heats the superconducting electrode. This paper presents a review of the mechanisms by which heat leaves the superconductor and introduces overlayer quasiparticle traps for more effective heat sinking. A comprehensive thermal model is presented that accounts for the described physics, including the behavior of athermal phonons generated by both quasiparticle recombination and trapped quasiparticles. We compare the model to measurements of a large-area (>400$\mu${}m2) NIS refrigerator with overlayer quasiparticle traps, and demonstrate that the model is in good agreement experiment. The refrigerator IV curve at a bath temperature of 300 mK is consistent with an electron temperature of 82 mK. However, evidence from independent thermometer junctions suggests that the refrigerator junction is creating an athermal electron whose total excitation energy corresponds to a higher temperature than is indicated by the refrigerator IV curve.
- Open Access
Observations and modeling of large area normal-metal/insulator/superconductor refrigerator cooling from 300 mK to below 100 mK
In a normal-metal/insulator/superconductor (NIS) tunnel junction refrigerator, the normal-metal electrons are cooled and the dissipated power heats the superconducting electrode. This paper presents a review of the mechanisms by which heat leaves the superconductor and introduces overlayer quasiparticle traps for more effective heatsinking. A comprehensive thermal model is presented that accounts for the described physics, including the behavior of athermal phonons generated by both quasiparticle recombination and trapped quasiparticles. We compare the model to measurements of a large area (>400 um^2) NIS refrigerator with overlayer quasiparticle traps, and demonstrate that the model is in good agreement experiment. The refrigerator IV curve at a bath temperature of 300 mK is consistent with an electron temperature of 82 mK. However, evidence from independent thermometer junctions suggests that the refrigerator junction is creating an athermal electron distribution whose total excitation energy corresponds to a higher temperature than is indicated by the refrigerator IV curve.
Open AccessObservations and modeling of large area normal-metal/insulator/superconductor refrigerator cooling from 300 mK to below 100 mK
In a normal-metal/insulator/superconductor (NIS) tunnel junction refrigerator, the normal-metal electrons are cooled and the dissipated power heats the superconducting electrode. This paper presents a review of the mechanisms by which heat leaves the superconductor and introduces overlayer quasiparticle traps for more effective heatsinking. A comprehensive thermal model is presented that accounts for the described physics, including the behavior of athermal phonons generated by both quasiparticle recombination and trapped quasiparticles. We compare the model to measurements of a large area (>400 um^2) NIS refrigerator with overlayer quasiparticle traps, and demonstrate that the model is in good agreement experiment. The refrigerator IV curve at a bath temperature of 300 mK is consistent with an electron temperature of 82 mK. However, evidence from independent thermometer junctions suggests that the refrigerator junction is creating an athermal electron distribution whose total excitation energy corresponds to a higher temperature than is indicated by the refrigerator IV curve.
- 18 August 2009
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nuclear Science
- Vol. 56 (4) , 2294-2298
Application of GEANT4 to the Simulation of High Energy-Resolution Microcalorimeter Detectors
GEANT4 is a versatile Monte Carlo code for simulating the interactions of radiation with matter. GEANT4 has proven to be an effective toolkit for the simulation of a wide variety of detectors. We are interested in the application of GEANT4 to a new type of sensor technology being developed for X-ray and gamma-ray measurements. Microcalorimeter detectors based on transition-edge sensors coupled to bulk absorbers are an emerging technology for hard X-ray and soft gamma-ray measurements with unprecedented energy resolution. In this work, we assess the ability of the GEANT4 electromagnetic physics package to reproduce measured microcalorimeter data. We also use the simulations to explore the design space of absorber materials and cryostat design.
- 18 August 2009
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nuclear Science
- Vol. 56 (4) , 2294-2298
Application of GEANT4 to the Simulation of High Energy-Resolution Microcalorimeter Detectors
GEANT4 is a versatile Monte Carlo code for simulating the interactions of radiation with matter. GEANT4 has proven to be an effective toolkit for the simulation of a wide variety of detectors. We are interested in the application of GEANT4 to a new type of sensor technology being developed for X-ray and gamma-ray measurements. Microcalorimeter detectors based on transition-edge sensors coupled to bulk absorbers are an emerging technology for hard X-ray and soft gamma-ray measurements with unprecedented energy resolution. In this work, we assess the ability of the GEANT4 electromagnetic physics package to reproduce measured microcalorimeter data. We also use the simulations to explore the design space of absorber materials and cryostat design.
- 12 July 2008
- Published by SPIE-Intl Soc Optical Eng
- Vol. 7011, 70113T-70113
Recent developments in transition-edge strip detectors for solar x-rays
LMSAL and NIST are developing position-sensitive x-ray strip detectors based on Transition Edge Sensor (TES) microcalorimeters optimized for solar physics. By combining high spectral (E/ΔE ~1600) and temporal (single photon Δt ~10μs) resolutions with imaging capabilities, these devices will be able to study high-temperature (>10 MK) x-ray lines as never before. Diagnostics from these lines should provide significant new insight into the physics of both microflares and the early stages of flares. Previously, the large size of traditional TESs, along with the heat loads associated with wiring large arrays, presented obstacles to using these cryogenic detectors for solar missions. Implementing strip detector technology at small scales, however, addresses both issues: here, a line of substantially smaller effective pixels requires only two TESs, decreasing both the total array size and the wiring requirements for the same spatial resolution. Early results show energy resolutions of Δ ΕFWHM ~30eV and spatial resolutions of ~10-15 μm, suggesting the strip-detector concept is viable.
- 12 July 2008
- Published by SPIE-Intl Soc Optical Eng
- Vol. 7011, 70113T-70113
Recent developments in transition-edge strip detectors for solar x-rays
LMSAL and NIST are developing position-sensitive x-ray strip detectors based on Transition Edge Sensor (TES) microcalorimeters optimized for solar physics. By combining high spectral (E/ΔE ~1600) and temporal (single photon Δt ~10μs) resolutions with imaging capabilities, these devices will be able to study high-temperature (>10 MK) x-ray lines as never before. Diagnostics from these lines should provide significant new insight into the physics of both microflares and the early stages of flares. Previously, the large size of traditional TESs, along with the heat loads associated with wiring large arrays, presented obstacles to using these cryogenic detectors for solar missions. Implementing strip detector technology at small scales, however, addresses both issues: here, a line of substantially smaller effective pixels requires only two TESs, decreasing both the total array size and the wiring requirements for the same spatial resolution. Early results show energy resolutions of Δ ΕFWHM ~30eV and spatial resolutions of ~10-15 μm, suggesting the strip-detector concept is viable.