Koichi Kita
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Koichi Kita has a total of 2 co-authors. Here are the top co-authors by number of shared publications:
- Atsushi Konno
Tohoku University
3 shared publications - Masaru Uchiyama
Tōhoku Univ
3 shared publications
Latest Publications
- 1 January 2010
- Published by Taylor & Francis in Advanced Robotics
- Vol. 24 (5-6) , 763-781
Transition between Level Flight and Hovering of a Tail-Sitter Vertical Takeoff and Landing Aerial Robot
This paper presents the vertical takeoff, landing and transition between level flight and hovering of a tail-sitter vertical takeoff and landing (VTOL) aerial robot. The tail-sitter is suitable for micro aerial vehicles because it does not need any extra equipment for the VTOL maneuver. The developed tail-sitter aerial robot is equipped with four actuators for controlling ailerons, an elevator, a rudder and a propeller. A micro computer, various sensors and a battery are mounted on the aerial robot for autonomous flight without any support from a ground system. A transition flight strategy is constructed so that the transition finishes in the shortest time restricting an altitude change. In order to achieve the transition strategy, the reference trajectory of the pitch angle is computed offline by using an optimization technique. In the transition flight control system, a PID feedback controller is applied to attitude control, while a feedforward controller is applied to altitude control. The gain scheduling is applied to the control of the rudder and aileron. The experimental results on the transition between level flight and hovering, takeoff, and landing are presented.
- 1 January 2010
- Published by Taylor & Francis in Advanced Robotics
- Vol. 24 (5-6) , 763-781
Transition between Level Flight and Hovering of a Tail-Sitter Vertical Takeoff and Landing Aerial Robot
This paper presents the vertical takeoff, landing and transition between level flight and hovering of a tail-sitter vertical takeoff and landing (VTOL) aerial robot. The tail-sitter is suitable for micro aerial vehicles because it does not need any extra equipment for the VTOL maneuver. The developed tail-sitter aerial robot is equipped with four actuators for controlling ailerons, an elevator, a rudder and a propeller. A micro computer, various sensors and a battery are mounted on the aerial robot for autonomous flight without any support from a ground system. A transition flight strategy is constructed so that the transition finishes in the shortest time restricting an altitude change. In order to achieve the transition strategy, the reference trajectory of the pitch angle is computed offline by using an optimization technique. In the transition flight control system, a PID feedback controller is applied to attitude control, while a feedforward controller is applied to altitude control. The gain scheduling is applied to the control of the rudder and aileron. The experimental results on the transition between level flight and hovering, takeoff, and landing are presented.
- 1 January 2009
- Published by Japan Society of Mechanical Engineers in The Proceedings of JSME annual Conference on Robotics and Mechatronics (Robomec)
- Vol. 2009, _1A2-E13_1
1A2-E13 Transitions Between Level-Flight and Hovering of a Tail-Sitter VTOL Aerial Robot
Tail-sitter is one of the simplest VTOL aircraft. However, because the flight control is difficult, past researches used special equipments to facilitate controlling. To make aerial robots smaller and simpler, we are developing an aerial robot that excludes these special equipments. Flight of VTOL aircraft can be broadly divided into three phases: vertical flight (including hovering), level-flight, and transition flight. This paper describes transition flight between level-flight and hovering of our tail-sitter VTOL aerial robot. The transition flight was constructed based on strategy that transition finishes in the shortest time and altitude is kept constant. To achieve the transition strategy, modeling and simulation were prepared. Finally, feasibility of the transition strategy and effectiveness of control system were confirmed by flight tests.
- 1 January 2009
- Published by Japan Society of Mechanical Engineers in The Proceedings of JSME annual Conference on Robotics and Mechatronics (Robomec)
- Vol. 2009, _1A2-E13_1
1A2-E13 Transitions Between Level-Flight and Hovering of a Tail-Sitter VTOL Aerial Robot
Tail-sitter is one of the simplest VTOL aircraft. However, because the flight control is difficult, past researches used special equipments to facilitate controlling. To make aerial robots smaller and simpler, we are developing an aerial robot that excludes these special equipments. Flight of VTOL aircraft can be broadly divided into three phases: vertical flight (including hovering), level-flight, and transition flight. This paper describes transition flight between level-flight and hovering of our tail-sitter VTOL aerial robot. The transition flight was constructed based on strategy that transition finishes in the shortest time and altitude is kept constant. To achieve the transition strategy, modeling and simulation were prepared. Finally, feasibility of the transition strategy and effectiveness of control system were confirmed by flight tests.
- 1 January 2008
- Published by Japan Society of Mechanical Engineers in The Proceedings of JSME annual Conference on Robotics and Mechatronics (Robomec)
- Vol. 2008, _1P1-F19_1
1P1-F19
In this study, we developed a tail sitter type VTOL aerial robot, and a basic control system. The VTOL aircraft has advantages of both the rotorcraft and the fixed-wing aircraft. The tail sitter type VTOL aircraft doesn't need an extra actuator for the VTOL action like the tilt rotor type. On the other hand, because the attitude change is large, the control is difficult. The control of the VTOL aerial robot is roughly divided into three phases. The first is the take-off and landing, the second is the transition flight, and the third is the horizontal cruse flight. As the first step for controlling these three phases, we developed and experimented in the hovering control that is a basic maneuver during the take-off and landing.
- 1 January 2008
- Published by Japan Society of Mechanical Engineers in The Proceedings of JSME annual Conference on Robotics and Mechatronics (Robomec)
- Vol. 2008, _1P1-F19_1
1P1-F19
In this study, we developed a tail sitter type VTOL aerial robot, and a basic control system. The VTOL aircraft has advantages of both the rotorcraft and the fixed-wing aircraft. The tail sitter type VTOL aircraft doesn't need an extra actuator for the VTOL action like the tilt rotor type. On the other hand, because the attitude change is large, the control is difficult. The control of the VTOL aerial robot is roughly divided into three phases. The first is the take-off and landing, the second is the transition flight, and the third is the horizontal cruse flight. As the first step for controlling these three phases, we developed and experimented in the hovering control that is a basic maneuver during the take-off and landing.