Sijia Zhong
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Sijia Zhong has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Jianfeng Shi
Institute of Advanced Equipment, College of Energy Engineering, Zhejiang University, Hangzhou 310027, China
2 shared publications - Dongsheng Hou
Institute of Process Equipment, College of Energy Engineering, Zhejiang University, Hangzhou, Zhejiang 310027, China
1 shared publication Guangzhong Li
1 shared publicationJinyang Zheng
1 shared publication- Jinyang Zheng
Institute of Advanced Equipment, Zhejiang University, Hangzhou, China
1 shared publication - Weican Guo
Zhejiang Academy of Special Equipment Science, Key Laboratory of Special Equipment Safety Testing Technology of Zhejiang Province , Zhejiang, Hangzhou 310020, China
1 shared publication
Latest Publications
- 1 December 2015
- Published by Elsevier in Composite Structures
- Vol. 133, 756-763
Effect of viscoelasticity on the hold pressure of plastic pipe reinforced by cross helically wound steel wires in leak test
- 1 December 2015
- Published by Elsevier in Composite Structures
- Vol. 133, 756-763
Effect of viscoelasticity on the hold pressure of plastic pipe reinforced by cross helically wound steel wires in leak test
- 15 October 2014
- Published by ASME International in Journal of Pressure Vessel Technology
- Vol. 137 (2) , 021401
Study on the Allowable Temperature for Preventing Over Welding During Thermal Welding of Polyethylene Pipe
Polyethylene (PE) pipe material may degrade into lower carbon number volatiles quickly during thermal welding when the welding temperature rises up to very high temperature. However, PE may also degrade into lower molecular weight (MW) polymer when subjected to a lower temperature. As a result, determination of the allowable temperature during thermal welding is crucial for guaranteeing the quality of welding joint. In this paper, a typical commercial PE100 material was chosen to conduct thermogravimetic analysis (TGA) and gel permeation chromatography (GPC) tests. The thermal degradation behavior of PE100 was investigated in dynamic and isothermal mode. The composition of the residue after thermal degradation was also analyzed through MW and MW distribution (MWD) measurements. Based on the experimental results, the initial temperature of thermal degradation with volatilization was derived and the thermal degradation process was studied in detail. To limit the degree of thermal degradation within a certain range during thermal welding of PE pipe, the allowable welding temperature for typical commercial PE100 material was determined.
- 15 October 2014
- Published by ASME International in Journal of Pressure Vessel Technology
- Vol. 137 (2) , 021401
Study on the Allowable Temperature for Preventing Over Welding During Thermal Welding of Polyethylene Pipe
Polyethylene (PE) pipe material may degrade into lower carbon number volatiles quickly during thermal welding when the welding temperature rises up to very high temperature. However, PE may also degrade into lower molecular weight (MW) polymer when subjected to a lower temperature. As a result, determination of the allowable temperature during thermal welding is crucial for guaranteeing the quality of welding joint. In this paper, a typical commercial PE100 material was chosen to conduct thermogravimetic analysis (TGA) and gel permeation chromatography (GPC) tests. The thermal degradation behavior of PE100 was investigated in dynamic and isothermal mode. The composition of the residue after thermal degradation was also analyzed through MW and MW distribution (MWD) measurements. Based on the experimental results, the initial temperature of thermal degradation with volatilization was derived and the thermal degradation process was studied in detail. To limit the degree of thermal degradation within a certain range during thermal welding of PE pipe, the allowable welding temperature for typical commercial PE100 material was determined.