Ivica Skozrit
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Ivica Skozrit has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- Zdenko Tonković
Faculty of Mechanical Engineering and Naval Architecture, University of Zagreb, Zagreb, Croatia
3 shared publications - Jurica Sorić
University of Zagreb
1 shared publication - Krešimir Jukić
Faculty of Mechanical Engineering and Naval Architecture, University of Zagreb, Ivana Lucica 5, 10000 Zagreb, Croatia
1 shared publication - Mato Perić
Department of Mechatronics, University North, Trg dr. Žarka Dolinara 1, 48000 Koprivnica, Croatia
1 shared publication - Tomislav Jarak
Faculty of Mechanical Engineering and Naval Architecture, University of Zagreb, Zagreb, Croatia
1 shared publication
Latest Publications
- Open Access
Numerical Calculation of Stress Intensity Factors for Semi-Elliptical Surface Cracks in Buried-Arc Welded Thick Plates
The present study deals with the influence of residual stresses induced by the buried-arc welding on the crack behavior in two butt-welded 20 mm thick plates. The following steps were undertaken: the thermo-mechanical simulation of the welding process, the mapping of stress results from a finite element (FE) mesh used for the welding simulation to a new FE mesh with a crack, the stress balancing, and the stress intensity factor (SIF) calculation. The FE and weight function (WF) methods were used to investigate the SIFs at the deepest point of semi-elliptical surface cracks with different geometries, orientations, and positions in relation to the weld line. In the case of cracks perpendicular to the weld line, the FE and WF results showed a good agreement for smaller cracks, while deviation between the results increases with the size of the crack. Considering the SIF solutions for the cracks of arbitrary orientation, it was observed that for some cases, the SIF value for mode III of crack opening can be of significant influence.
Open AccessNumerical Calculation of Stress Intensity Factors for Semi-Elliptical Surface Cracks in Buried-Arc Welded Thick Plates
The present study deals with the influence of residual stresses induced by the buried-arc welding on the crack behavior in two butt-welded 20 mm thick plates. The following steps were undertaken: the thermo-mechanical simulation of the welding process, the mapping of stress results from a finite element (FE) mesh used for the welding simulation to a new FE mesh with a crack, the stress balancing, and the stress intensity factor (SIF) calculation. The FE and weight function (WF) methods were used to investigate the SIFs at the deepest point of semi-elliptical surface cracks with different geometries, orientations, and positions in relation to the weld line. In the case of cracks perpendicular to the weld line, the FE and WF results showed a good agreement for smaller cracks, while deviation between the results increases with the size of the crack. Considering the SIF solutions for the cracks of arbitrary orientation, it was observed that for some cases, the SIF value for mode III of crack opening can be of significant influence.
- 13 February 2009
- Published by Springer Nature
- p. 455-464
Fracture Analysis of Medium Density Polyethylene
- 13 February 2009
- Published by Springer Nature
- p. 455-464
Fracture Analysis of Medium Density Polyethylene
- 4 January 2008
- Published by Springer Nature
- p. 625-626
Numerical Analysis of Surface Cracks in Steam Generator Tubes
- 4 January 2008
- Published by Springer Nature
- p. 625-626
Numerical Analysis of Surface Cracks in Steam Generator Tubes