Bong-Soo Jin
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Bong-Soo Jin has a total of 27 co-authors. Here are the top co-authors by number of shared publications:
Hyun-Soo Kim
7 shared publications- Young Moo Lee
Department of Energy Engineering, College of Engineering, Hanyang University, Seoul 04763, Republic of Korea
3 shared publications - Chil-Hoon Doh
Korea Electro-Technology Research Institute (KERI)
2 shared publications Dong-Hun Kim
2 shared publications- Seong-In Moon2 shared publications
- Chang-Woo Lee
Department of Molecular Cell Biology, Samsung Medical Center, Sungkyunkwan University School of Medicine, Suwon, Republic of Korea
1 shared publication
Latest Publications
- 15 May 2018
- Published by Wiley in Physica Status Solidi (a)
- Vol. 215 (20)
Improvement of the Electrochemical Properties of Li3V2(PO4)3/C Cathode Material for Lithium‐Ion Batteries
The Li3V2(PO4)3 (LVP) cathode material is prepared via a sol‐gel method wherein 2.5–15.0 wt.% carbon black dispersed in distilled water is added during the sol preparation process to produce a cathode exhibiting improved electrochemical properties. Analysis by X‐ray diffraction shows that the prepared material exhibits a monoclinic LVP phase containing no impurities. In addition, the synthesized Li3V2(PO4)3 powder exhibits an irregular particle shape (average particle size 1–2 µm), with carbon black particles measuring tens of nanometers distributed on the surfaces of LVP particles. Coin half cells are then fabricated using this cathode material, and its electrochemical properties are evaluated in the voltage ranges of 3.0–4.8 and 3.0–4.3 V based on the carbon black content. More specifically, as the carbon black content is increased, the initial discharge capacity and rate performance improve, and the capacity retention increases between 3.0 and 4.8 V at 25 °C. Following charge/discharge cycling, the capacity retention of LVP/C between 3.0 and 4.3 V, but higher capacity is achieved compared to that of LVP.
- 15 May 2018
- Published by Wiley in Physica Status Solidi (a)
- Vol. 215 (20)
Improvement of the Electrochemical Properties of Li3V2(PO4)3/C Cathode Material for Lithium‐Ion Batteries
The Li3V2(PO4)3 (LVP) cathode material is prepared via a sol‐gel method wherein 2.5–15.0 wt.% carbon black dispersed in distilled water is added during the sol preparation process to produce a cathode exhibiting improved electrochemical properties. Analysis by X‐ray diffraction shows that the prepared material exhibits a monoclinic LVP phase containing no impurities. In addition, the synthesized Li3V2(PO4)3 powder exhibits an irregular particle shape (average particle size 1–2 µm), with carbon black particles measuring tens of nanometers distributed on the surfaces of LVP particles. Coin half cells are then fabricated using this cathode material, and its electrochemical properties are evaluated in the voltage ranges of 3.0–4.8 and 3.0–4.3 V based on the carbon black content. More specifically, as the carbon black content is increased, the initial discharge capacity and rate performance improve, and the capacity retention increases between 3.0 and 4.8 V at 25 °C. Following charge/discharge cycling, the capacity retention of LVP/C between 3.0 and 4.3 V, but higher capacity is achieved compared to that of LVP.
- 1 October 2015
- Vol. 15 (10) , 8042-7
Electrochemical Performances of Yttrium Doped Li3V(2-X)Y(X)(PO4)3/C Cathode Material for Lithium Secondary Battery.
In this study, the Li3V(2-X)Y(X)(PO4)3 compounds have been synthesized by a simple solid state method. In addition, a polyurethane was added to apply carbon coating on the surface of the Li3V(2-X)Y(X)(PO4)3 particles for enhancement of the electrical conductivity. The crystal structure and morphology of the synthesized Li3V(2-x)Y(x)(PO4)3/C (LVYP/C) was investigated using an X-ray diffraction (XRD) and a scanning electron microscopy (SEM) systematically. The electrochemical performance of synthesized material, such as the initial capacity, rate capability, cycling performance and EIS was evaluated. The sizes of synthesized particle ranged from 1 to 5 μm. The Li3V(2-X)Y(X)(PO4)3/C (x = 0.02) delivered the initial discharge capacity of 171.5 mAh·g(-1) at 0.1C rate. It showed a capacity retention ratio of 73.0% at 1.OC after 100th cycle. The electrochemical impedance spectroscopies (EIS) results revealed that the charge transfer resistance of the material decreases by Y doping.
- 1 October 2015
- Vol. 15 (10) , 8042-7
Electrochemical Performances of Yttrium Doped Li3V(2-X)Y(X)(PO4)3/C Cathode Material for Lithium Secondary Battery.
In this study, the Li3V(2-X)Y(X)(PO4)3 compounds have been synthesized by a simple solid state method. In addition, a polyurethane was added to apply carbon coating on the surface of the Li3V(2-X)Y(X)(PO4)3 particles for enhancement of the electrical conductivity. The crystal structure and morphology of the synthesized Li3V(2-x)Y(x)(PO4)3/C (LVYP/C) was investigated using an X-ray diffraction (XRD) and a scanning electron microscopy (SEM) systematically. The electrochemical performance of synthesized material, such as the initial capacity, rate capability, cycling performance and EIS was evaluated. The sizes of synthesized particle ranged from 1 to 5 μm. The Li3V(2-X)Y(X)(PO4)3/C (x = 0.02) delivered the initial discharge capacity of 171.5 mAh·g(-1) at 0.1C rate. It showed a capacity retention ratio of 73.0% at 1.OC after 100th cycle. The electrochemical impedance spectroscopies (EIS) results revealed that the charge transfer resistance of the material decreases by Y doping.
