Jose Cataldo
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Jose Cataldo has a total of 24 co-authors. Here are the top co-authors by number of shared publications:
Ignacio Rovira
Instituto de Mecánica de los Fluidos e Ingeniería Ambiental, Facultad de Ingeniería, Universidad de la República, Uruguay
2 shared publications- Alejandro Gutiérrez
Universidad de la República
1 shared publication - Alexandre Costa
Center for Renewable Energy, Federal University of Pernambuco, Av. Prof. Moraes Rego, 1235, Recife 50740-550, Brazil
1 shared publication - Bruno Lopez
IMFIA, Facultad de Ingeniería, Universidad de la República, Montevideo 11200, Uruguay
1 shared publication - Daniel González Rodríguez
Department of Nuclear Engineering, Federal University of Pernambuco
1 shared publication Everton De Almeida Lucas
Universidade Federal do Pampa
1 shared publication
Latest Publications
- Open Access
- 21 May 2025
- Published by Copernicus GmbH
Analyzing wind performance at the pedestrian waterfront along South America's Pacific coast through urban design morphology modeling.
Extreme weather events, like storms and tornadoes, are becoming more frequent due to climate change, resulting in wind gusts over 150 km/h in South America's waterfront areas. These conditions threaten lives and urban heritage. For decades, high-rise developments in these locations have followed similar design patterns, obstructing or channeling wind flow in outdoor spaces. This built environment poses challenges for climate-sensitive urban design. To address these issues, it is essential to understand how different urban layouts affect wind performance. This study aims to evaluate the wind performance of urban design morphology in the waterfront of Viña del Mar, a prominent tourist city on South America's Pacific coast. Two geometric arrangements are analyzed: a new circular and a traditional linear. Both designs have heights of up to 25 floors and use the same construction materials. The method involves modeling wind performance using Computational Fluid Dynamics (CFD) during two sample periods: summer (December) and winter (June). The data was extrapolated from a weather station in Viña del Mar to the Con-Con site. According to the wind rose data, the main wind directions for analysis are North-West and South-East. The results connect theoretical wind performance around buildings and the modeling outcomes, highlighting phenomena such as Venturi effects, vortex formation, and wind shadow lengths. Findings reveal that the permeability of urban facades varies between the two layouts. Increasing the distance between buildings reduces the length of wind shadows in linear arrangements. Conversely, circular building arrangements lead to higher wind speeds in outdoor areas facing the windward side.
- 21 May 2025
- Published by Copernicus GmbH
Open AccessAnalyzing wind performance at the pedestrian waterfront along South America's Pacific coast through urban design morphology modeling.
Extreme weather events, like storms and tornadoes, are becoming more frequent due to climate change, resulting in wind gusts over 150 km/h in South America's waterfront areas. These conditions threaten lives and urban heritage. For decades, high-rise developments in these locations have followed similar design patterns, obstructing or channeling wind flow in outdoor spaces. This built environment poses challenges for climate-sensitive urban design. To address these issues, it is essential to understand how different urban layouts affect wind performance. This study aims to evaluate the wind performance of urban design morphology in the waterfront of Viña del Mar, a prominent tourist city on South America's Pacific coast. Two geometric arrangements are analyzed: a new circular and a traditional linear. Both designs have heights of up to 25 floors and use the same construction materials. The method involves modeling wind performance using Computational Fluid Dynamics (CFD) during two sample periods: summer (December) and winter (June). The data was extrapolated from a weather station in Viña del Mar to the Con-Con site. According to the wind rose data, the main wind directions for analysis are North-West and South-East. The results connect theoretical wind performance around buildings and the modeling outcomes, highlighting phenomena such as Venturi effects, vortex formation, and wind shadow lengths. Findings reveal that the permeability of urban facades varies between the two layouts. Increasing the distance between buildings reduces the length of wind shadows in linear arrangements. Conversely, circular building arrangements lead to higher wind speeds in outdoor areas facing the windward side.
