CMChao Ma

Chao Ma

*This is an algorithmically generated author record based on publicly available information.

Chao Ma has a total of 4 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Melt Pool Flow and Surface Evolution During Pulsed Laser Micro Polishing of Ti6Al4V

    by Chao Ma, Madhu Vadali, Neil A. Duffie, Frank E. Pfefferkorn, Xiaochun Li

    Extensive experimental work has shown that pulsed laser micro polishing (PLμP) is effective for polishing micro metallic parts. However, the process physics have not been fully understood yet, especially with respect to the melt pool flow. A reliable physical model can be of significant assistance in understanding the fluid flow in the melt pool and its effect on PLμP. In this paper, a two-dimensional axisymmetric transient model that couples heat transfer and fluid flow is described that was constructed using the finite element method. The model not only provided the solutions to the temperature and velocity fields but also predicted the surface profile evolution on a free deformable surface. The simulated melt depth and resolidified surface profiles matched those obtained from optical images of PLμPed Ti6Al4V sample cross-sections. The model was also used to study the effect of laser pulse duration on the melt pool flow. The study suggests that longer pulses produce more significant fluid flows. The cut-off pulse duration between capillary and thermocapillary regimes, below which minimal Maragoni flow should be expected, was estimated to be 0.66 μs for Ti6Al4V, which also matched well with the experimental results. It is evident that the coupled model offers reliable predictions and thus can be extended for a more complex parametric study to provide further insights for PLμP.


  • Effects of Pulse Duration on Laser Micro Polishing

    by Madhu Vadali, Chao Ma, Neil A. Duffie, Xiaochun Li, Frank E. Pfefferkorn

    Pulsed laser micro polishing (PLμP) has been shown to be an effective method of polishing micro metallic parts whose surface roughness can approach the feature size. Laser pulse duration in the PLμP process is an important parameter that significantly affects the achievable surface finish. This paper describes the influence of laser pulse duration on surface roughness reduction during PLμP. For this purpose, near-infrared laser pulses have been used to polish Ti6Al4V at three different pulse durations: 0.65 μs, 1.91 μs, and 3.60 μs. PLμP at longer pulse durations resulted in dominating Marangoni convective flows, yet significantly higher reductions in the average surface roughness were observed compared to the short pulse duration regime without convection.