- 2 December 2014
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 5 (7) , 4872-4879
The effect of titanium in Li 3 V 2 (PO 4 ) 3 /graphene composites as cathode material for high capacity Li-ion batteries
We report high capacity and rate capability of titanium-added Li 3 V 2 (PO 4 ) 3 (LVP) as a cathode material for lithium ion batteries (LIBs).
- 2 December 2014
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 5 (7) , 4872-4879
The effect of titanium in Li 3 V 2 (PO 4 ) 3 /graphene composites as cathode material for high capacity Li-ion batteries
We report high capacity and rate capability of titanium-added Li 3 V 2 (PO 4 ) 3 (LVP) as a cathode material for lithium ion batteries (LIBs).
- 20 February 2014
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 2 (21) , 7873-7879
Enhanced electrochemical performance of Li3V2(PO4)3/Ag–graphene composites as cathode materials for Li-ion batteries
In this study, we have synthesized a Li3V2(PO4)3/Ag–graphene (LVP/Ag–G) composite using a facile sol–gel route. The physical and electrochemical properties of the LVP/Ag–G composite have been evaluated by X-ray diffraction (XRD), scanning electron microscopy (SEM), Raman spectroscopy and electrochemical measurements. In the potential range 3.0–4.3 V, the LVP/Ag–G electrode delivered a capacity of 135 mA h g−1 at a rate of 0.1 C, which is above the theoretical capacity (133 mA h g−1). Even at a high current rate of 10 C, it still exhibited a discharge capacity of 118 and 133 mA h g−1 in the potential ranges 3.0–4.3 and 3.0–4.8 V, respectively. Such a capacity value is significantly higher than previously reported works. The LVP/Ag–G composites exhibited an outstanding specific capacity, rate capability and cycling stability. These exceptional properties of the LVP/Ag–G composites were mainly attributed to the synergetic effect of the graphene and the silver particles.
- 20 February 2014
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 2 (21) , 7873-7879
Enhanced electrochemical performance of Li3V2(PO4)3/Ag–graphene composites as cathode materials for Li-ion batteries
In this study, we have synthesized a Li3V2(PO4)3/Ag–graphene (LVP/Ag–G) composite using a facile sol–gel route. The physical and electrochemical properties of the LVP/Ag–G composite have been evaluated by X-ray diffraction (XRD), scanning electron microscopy (SEM), Raman spectroscopy and electrochemical measurements. In the potential range 3.0–4.3 V, the LVP/Ag–G electrode delivered a capacity of 135 mA h g−1 at a rate of 0.1 C, which is above the theoretical capacity (133 mA h g−1). Even at a high current rate of 10 C, it still exhibited a discharge capacity of 118 and 133 mA h g−1 in the potential ranges 3.0–4.3 and 3.0–4.8 V, respectively. Such a capacity value is significantly higher than previously reported works. The LVP/Ag–G composites exhibited an outstanding specific capacity, rate capability and cycling stability. These exceptional properties of the LVP/Ag–G composites were mainly attributed to the synergetic effect of the graphene and the silver particles.
- 30 June 2011
- Published by The Korean Electrochemical Society in Journal of Electrochemical Science and Technology
- Vol. 2 (2) , 97-102
Optimization of Lithium in Li1+x[Mn0.720Ni0.175Co0.105]O2as a Cathode Material for Lithium Ion Battery
- 30 June 2011
- Published by The Korean Electrochemical Society in Journal of Electrochemical Science and Technology
- Vol. 2 (2) , 97-102
Optimization of Lithium in Li1+x[Mn0.720Ni0.175Co0.105]O2as a Cathode Material for Lithium Ion Battery
- Open Access
- 30 November 2008
- Published by The Korean Electrochemical Society in Journal of the Korean Electrochemical Society
- Vol. 11 (4) , 284-288
Preparation and Characterization of a Sn-Anode Fabricated by Organic-Electroplating for Rechargeable Thin-Film Batteries
- 30 November 2008
- Published by The Korean Electrochemical Society in Journal of the Korean Electrochemical Society
- Vol. 11 (4) , 284-288
Open AccessPreparation and Characterization of a Sn-Anode Fabricated by Organic-Electroplating for Rechargeable Thin-Film Batteries
- 28 February 2008
- Published by The Korean Electrochemical Society in Journal of the Korean Electrochemical Society
- Vol. 11 (1) , 47-50
High Coulombic Efficiency Negative Electrode(SiO-Graphite) for Lithium Ion Secondary Battery
- 28 February 2008
- Published by The Korean Electrochemical Society in Journal of the Korean Electrochemical Society
- Vol. 11 (1) , 47-50
High Coulombic Efficiency Negative Electrode(SiO-Graphite) for Lithium Ion Secondary Battery