- Open Access
- 3 July 2023
- Published by Taylor & Francis in Ribagua
- Vol. 10 (2) , 79-90
Análisis del efecto de las incertidumbres sobre el sistema de regulación de velocidad de una central hidroeléctrica
- 3 July 2023
- Published by Taylor & Francis in Ribagua
- Vol. 10 (2) , 79-90
Open AccessAnálisis del efecto de las incertidumbres sobre el sistema de regulación de velocidad de una central hidroeléctrica
- Open Access
- 2 January 2023
- Published by Taylor & Francis in Ribagua
- Vol. 10 (1) , 18-30
Análisis de las pérdidas de carga en rejas de una central hidroeléctrica
- 2 January 2023
- Published by Taylor & Francis in Ribagua
- Vol. 10 (1) , 18-30
Open AccessAnálisis de las pérdidas de carga en rejas de una central hidroeléctrica
- Open Access
CFD Analysis of a Hydrostatic Pressure Machine with an Open Source Solver
The open source and freely available fluid flow solver named caffa3d was adapted to simulate the performance of a medium-scale Hydrostatic Pressure Machine (HPM) with straight radial blades, which had been previously tested in a laboratory facility. A fully detailed explanation of the code caffa3d is not intended to be included in this paper, but some of its main characteristics are mentioned for completeness. In addition, convergence and grid sensitivity analysis were performed in order to assess the adequacy of the model. Evolution of instantaneous power over a few turns of the HPM shows typical blade pass frequency for all operating discharges and another oscillatory phenomena at rotating frequency for higher discharges. The Power—Discharge and Efficiency—Discharge curves obtained from the simulations present a good correlation with the experimental curves, up to the discharge value corresponding to the maximum power of the HPM. The comparison error in power and efficiency remained below 6% for discharge lower than 97.8 L/s. For higher discharge, the flow through the HPM becomes very unsteady, with big eddy structures, underfilling of the buckets and recirculation down to the entry of the channel, significantly reducing the generated power. This behaviour was also observed during the previous experiments. In the present work, the foundations for the study of other types of turbines with caffa3d are laid.
Open AccessCFD Analysis of a Hydrostatic Pressure Machine with an Open Source Solver
The open source and freely available fluid flow solver named caffa3d was adapted to simulate the performance of a medium-scale Hydrostatic Pressure Machine (HPM) with straight radial blades, which had been previously tested in a laboratory facility. A fully detailed explanation of the code caffa3d is not intended to be included in this paper, but some of its main characteristics are mentioned for completeness. In addition, convergence and grid sensitivity analysis were performed in order to assess the adequacy of the model. Evolution of instantaneous power over a few turns of the HPM shows typical blade pass frequency for all operating discharges and another oscillatory phenomena at rotating frequency for higher discharges. The Power—Discharge and Efficiency—Discharge curves obtained from the simulations present a good correlation with the experimental curves, up to the discharge value corresponding to the maximum power of the HPM. The comparison error in power and efficiency remained below 6% for discharge lower than 97.8 L/s. For higher discharge, the flow through the HPM becomes very unsteady, with big eddy structures, underfilling of the buckets and recirculation down to the entry of the channel, significantly reducing the generated power. This behaviour was also observed during the previous experiments. In the present work, the foundations for the study of other types of turbines with caffa3d are laid.
- Open Access
Wind Resource Assessment in Building Environment: Benchmarking of Numerical Approaches and Validation with Wind Tunnel Data
In the framework of the wind energy network for distributed generation in urban environments for most South American countries, wind resource assessment studies have been carried out in activities to establish a suitable methodology to assess the wind potential in urban environments. Some methodologies are already published in research studies, and the wind tunnel is the most accurate solution to obtain insight into the wind resource when measurements are unavailable, which is the most frequent case. Nevertheless, besides its validity, one cannot disregard the high cost of producing a scaled urban model and access to a wind tunnel. In this sense, this paper compares results from a wind tunnel experiment and different numerical modeling approaches. Two commercial models (WindSim and Wasp Engineering) and one open-source CFD code (OpenFOAM) are used. The results from the modeling simulation concluded that CFD models could achieve lower deviations for the mean wind speed and turbulence intensity when compared with non-CFD models. With such results, CFD modeling is a promising tool for reliably evaluating wind potential in urban environments.
