Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Lenka Kuboňová has a total of 101 co-authors. Here are the top co-authors by number of shared publications:

  • František Hopan

    Centre for Energy and Environmental Technologies, Energy Research Centre, VSB—Technical University of Ostrava, 17. listopadu 2172/15, 708 00 Ostrava, Czech Republic

    14 shared publications
  • Jiří Horák

    Centre for Energy and Environmental Technologies, Energy Research Centre, VSB—Technical University of Ostrava, 17. listopadu 2172/15, 708 00 Ostrava, Czech Republic

    14 shared publications
  • Jiří Ryšavý

    Energy Research Centre, Centre for Energy and Environmental Technologies, VŠB—Technical University of Ostrava, 17. Listopadu 2172/15, 708 00 Ostrava, Czech Republic

    8 shared publications
  • Kamil Krpec

    8 shared publications
  • Oleksandr Molchanov

    Centre for Energy and Environmental Technologies, Energy Research Centre, VSB—Technical University of Ostrava, 17. listopadu 2172/15, 708 00 Ostrava, Czech Republic

    6 shared publications
  • Milan Dej

    Centre for Energy and Environmental Technologies, Energy Research Centre, VSB - Technical University of Ostrava, 17. listopadu 2172/15, 708 00 Ostrava, Poruba, Czech Republic

    5 shared publications

Latest Publications

  • Open Access

    Gaseous and particulate emissions from PET and PS co-combustion with biomass in a domestic boiler: Role of air intake and waste proportion

    by Kuboňová Lenka, Horák Jiří, Jaroch Miroslav, Garba Martin, Kawulokova Monika, Smetana BedřIch, Póliska Csaba

  • Open Access

    The Genotoxic Potential of Organic Emissions from Domestic Boilers Combusting Biomass and Fossil Fuels

    by Jitka Sikorova, Frantisek Hopan, Lenka Kubonova, Jiri Horak, Alena Milcova, Pavel Rossner, Antonin Ambroz, Kamil Krpec, Oleksandr Molchanov, Tana Zavodna

    Solid fuels are still widely used in household heating in Europe and North America. Emissions from boilers are released in proximity to people. Therefore, there is a need to minimise the toxicity of emissions affecting human health to the greatest extent possible. This study compares the genotoxic potential of the emissions of four boilers of modern and old design (automatic, gasification, down-draft, over-fire) operating at reduced output to simulate the real-life combustion fed by various fossil and renewable solid fuels (hard coal, brown coal, brown coal briquettes, wood pellets, wet and dry spruce). Organic emissions were tested for genotoxic potential by analysing bulky DNA adducts and 8-oxo-dG adduct induction. There was no consistent genotoxic pattern among the fuels used within the boilers. Genotoxicity was strongly correlated with polycyclic aromatic hydrocarbon (PAH) content, and even stronger correlation was observed with particulate matter (PM). In all measured variables (PM, PAHs, genotoxicity), the technology of the boilers was a more important factor in determining the genotoxic potential than the fuels burned. The highest levels of both bulky and 8-oxo-dG DNA adducts were induced by organics originating from the over-fire boiler, while the automatic boiler exhibited genotoxic potential that was ~1000- and 100-fold lower, respectively.


  • Open Access

    Emission control of household heating combustion units via catalytic oxidation: A Pt-Pd monolith case

    by Jiří Ryšavý, Estela Alexandra Domingos Vicente, Kamil Krpec, Lenka Kuboňová, Oleksandr Molchanov, Sangeetha Thangavel, Wei-Mon Yan, Gangasalam Arthanareeswaran, Katarzyna Szramowiat-Sala


  • Open Access

    In-situ investigation of real-world emissions from 111 measurements on solid fuel household boilers

    by František Hopan, Martin Chmelář, Jiří Kremer, Milan Dej, Michal Vojtíšek-Lom, Estela D. Vicente, Jiří Ryšavý, Kamil Krpec, Lenka Kuboňová, Alexandr Molčanov, et al.


  • Open Access

    Transformation of NO in Combustion Gases by DC Corona

    by Oleksandr Molchanov, Kamil Krpec, Jiří Horák, Lenka Kuboňová, František Hopan, Jiří Ryšavý, Marcelina Bury

    This study investigates the performance of DC corona discharge electrostatic precipitators (ESPs) for NO conversion to increase DeNOx technologies’ efficiency for small-scale biomass combustion systems. Experiments were conducted using a 5 kW automatic wood pellet domestic heat source with combustion gas treated in a specially designed ESP operated in both positive and negative corona modes, resulting in a reduction in NO concentrations from 130 mg/m3 to 27/29 mg/m3 for positive/negative polarities (at 0 °C and 101.3 kPa). NO conversion efficiency was evaluated across a range of specific input energies (SIEs) from 0 to 50 J/L. The results demonstrate that DC corona ESPs can achieve up to 78% NO reduction, with positive corona demonstrating a greater energy efficiency, requiring a lower SIE (35 J/L) compared to the negative corona mode (48 J/L). A detailed analysis of reaction pathways revealed distinct conversion mechanisms between the two modes. In positive corona, dispersed active species distribution led to more uniform NO conversion, while negative corona exhibited concentrated reaction zones with about 20% higher ozone production. The reactions involving O and OH radicals were more important in positive corona, whereas ozone-mediated oxidation dominated in negative corona. The research results demonstrate that ESP technology with DC corona offers a promising, energy-efficient solution for NOx control in small-scale combustion systems.

