SKSoon-Jai Khang

Soon-Jai Khang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Soon-Jai Khang has a total of 13 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    The Deployment of Carbon Monoxide Wireless Sensor Network (CO-WSN) for Ambient Air Monitoring

    by Chaichana Chaiwatpongsakorn, Mingming Lu, Tim C. Keener, Soon-Jai Khang

    Wireless sensor networks are becoming increasingly important as an alternative solution for environment monitoring because they can reduce cost and complexity. Also, they can improve reliability and data availability in places where traditional monitoring methods are difficult to site. In this study, a carbon monoxide wireless sensor network (CO-WSN) was developed to measure carbon monoxide concentrations at a major traffic intersection near the University of Cincinnati main campus. The system has been deployed over two weeks during Fall 2010, and Summer 2011–2012, traffic data was also recorded by using a manual traffic counter and a video camcorder to characterize vehicles at the intersection 24 h, particularly, during the morning and evening peak hour periods. According to the field test results, the 1 hr-average CO concentrations were found to range from 0.1–1.0 ppm which is lower than the National Ambient Air Quality Standards (NAAQS) 35 ppm on a one-hour averaging period. During rush hour periods, the traffic volume at the intersection varied from 2,067 to 3,076 vehicles per hour with 97% being passenger vehicles. Furthermore, the traffic volume based on a 1-h average showed good correlation (R2 = 0.87) with the 1-h average CO-WSN concentrations for morning and evening peak time periods whereas CO-WSN results provided a moderate correlation (R2 = 0.42) with 24 hours traffic volume due to fluctuated changes of meteorological conditions. It is concluded that the performance and the reliability of wireless ambient air monitoring networks can be used as an alternative method for real time air monitoring.


  • Open Access

    Control of Diesel Gaseous and Particulate Emissions with a Tube-Type Wet Electrostatic Precipitator

    by Phirun Saiyasitpanich, Tim C. Keener, Mingming Lu, Fuyan Liang, Soon-Jai Khang

    In this study, experiments were performed with a bench-scale tube-type wet electrostatic precipitator (wESPs) to investigate its effectiveness for the removal of mass- and number-based diesel particulate matter (DPM), hydrocarbons (HCs), carbon monoxide (CO), and oxides of nitrogen (NOx) from diesel exhaust emissions. The concentration of ozone (O3) present in the exhaust that underwent a nonthermal plasma treatment process inside the wESP was also measured. A nonroad diesel generator operating at varying load conditions was used as a stationary diesel emission source. The DPM mass analysis was conducted by means of isokinetic sampling and the DPM mass concentration was determined by a gravimetric method. An electrical low-pressure impactor (ELPI) was used to quantify the DPM number concentration. The HC compounds, n-alkanes, and polycyclic aromatic hydrocarbons (PAHs) were collected on a moisture-free quartz filter together with a PUF/XAD/PUF cartridge and extracted in dichloromethane with sonication. Gas chromatography (GC)/mass spectroscopy (MS) was used to determine HC concentrations in the extracted solution. A calibrated gas combustion analyzer (Testo 350) and an O3 analyzer were used for quantifying the inlet and outlet concentrations of CO and NOx (nitric oxide [NO] + nitrogen dioxide [NO2]), and O3 in the diesel exhaust stream. The wESP was capable of removing approximately 67–86% of mass- and number-based DPM at a 100% exhaust volumetric flow rate generated from 0- to 75-kW engine loads. At 75-kW engine load, increasing gas residence time from approximately 0.1 to 0.4 sec led to a significant increase of DPM removal efficiency from approximately 67 to more than 90%. The removal of n-alkanes, 16 PAHs, and CO in the wESP ranged from 31 to 57% and 5 to 38%, respectively. The use of the wESP did not significantly affect NOx concentration in diesel exhaust. The O3 concentration in diesel exhaust was measured to be less than 1 ppm. The main mechanisms responsible for the removal of these pollutants from diesel exhaust are discussed.

  • Open Access

    The Effectiveness of Aeration Recirculation in Controlling VOC Emissions from Publicly Owned Treatment Works

    by Hongwei Zhu, Tim C. Keener, Tim L. Orton, Paul L. Bishop, Soon Jai Khang, Kaniz Siddiqui

    The effects of aeration recirculation on oxygen transfer and the fate of five volatile organic compounds (VOCs) commonly found in publicly owned treatment works (POTWs) influent are studied using various modeling approaches. The five compounds are benzene, chloroform, methylene chloride, toluene, and trichloroethylene. The models predict that the overall oxygen transfer efficiency can be increased by 96.7% at 50% aeration recirculation with only a 9.6% drop in oxygen transfer rate. The emission reductions and biodegradation improvements are compound specific; for the compounds investigated here, about 40% emission reductions and 16% biodegradation increases can be achieved at 50% aeration recirculation. The temperature effect on the VOC fate mechanisms is also investigated. Overall, the model predictions reveal that up to 50% aeration recirculation is effective in controlling VOC emissions.


  • A novel coal feeder for production of low sulfur fuel

    by Soon-Jai Khang, T.C. Keener

    The first task of the project is to evaluate and model the pyrolysis section of the proposed coal feeder. Literature review on coal pyrolysis have been conducted and a mathematical/computer modeling of this work has begun. Both isothermal and non-isothermal conditions are considered for this model. A pseudo-component approach was adopted for coal pyrolysis kinetics. Initially, the literature values of pyrolysis kinetic are planned to be utilized. Later, actual kinetics will be measured from a feeder-pyrolyzer. A separate feeder-pyrolyzer is under construction for this purpose.