Open AccessWind Resource Assessment in Building Environment: Benchmarking of Numerical Approaches and Validation with Wind Tunnel Data
In the framework of the wind energy network for distributed generation in urban environments for most South American countries, wind resource assessment studies have been carried out in activities to establish a suitable methodology to assess the wind potential in urban environments. Some methodologies are already published in research studies, and the wind tunnel is the most accurate solution to obtain insight into the wind resource when measurements are unavailable, which is the most frequent case. Nevertheless, besides its validity, one cannot disregard the high cost of producing a scaled urban model and access to a wind tunnel. In this sense, this paper compares results from a wind tunnel experiment and different numerical modeling approaches. Two commercial models (WindSim and Wasp Engineering) and one open-source CFD code (OpenFOAM) are used. The results from the modeling simulation concluded that CFD models could achieve lower deviations for the mean wind speed and turbulence intensity when compared with non-CFD models. With such results, CFD modeling is a promising tool for reliably evaluating wind potential in urban environments.
- Open Access
- 20 July 2016
- Published by Universidade Federal de Santa Maria in Ciência e Natura
- Vol. 38, 426-434
DESCRIÇÃO ESTATÍSTICA DO CICLO DIÁRIO DO VENTO NOS PRIMEIROS 100 METROS DE ALTURA DA C.L.P. NA LOCALIDADE DE COLONIA EULACIO, URUGUAI
In this work is presented a statistical description of wind profile in the first 100 m of height of the Planetary Boundary Layer, taking account the measurements in the tower Colonia Eulacio Uruguay. This tower has high vertical resolution of wind velocity measurements, form 10.1 m to 101.8 m. Thermometer are installed in 3.4 m and 100.8 m, also the tower is equipped with wind vane and pyranometer. We present the diurnal cycle of mean wind, intensity of turbulence in dependence of height, also standard deviation of direction is described as a measure of turbulence in wind. Stability state is computed with vertical gradient of temperature. Before sunrise (unstable condition) is seen a decrease in mean velocity of top levels (81.8 m and 101.8 m) and increase in lower levels (10.1 m and 25.7 m). Higher dispersion in dT/dz can be seen during night time (stable condition), superadiabatic values -0.02 ◦C/m can be seen during daytime with slow dispersion. Intensity of turbulence decrease with height, for all stability conditions, is seen a increase in intensity of turbulence for unstable condition.
- 20 July 2016
- Published by Universidade Federal de Santa Maria in Ciência e Natura
- Vol. 38, 426-434
Open AccessDESCRIÇÃO ESTATÍSTICA DO CICLO DIÁRIO DO VENTO NOS PRIMEIROS 100 METROS DE ALTURA DA C.L.P. NA LOCALIDADE DE COLONIA EULACIO, URUGUAI
In this work is presented a statistical description of wind profile in the first 100 m of height of the Planetary Boundary Layer, taking account the measurements in the tower Colonia Eulacio Uruguay. This tower has high vertical resolution of wind velocity measurements, form 10.1 m to 101.8 m. Thermometer are installed in 3.4 m and 100.8 m, also the tower is equipped with wind vane and pyranometer. We present the diurnal cycle of mean wind, intensity of turbulence in dependence of height, also standard deviation of direction is described as a measure of turbulence in wind. Stability state is computed with vertical gradient of temperature. Before sunrise (unstable condition) is seen a decrease in mean velocity of top levels (81.8 m and 101.8 m) and increase in lower levels (10.1 m and 25.7 m). Higher dispersion in dT/dz can be seen during night time (stable condition), superadiabatic values -0.02 ◦C/m can be seen during daytime with slow dispersion. Intensity of turbulence decrease with height, for all stability conditions, is seen a increase in intensity of turbulence for unstable condition.
- 18 August 2015
- Published by Springer Nature
- p. 73-82
Numerical ABL Wind Tunnel Simulations with Direct Modeling of Roughness Elements Through Immersed Boundary Condition Method
- 18 August 2015
- Published by Springer Nature
- p. 73-82
Numerical ABL Wind Tunnel Simulations with Direct Modeling of Roughness Elements Through Immersed Boundary Condition Method
- Open Access
- 1 January 2000
- Published by Elsevier
- p. 1225-1228
Feasibility of the Use of Wind Energy Generation at Sewage Plants in Montevideo City
- 1 January 2000
- Published by Elsevier
- p. 1225-1228
Open AccessFeasibility of the Use of Wind Energy Generation at Sewage Plants in Montevideo City