  • Open Access

    Application End Evaluation of Electrostatic Precipitation for Control PM and NOx Emissions from Small-Scale Combustions

    by Oleksandr Molchanov, Kamil Krpec, Jiří Horák, Lenka Kuboňová, František Hopan, Jiří Ryšavý

    Electrostatic precipitators (ESPs) have shown promise in reducing particulate matter (PM) emissions, but their potential for simultaneous NOx reduction in small-scale combustion systems remains underexplored. This study focuses on using non-thermal plasma generated in a corona discharge to reduce PM and NOx emissions from small-scale combustion. ESP was specifically designed for a commercially available 15 kW boiler with wood pellet combustion and used with both positive and negative discharge polarity to control emissions without any chemical additives. ESP performance was evaluated across a range of specific input energies (SIE) in terms of particle mass and number concentrations and NOx concentrations obtained by continuous gas analysis. ESP ensured the reduction in PM concentrations from 48 mg/m3 to the magnitude of PM content in the ambient air. The highest precipitation efficiency was observed for particles in the 20–200 nm range. Concurrently, NOx emissions were reduced by up to 78%, from 178 mg/m3 to 39 mg/m3. These results were achieved at specific input energies of 36 for positive and 48 J/L for negative corona, which is significantly lower than those reported for many existing separate PM and NOx control systems. This study demonstrates the potential of ESPs as a compact, energy-efficient solution for simultaneous PM and NOx removal in small-scale combustion systems, offering promising implications for improving air pollution control technologies for small-scale combustion systems.


  • Open Access

    The Bacharach Method: A Low-Cost Tool for Small-Scale Combustion Units’ Flue Gas Quality Control

    by Jiří Ryšavý, Wei-Mon Yan, Thangavel Sangeetha, Jenn-Kun Kuo, Cheng-Chi Wang, František Hopan, Maria Gouveia, Carla Oliveira Henriques, Lenka Kuboňová, Tadeáš Ochodek

    Although current EU regulations, such as EU Directive 2015/1189 on the eco-design of solid fuel boilers and Directive 2015/1188, in accordance with the Machinery Directive 2006/42/EC, require manufacturers to meet specific emission requirements for CE marking, the routine and regular onsite testing of household heating appliances is still not mandatory in many EU countries. This research endeavour addressed this gap by evaluating the effectiveness of the Bacharach method as a rapid and cost-effective tool for assessing flue gas quality, particularly in terms of particulate matter mass concentration. This study also compared the results of the Bacharach method with those obtained from two commercially available portable analysers. The research outcomes demonstrate that the Bacharach method, in combination with an innovative evaluation approach, offers a viable solution, enabling the swift and economical assessment of flue gas quality with the primary objective of determining the boiler class according to the limits specified by standard EN 303-5 under operating conditions. The modified Bacharach method for measuring TSP in solid fuel-fired boilers provides qualitatively similar results to the commercially used SM500 and STM225 instruments. The modified Bacharach methodology was primarily developed for comparison to the boiler class 3 limit (i.e., 125 and 150 mg/m3). The study revealed that the modified Bacharach method, when applied to biomass-based boilers, exhibited higher accuracies in the case of classification into classes 3 and 4, whereas fossil fuel-based boilers demonstrated higher accuracy in the case of class 5 limits.


  • Combined control of PM and NOx emissions by corona discharge

    by Oleksandr Molchanov, Kamil Krpec, Jiří Horák, Lenka Kubonová, František Hopan, Jiří Ryšavý


  • Open Access

    Co-Gasification of Pistachio Shells with Wood Pellets in a Semi-Industrial Hybrid Cross/Updraft Reactor for Producer Gas and Biochar Production

    by Jiří Ryšavý, Jakub Čespiva, Lenka Kuboňová, Milan Dej, Katarzyna Szramowiat-Sala, Oleksandr Molchanov, Lukasz Niedzwiecki, Wei-Mon Yan, Sangeetha Thangavel

    The possibilities of pistachio shell biochar production on laboratory-scale gasification and pyrolysis devices have been described by several previous studies. Nevertheless, the broader results of the pistachio shell co-gasification process on pilot-scale units have not yet been properly investigated or reported, especially regarding the detailed description of the biochar acquired during the routine operation. The biochar was analysed using several analytical techniques, such as ultimate and proximate analysis (62%wt of C), acid–base properties analysis (pH 9.52), Fourier-transform infrared spectroscopy (the presence of –OH bonds and identification of cellulose, hemicellulose and lignin), Raman spectroscopy (no determination of Id/Ig ratio due to high fluorescence), and nitrogen physisorption (specific surface 50.895 m2·g−1). X-ray fluorescence analysis exhibited the composition of the main compounds in the biochar ash (32.5%wt of Cl and 40.02%wt of Na2O). From the energy generation point of view, the lower heating value of the producer gas achieved 6.53 MJ·m−3 during the co-gasification. The relatively high lower heating value of the producer gas was mainly due to the significant volume fractions of CO (6.5%vol.), CH4 (14.2%vol.), and H2 (4.8 %vol.), while hot gas efficiency accomplished 89.6%.